焊缝超声检测报告VIP

焊缝超声检测报告Ultrasonic Examination Report for Welds产品编号 (Product No.)工件Part部件名称Part Name板厚Thicknessmm部件编号Part No材料牌号Material表面状态Surface Condition焊接方法Welding Method检测区域Examination Areas坡口形式Groove Type器材及参数Instrument AndParameters仪器型号Instrument Type检测方法Examination Method探头型号Probe Type检测灵敏度Examination SensitivitydB试块型号Block Type扫查方式Scanning Method偶合剂Couplant 9水 9机油 Water Mechanical Oil表面补偿Surface CompensationdB扫描调节Scanning Adjustment检测面Examination Surface技术要求TechnicalRequirements检测比例Examination Proportion合格级别Acceptance Grade级检测标准Examination Standard检测工艺编号Examination Procedure No.评定结果Results焊 缝编 号WeldNo.焊 缝长 度LengthOfWelds(mm)检测结果 Examination Results返修情况 Repair(s)备 注Remarks最终检测长度FinalExamination Lengths(mm)扩检长度ExtendedExaminationLengths(mm)最终级别（级）FinalGrade一次返修1st Repair(s)二次返修2nd Repair(s)超次返修More Repair(s)部位数PositionsNo.长度Lengths(mm)部位数PositionsNo.长度Lengths(mm)部位数PositionsNo.长度Lengths(mm)缺陷及返修情况说明Defects and Repairs Instruction检测结果Examination Results1. 本台产品返修部位共计处,最高返修次数次. There is (are) total repairs on the product. Max. Repair Times is . 2. 超标缺陷部位返修后经复验合格The repair(s) has (have) been re-examined and can be acceptable.3. 返修部位原缺陷情况见焊缝超声检测评定表.Please refer to the Ultrasonic Examination Evaluation Sheet for more details about initial defect.1. 本台产品焊缝质量符合级的要求,结果合格.Welds quality of the product meets the requirements of Grade . It can be acceptable.2. 检测部位详见超声检测位置示意图（另附），各部位检测情况 详见超声检测评定表Please refer to map of Ultrasonic Examination (attached) and The Ultrasonic Examination Evaluation Sheet for examination locations and more details.报告人(资格):Prepared (Qualification): 年