WOHA33_3509244_202_AT-523200-250-801

Hong Kong Airlines Limited香港航空有限公司03110-01Hong Kong Airlines MEDHong Kong Airlines LimitedWO NO/工作指令号SEQ NO/序列号WOHA333509_202_244培训方式3509244通用类/GenericTitleSPECIAL DETAILED INSPECTION(HFEC) OF ACTUATOR ATTACH FITTING OF AFT CARGO COMPARTMENT DOOR AT FR 62AMcd&Rev/厂家工卡&修订日期标题特别详细检查(HFEC)FR62A后货舱门的作动筒连接接头AMM 52-32-00-250-801 2018-01-01A/C/飞机号Subtask No/工卡号JC Rev/工卡版本号Workarea/工作区域Skill/工种Man Hour/工时BLNZAT-523200-250-801HR001019机身/AirframeAIRP/NDT01:30/00:30MP Item/MP号Baseline/依据MP REV/ MP版本号Station/维修站Threshold/首检Interval/重复检HA33-523205-01-1MPD 523205-01-1,MRB 523205-01-1Issue 2 Revision 6PVG6000 CY6000 CYAccess Panels/接近盖板Zones/区域Written/编写Approved/批准8228222018-01-262018-02-01TOOLS/工具TOOLS NECESSARY/必须工具ITEM项目P/N件号DESCRIPTION名称EQTP类型QTY数量APP适用性Conditions note互换信息及备注12-835-07-6902PROBETO1ALL(必需/Necessary)22-835-74-6901PROBETO1ALL(必需/Necessary)32-164-551参考试块TO1ALL(必需/Necessary)48500德国尼克斯涂镀层测厚仪-包含探头TO1ALL(必需/Necessary)52-835-01-9902连接线TO1ALL(必需/Necessary)6H2-835涡流仪TO1ALL(必需/Necessary)TOOLS IF NECESSARY/视情工具ITEM项目P/N件号DESCRIPTION名称EQTP类型QTY数量APP适用性Conditions note互换信息及备注198A52307628000LOCK - SAFETY, CARGO DOOR ACTUATORSTO1ALL(视情/As Necessary)298F52308227002SUPPORT STRUT - CARGO DOORTO2ALL(视情/As Necessary)或98F52308279000398D29003501003FILL UNIT - AIRTO1ALL(视情/As Necessary)PARTS AND MATERIAL/航材NOTE:OPERATOR MUST GET AND INSTALL THE PARTS THAT CORRESPOND TO THE RELATIVE WORKORDER NO.注释：请工作者严格按照工作指令号领取预定的航材装机PARTS AND MATERIAL NECESSARY/必须航材ITEM项目P/N件号DESCRIPTION名称EQTP类型QTY数量APP适用性Conditions note互换信息及备注PARTS AND MATERIALIF NECESSARY/视情航材ITEM项目P/N件号DESCRIPTION名称EQTP类型QTY数量APP适用性Conditions note互换信息及备注1MS24665-357PINAS2ALL(视情/As Necessary)2HYJET Vhydraulic oilCH1ALL(视情/As Necessary)IMPORTANT NOTE:In the event of any discrepancies between the Chinese instruction and the English instruction, the English procedure should prevail.Record Additional Work/Findings(If Applicable) Reference No. Certificate of Release to Service (* Tick as appropriate # Different crews should perform the work on each of the systems)Certifies that the work specified, except as otherwise specified, was carried out in accordance with HKAR-145and in respect to that work, The aircraft / aircraft components are considered ready for Release to Service. HKA Approval No: AI / 135 / 706 * HKE Approval No: AI /218/1215, JMM 133 * HNAT Approval No.: D.101115, JMM 047* CASL Approval No: AI / 101 / 798 * AMECO Approval No.: D.101131, JMM 001* HNAT- North West Approval No.: D.500023, JMM 049 * HAECO Approval No: DAI / 1 / 853 * SMECO Approval No.: D.400009, JMM 081* HNAT- YN Approval No.: D.4108, JMM 134 * TAECO Approval No.: DAI / 89 / 1295 * CEA Approval No.: D.200002, JMM 112 * HNAT Approval No.: D.3039, JMM 076 * THAECO Approval No.: D.101661, JMM 124 * CEA-Jiangsu Approval No.: D.200047, JMM 117 * SPRING Approval No.: D.200081, JMM 121 * SIAEC Approval No: AWI / 01 * STARCO Approval No.: D.200078,JMM 039* GAMECO Approval No.: D.300001, JMM 006* THAI Approval No.: AI / 147 / 0910 * Other: *Signature:_ Authorization No.:_ Date:_AT-523200-250-801 HR001019 W/O:3509 AC:BLNZ页码，2 / 7工卡Job card:HA33-523205-01-1TITLESPECIAL DETAILED INSPECTION(HFEC) OF ACTUATOR ATTACH FITTING OF AFT CARGO COMPARTMENT DOOR AT FR 62APerfInsp标题特别详细检查(HFEC)FR62A后货舱门的作动筒连接接头工作者检查者Special Detailed Inspection(HFEC) of the Actuator Attachment Fitting of AFT Cargo Compartment Door at FR62A特别详细检查(HFEC)FR62A后货舱门的作动筒连接接头CAUTION: IMMEDIATELY AFTER YOU OPEN THE CARGO COMPARTMENT DOOR, RECORD ON THE DOOR THE DATE AND TIME WHEN YOU OPENED IT. IF THE CARGO COMPARTMENT DOOR STAYS OPEN FOR 12 HOURS OR MORE, YOU MUST BLEED THE HYDRAULIC SYSTEM RELATED TO IT. IF YOU DO NOT OBEY THESE PRECAUTIONS, THE DOOR CAN CLOSE SUDDENLY WHEN YOU SET THE DOOR TO CLOSE. THIS CAN CAUSE DAMAGE TO THE DOOR AND TO THE AIRCRAFT STRUCTURE.注 意：在打开货舱门之后，立刻在门上记录开门日期和时间。若货舱门保持打开状态12小时或更久，必须给舱门相关液压系统增压。若不遵守这些注意事项，当设置门到关闭位时，舱门会突然关闭。这会造成舱门和飞机结构损伤。1. Job Set-up /工作准备A. Get Access / 接近 M (1) Put an ACCESS PLATFORM 5M (16 FT)- ADJUSTABLE in position at the AFT cargo compartment door (referred to as AFT cargo door). 将可调接近平台5M (16 FT)放在AFT货舱门（称为后货舱门）位置。(2) Open the AFT cargo door (Ref. AMM TASK 52-30-00-010-801) . 打开后货舱门（参考AMM TASK 52-30-00-010-801）。(3) Remove the access cover of the circuit breaker panel 5002VE. 移走跳开关面板5002VE接近口盖。B. Install the safety support equipment on the AFT cargo door M (Ref. AMM TASK 52-30-00-480-801). 安装后货舱门安全支撑装置（参考AMM TASK 52-30-00-480-801）。C. Aircraft Maintenance Configuration M 飞机维护构型(1) Energize the ground service network. (Ref.AMMTASK24-42-00-861-801) .接通地面勤务电源(参考AMMTASK24-42-00-861-801)。(2) Set the light switch 30LU at the AFT service panel 5024VE to ON. 设置后勤务面板5024VE上灯开关30LU到ON位。(3) Remove the protection lining from the AFT cargo door (Ref. AMM TASK 52-31-15-000-801) . 按需从后货舱门上拆下保护衬板（参考AMM TASK 52-31-15-000-801）。D. Open, safety and tag this(these) circuit breaker(s): M 拔出以下跳开关并装上安全夹，挂上警告牌：PANELDESIGNATIONFINLOCATION* ON A/C CRK 301-350 /适用于CRK有效号为301-350的飞机* ON A/C HKC ALL/适用于HKC手册所有飞机5002VECARGO DOOR CTL1MJA08* ON A/C CHH 001-005, 007-050 /适用于CHH有效号为001-005, 007-050的飞机* ON A/C CRK 001-012, 401-500 /适用于CRK有效号为001-012, 401-500的飞机5002VECARGO DOOR CTL1MJC03* ON A/C CHH 006-006, 051-350/适用于CHH有效号为006-006, 051-350的飞机* ON A/C CRK 013-300，351-400/适用于CRK有效号为013-300，351-400的飞机5002VECARGO DOOR CTL1MJA02* ON A/C ALL /适用于所有的飞机2. Procedure /程序(Ref. Fig. Inspection of the Actuator Attachment Fitting SHEET 1)(参考图Inspection of the Actuator Attachment Fitting SHEET 1) A. Special Detailed Inspection (HFEC) of Actuator Attach Fitting of AFT Cargo Compartment Door at FR62A 特别详细检查(HFEC)FR62A后货舱门的作动筒连接接头 (1) Do a NDT inspection at the actuator attach fitting NTM 523205. T DIC参考NTM 523205对作动筒连接组件执行NDT检查。Note : Please attach the NDT inspection report after this jobcard.注释：NDT检查报告附在工卡后。3. Close-up /结束A. Put the aircraft back to its operational configuration 将飞机还原到初始构型(1) Install the protection lining (Ref. AMM TASK 52-31-15-400-801) . M 安装保护衬板（参考AMM TASK 52-31-15-400-801）。(2) Close the access cover of the circuit breaker panel 5002VE. M 关闭跳开关面板5002VE接近口盖。(3) Make sure that the work area is clean and clear of tools and other items. M 确认工作区域干净且无其它物品遗留。(4) Set the light switch 30LU at the AFT service panel 5024VE to OFF. M 设置后勤务面板5024VE上灯开关30LU到OFF位。(5) De-energize the ground service network(Ref.AMMTASK24-42-00-862-801) . M 断开地面勤务电源(参考AMMTASK24-42-00-862-801)。B. Remove the safety support equipment from the AFT cargo door M (Ref. AMM TASK 52-30-00-080-801). 移走后货舱门安全支撑装置（参考AMM TASK 52-30-00-080-801）。C. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): M 取下安全夹和警告牌并闭合以下跳开关：PANELDESIGNATIONFINLOCATION* ON A/C CRK 301-350 /适用于CRK有效号为301-350的飞机* ON A/C HKC ALL/适用于HKC手册的所有飞机5002VECARGO DOOR CTL1MJA08* ON A/C CHH 001-005, 007-050 /适用于CHH有效号为001-005, 007-050的飞机* ON A/C CRK 001-012, 401-500 /适用于CRK有效号为001-012, 401-500的飞机5002VECARGO DOOR CTL1MJC03* ON A/C CHH 006-006, 051-350/适用于CHH有效号为