Yb-Ho-LiNbO3单晶论文:Yb-Ho-LiNbO-3单晶的生长及上转换发光性能研究.doc_第1页
Yb-Ho-LiNbO3单晶论文:Yb-Ho-LiNbO-3单晶的生长及上转换发光性能研究.doc_第2页
Yb-Ho-LiNbO3单晶论文:Yb-Ho-LiNbO-3单晶的生长及上转换发光性能研究.doc_第3页
Yb-Ho-LiNbO3单晶论文:Yb-Ho-LiNbO-3单晶的生长及上转换发光性能研究.doc_第4页
Yb-Ho-LiNbO3单晶论文:Yb-Ho-LiNbO-3单晶的生长及上转换发光性能研究.doc_第5页
免费预览已结束,剩余1页可下载查看

下载本文档

版权说明:本文档由用户提供并上传,收益归属内容提供方,若内容存在侵权,请进行举报或认领

文档简介

Yb:Ho:LiNbO3单晶论文:Yb:Ho:LiNbO_3单晶的生长及上转换发光性能研究【中文摘要】采用提拉法生长出了一系列不同Yb3+ (0.5,1.5,2.0,2.5,3.0 mol%)摩尔掺杂浓度的Yb: Ho: LiNbO3单晶,其中Ho3+掺杂浓度固定为0.1 mol%。生长的晶体无宏观缺陷,有较好的光学均匀性。在晶体生长过程中,探索了其最佳生长工艺参数,其中,轴向温梯35-40/cm,径向温梯要对称、均匀,提拉速度为0.5-2.5mm/h,旋转速度为22-26r/min,保证了生长界面的平坦,降低了晶体组分不均匀性。X射线衍射结果显示,Yb: Ho: LiNbO3晶体仍然保持基质LiNbO3晶体本身的晶格结构,峰值的差异表明掺杂晶体的晶格常数和晶胞体积发生了变化,而且从实验结果可以看出,掺杂离子的进入使得晶胞的体积和未掺杂相比有所减少;晶体的紫外吸收光谱表明,稀土离子掺杂之后晶体的吸收强度明显增大,又进一步解释了掺杂离子在基质材料LiNbO3中的占位规律,Yb3+和Ho3+优先取代的是反位Nb的位置,紫外吸收边先发生红移然后紫移;此外,结合生长晶体的红外光谱的测试,观察Yb:Ho:LiNbO3晶体样品在32003800cm?1范围的红外吸收光谱可以看到,随着Yb3+掺杂浓度的增加,位于3481cm?1的OH?吸收峰的吸收强度降低,OH?吸收的降低有助于晶体的声子能量的降低,从而可见光的发光效率相应提高。泵浦光源为980 nm激光器激发下,在样品中分别观察到了Yb: Ho: LiNbO3晶体红绿上转换发光光谱,在此基础上得到了上转换功率曲线,用以分析Yb: Ho: LiNbO3晶体上转换发光机制。功率曲线的结果表明,绿光以及红光产生都主要是基于双光子过程,还有部分单光子过程参与。此外,由光谱可以看出,随着Yb3+浓度从0.5 mol%增加到2.0 mol%,会有Yb3+参与敏化作用,使得红绿上转换发光的强度都得到增强。而当Yb3+浓度继续增加,由于Yb3+的之间的合作敏化作用使得发光强度反而减弱。【英文摘要】A series of Yb: Ho: LiNbO3 single crystals with different Yb3+ (0.5, 1.5, 2.0, 2.5, 3.0 mol%) doping concentrations and a constant Ho3+ (0.1mo%) concentration were grown by the Czochralski method. The crystals had no macroscopic defect and exhibit good optical properties. In the process of crystal growth, temperature gradient is 35-40/cm, pulling speed is 0.5-2.5mm/h and rotating speed is 22-26r/min. These optimum parameters were selected to maintain the flat growth interface, and the heterogeneity component is decreased.The results of X-ray diffraction indicated that there is no additional peaks appeared in Yb: Ho: LiNbO3 single crystals. All these crystals are a single phase of LiNbO3 with trigonal structure. Comparing with the standard card of lithium niobate, the diffeencees between doped crystals and standed LiNbO3 crystal showed that the lattice and cell volumes was changed slightly as a result of the different ionic radius between doped and replaced ions. The cell volumes of doped LiNbO3 were decreased, which might be attributed to the exsisted impurities of LiNbO3 crystals resulting from the doping ions of Yb3+ or Ho3+. UV-visible absorption spectras show that the absorption of these doped crystals, compared with pure LiNbO3 crystal, intensity increases. So that the occupying mechanism of the dopants was found. Ho3+ and Yb3+ prefers to occupy the sites of NbLi4+. The UV absorption edge shift to red and then to blue. Besides, combined with the IR absorption spectra, The IR absorption spectras of the Yb:Ho:LiNbO3 in the wave number range of 32003800 cm?1 show that as the concentration of Yb3+ increases, the OH? absorption decreases. The reduction intensity of OH- absorption peaks indicates that the decrease of the phonon energy and hence results in the increase of the luminous efficiency increased.Under 980 nm excitation, green and red emission bands are observed in these samples, respectively. The up-conversion spectroscopies of Yb: Ho: LiNbO3 crystals were tested to obtain the power-upconversion curves which were used to analyze the up-conversion mechanism. According to the experimental results, Power dependence results indicate a dominnent two-photon population process of the emitting levels. In addition, the intensity of the red and green upconversion fluorescence emissions increase with Yb3+ concentrations of 0-2.0 mol% due to an increased Yb3+ sensitization, but decrease attribute to cooperative sensitization between two Yb3+.【关键词】Yb:Ho:LiNbO3单晶 掺杂离子 上转换发光 上转换机制【英文关键词】Yb:Ho:LiNbO3 crystal doped ions up-conversion up-conversion mechanism【目录】Yb:Ho:LiNbO_3单晶的生长及上转换发光性能研究摘要4-5ABSTRACT5第1章 绪论9-211.1 上转换发光的研究进展9-151.1.1 上转换发光91.1.2 上转换发光机理9-131.1.3 上转换发光基质材料的研究13-141.1.4 上转换发光技术的应用14-151.2 铌酸锂晶体的研究15-181.2.1 铌酸锂晶体的晶格结构15-161.2.2 铌酸锂晶体的缺陷16-171.2.3 铌酸锂晶体的主要性质17-181.3 国内外研究现状18-191.4 本课题研究的目的及意义19-201.5 课题研究主要内容20-21第2章 实验材料及研究方法21-252.1 实验药品与仪器21-222.1.1 主要化学试剂212.1.2 实验仪器21-222.2 晶体生长方法222.3 样品性能测试22-242.3.1 XRD 测试22-232.3.2 紫外-可见吸收光谱测试232.3.3 红外光谱测试232.3.4 上转换光谱及功率曲线测试23-242.4 掺杂铌酸锂单晶生长及研究过程24-25第3章 掺杂铌酸锂晶体的生长及加工25-353.1 晶体生长设备25-263.2 晶体生长的前期准备工作26-273.2.1 实验原料及配比263.2.2 原料预烧结过程26-273.3 晶体最佳生长条件的选择27-303.3.1 温场的确定283.3.2 晶体提拉速度的确定28-293.3.3 晶体旋转速度的确定29-303.4 晶体生长过程30-323.4.1 原料熔化303.4.2 引晶30-313.4.3 放肩313.4.4 收肩313.4.5 等径生长313.4.6 拉脱31-323.4.7 退火323.5 晶体的加工和后期处理过程32-333.5.1 晶体的极化32-333.5.2 晶体的加工333.6 本章小结33-35第4章 镱钬双掺铌酸锂晶体缺陷结构分析35-454.1 镱钬铌酸锂晶体XRD 测试分析35-384.1.1 X-射线衍射基本原理35-364.1.2 X-射线衍射测试结果及分析36-384.2 镱钬铌酸锂晶体紫外-可见吸收光谱38-414.2.1 紫外吸收边移动机理38-394.2.2 紫外-可见吸收光谱测试结果及分析39-414.3 镱钬铌酸锂晶体红外光谱分析41-444.3.1 OH-吸收峰移动机理研究42-434.3.2 红外光谱测试结果及分析43-444.4 本章小结44-45第5章 镱钬双掺铌酸锂晶

温馨提示

  • 1. 本站所有资源如无特殊说明,都需要本地电脑安装OFFICE2007和PDF阅读器。图纸软件为CAD,CAXA,PROE,UG,SolidWorks等.压缩文件请下载最新的WinRAR软件解压。
  • 2. 本站的文档不包含任何第三方提供的附件图纸等,如果需要附件,请联系上传者。文件的所有权益归上传用户所有。
  • 3. 本站RAR压缩包中若带图纸,网页内容里面会有图纸预览,若没有图纸预览就没有图纸。
  • 4. 未经权益所有人同意不得将文件中的内容挪作商业或盈利用途。
  • 5. 人人文库网仅提供信息存储空间,仅对用户上传内容的表现方式做保护处理,对用户上传分享的文档内容本身不做任何修改或编辑,并不能对任何下载内容负责。
  • 6. 下载文件中如有侵权或不适当内容,请与我们联系,我们立即纠正。
  • 7. 本站不保证下载资源的准确性、安全性和完整性, 同时也不承担用户因使用这些下载资源对自己和他人造成任何形式的伤害或损失。

评论

0/150

提交评论