50T吊车性能表.doc

50T吊车性能表50T 主要性能与参数项 目 数 值最大额定总起重量 50000 kg基本臂最大起重力矩 1800 kN.m 最长主臂最大起重力矩 868 kN.m主臂最大起升高度 40.2 m 副臂最大起升高度 56.5 m 外形尺寸(长宽高) 1360027503550 mm主臂长 10.840.2 m 副臂长 15 m 50T起重特性表 PATED LIFTING CAPACITY TABLE 单位（UNIT）：Kg工 作幅 度WORKINGRADIUS（m）主 臂 BOOM主臂仰角BOOM ANGLE（）主臂+副臂 BOOM+JIB支腿全伸、后方、侧方作业REAR&SIDE WORKING AREA WITH OUTRIGGER FULLY EXTENDED40.2+9m40.2+15m臂 长 BOOM LENGTH副臂安装角JIB OFF SET副臂安装角JIB OFF SET10.8m18.15m25.5m32.85m40.2m3.060000310000300303.550500310008040002150240010004.04350030000210007838002050218010004.54000028000200007635001950192010005.0360002700019200138007431501900182010005.5310002460019000138007228501850169010006.0256002320018200138007027001800153010006.522000210001750013600682550175013809007.0200001800017100136008500662450165012308008.0153001400015500126008500642150140010807009.0121001100013000116008200621850115095060010.0900010800106007800601550100083011.0750088009200740058135085070012.0650072008200700056110070060013.053006000700066005495055014.046005200620062005275015.037004300520053005016.0300040004800500018.030003800400020.021003000320022.016002300260024.01800210026.01400160028.01200说明（NOTE）：l 表中的额定总起重量是起重机设置在坚固地面呈水平状态下的允许起吊重量，不允许在不打支腿的情况下吊重。（Lifting capacities shown in the table are based the condition that the trane es set on firm ground horizontaily,lifting on wheels is prohibited.）l 表中所列数值为包括吊具在内的最大允许值（50吨主钩重505千克，副吊钩重量120千克）。(Capacities listed in the table are max.permissible values including the slings(505kg main hookblock for 50t and 120kg auxiliary hoodblock).)l 表中红线上方的额定总起重量有起重机的结构强度所决定，其他由起重机整机稳定性而确定。(Rated lifting capacities above the red line in the table are based on structure strength of the crane,the others,on stability.)l 使用臂端滑轮时，最大起重量不得超过单根钢丝绳允许起吊载荷4.2吨。(When the single top sheave is used,max.lifting capacity must not exceed a pernissble load of 4.2t per single line.)l 打好第五支腿时，表中数值使用于圆周360作业。(With the fifth outrigge