Juniper路由器配置OSPF.doc

Juniper路由器配置OSPF本文介绍了在Juniper路由器里配置OSPF动态路由协议的方法，包括：配置单区域OSPF、配置多区域OSPF、配置Stub Area、配置OSPF Virtual Link、配置OSPF Router Interfaces、配置OSPF验证等，详细的操作步骤请查看以下内容。 1、配置单区域OSPF edit userhost# set protocols ospf area 0 interface ge-0/0/0 INIT 2way Exstart Exchange FULL edit userhost# show protocols ospf ospf area 0.0.0.0 interface ge-0/0/0.0; 2、配置多区域OSPF edit userhost# show protocols ospf ospf area 0.0.0.0 interface ge-0/0/0.0; edit userhost# set protocols ospf area 1 interface at-0/1/1.100 edit userhost# show protocols ospf ospf area 0.0.0.0 interface ge-0/0/0.0; area 0.0.0.1 interface at-0/1/1.100; 3、配置Stub Area edit protocols ospf area area-id stub ; 8.3.3 配置a Not-So-Stubby Area edit protocols ospf area area-id nssa area-range network/mask-length ; default-lsa default-metric metric; metric-type type; type-7; (no-summaries | summaries); 4、配置OSPF Virtual Link 使用virtual Link 连接防止环路。 edit protocols ospf area 0.0.0.0 virtual-link neighbor-id router-id transit-area area-id; 5、配置OSPF Router Interfaces Configuring an Interface on a Broadcast or Point-to-Point Network edit protocols ospf area area-id interface interface-name; Configuring an Interface on a Point-to-Multipoint Network edit protocols ospf area 0.0.0.0 interface interface-name neighbor address; Configuring an Interface on a Nonbroadcast, Multiaccess Network edit protocols ospf area 0 interface interface-name interface-type nbma; neighbor address ; poll-interval seconds; 6、配置OSPF验证 可以使simple和MD5 edit protocols ospf area area-id authentication-type authentication; edit protocols ospf area area-id interface