环氧封闭底漆(溶剂型)的用途和使用.doc

环氧封闭底漆（溶剂型）的用途和使用Intended Uses用途环氧封闭底漆（溶剂型）适用于涂装地坪涂料前的水泥或混凝土地面处理,为后道涂料提供抗渗,易清理和良好的附着的表面,特别适用于较密实的地面作为接着层,如高强度水泥或混凝土地面,经处理的水磨石及大理石等表面,也适用于涂装溶剂型外墙涂料前用作底材封闭漆.Used to treat the surface of cement or concrete floor to be applied. When the structure is painted with it, a surface with excellent adhesion to subsequent coat, Which is also impermeable and easy to clean, should be gotten, Especially suitable for compact substrates as connecting layer, such high-strength cement or concrete floor, before painting with solvent-based coating for exterior wall.ProductDescription产品简介涂料粘度低,基材经本品处理后可增强封闭性和复合涂层对底材的附着强度.Low viscosity. When the substrate is treated with this product, the character of sealing -off and adhesion strength of composite coats to the substrate has been both reinforce.ProductInformation产品数据Volume Solids 固体份50%-75%, basing on the requirements of customer 根据客户要求Color 颜色Color , light yellow, transparent淡黄色,透明Dry Film Thickness 干膜厚度30-100 m , depending on the conditions of substrate, volume solids and the number of coats. 30-100微米,与基材状况,涂料固体份及涂装道数相关. Theoretical Coverage 理论涂布率Depend on the conditions of substrate, and in general, 5-10Kg/m2 forone coat by roller与基材状况有关，一般辊涂一道为5-10平方米/公斤Practical Coverage 实际涂布率Allow appropriate loss 允许适量损耗Application Details施工详述Mix Radio 混合比A : B=5:1(by weight) 甲:乙=5:1Method of Application 施工方法 Airless Spray 无空气喷涂 Recommended 推荐采用 Brush or Roller 涂刷或辊涂 Suitable only for small area 仅适用于小面积 Conventional Spray 传统喷涂 Not Recommended 不推荐采用Thinner 稀释剂 C003Cleaner 油漆设备清洗剂 C003Pot Life 使用期 35:4h 25:6h 15:8h Storage 贮存期 One year 一年Drying time 干燥时间SubstrateTemperature底材温度,Touch Dry表干（h）Hard Dry硬干(h）Over coating Interval覆涂间隔Mix最短Max最长25 42424 h7 d来源：江苏纽克莱涂料有限公司官网 Storage andHandling贮存与管理Storage 贮存 Store in cool and dry conditions 贮存于阴凉干燥处Pack size 包装规格 A;15Kg in 20 liter container 甲:15公斤装于20公升容器中 B:5Kg in 5 liter container 乙:5公斤装于5公升容器中Flash Point 闪点 27 Specific Gravity 比重 Approx1.05Kg/L 大约1.05公斤/公升Safety Precautions 安全措施The product must be used in painting area by professionals. When painting, please be sure to refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying the product.参考 The product is a kind of solvent-based paint. In order to avoid the accident or dangerous occurrence, minimal safety precaution, as follow, should be down.The paint contains volatile solvent and it is flammable, So must keep away from sparks and open flames. No smoking at workplace, Effective precautions (such as using explosion-proof electrical equipments. No static electricity accumulation or metal collision etc) also should be done so as to avoid product sparks. Enough ventilation is necessary at application sites. In order to remove any danger of explosion, must keep the ratio of gas / air is less than 10 %, Usually 200 m3of ventilation quantity per 1 Kg solvent (according to the solvent) is necessary, it canMaintain the minimum explosive limit. Take effective precautions to prevent skin and eye contact with the coating (such as the use of overalls, gloves, goggles, face shields and protective oil coating and so on). If paint gets in touch with skin,If accidental skin contact with the product, please use fresh water and soap or an appropriate industrial cleaning agents thoroughly cleansed. In case of eyes being contaminated, rinse with fresh water for 10 min at least and give medical treatment immediately.During painting, it is recommended to wear face shields to prevent inhalation of paint mist and harmful gases.Especially in poorly ventilated environment, it is more necessary.Finally, be handled with care so as not to waste paint barrels of pollution of the environment.NOTICE: If consumers have not taken effective safety precautions (Refer to the specification), our company will NOT be responsible for any accident. 本产品必须由专业人员在工业场所使用。使用时请务必参照本说明书以及相关健康安全手册。若客户在使用本产品前,未能详细了解本产品的相关健康安全知识,请与本公司人员联系。该涂料为溶剂型涂料，为避免事故或危险发生，应采取最低限度的安全措施如下：此涂料为易燃物,并含有挥发性易燃溶剂，故必须远离火星和明火。严禁在作业场所吸烟，并应该采取有效措施，防止火星产生(如采用防爆电器设备，杜绝静电积累,避免金属撞击等)。施工场所应尽量保持良好通风。为消除使用过程中的爆炸隐患,应保证足够的通风量以维持气体/空气比例不超过最低爆炸极限的10 %,通常每千克溶剂需要200立方米通风量,(与溶剂种类相关)就能维持最低爆炸极限10 %的工作环境。 采取有效措施，防止皮肤和眼睛与涂料直接接触(如使用工