netiq操作指南.doc

NETIQ Chariot Test指南制作人：鑫茂科技（ECSM）深圳有限公司产品验证部 尹学容1. Run Chariot_Inst.exe，按默认路径安装好。2. Copy chariot.lic to C:Program FilesNetIQChariot3. Run gsendw32.exe.4. Click Next when installing.5. Select “Dont install application monitoring support” then click Next.6. Repeat 15 step on another system.然后手动关闭Windows防火墙，并在管理工具服务中停止Windows Firewall/Internet Connection Sharing(ICS).并手动指定被测板和标准系统的IP地址。比如，被测板的IP地址为：192.168.0.11，子网掩码为：255.255.255.0，默认网关设为同一局域网网段服务器的IP地址192.168.0.1；标准系统的IP地址为：192.168.0.9，子网掩码为：255.255.255.0，默认网关也设为同一局域网网段服务器的IP地址192.168.0.1。7. Run Chariot Console from one unit(dont need to run it on two units on the same test time).8. Click New.9. Click “Add Pair”.10. Enter the source IP address （源地址，即被测板的IP地址192.168.0.11）to Endpoint 1 network address, and target IP address（目标地址，即标准系统的IP地址192.168.0.9） to Endpoint 2 network address.11. Click “Select Script”, double click “Benchmarks” folder.12. Select “High_Performance_Throughput.scr” then click Open.13. Click OK.14. Select Run/Set Run Options.15. In “How to end a test run”, select “Run for a fixed duration”, then set the test time you want it to test.16. Click Run.17. Click the “Throughput” tab.18. After testing, write down the Pair 1 Average(Mbps) into your test report.19. If you want test the IPX/SPX, change the setting in step 13. Endpoint 1 please type 00000000:Source MAC address, Endpoint 2 please type 00000000:Target MAC address, then change the network protocol to “IPX”.20. Select “Throughput.src” in Script folder.21. Please notice, the result by “Throughput.scr” script is slower than “High_Performance_Throughput.scr”, so if you want know the result is pass or fail, please compare with other platforms, but you may ask why we dont use the “High_Performance_Throughput.scr” script to test IPX/SPX, sorry, the script is only for TCP/IP test, because when we try to use that script