JAN1N757DUR中文资料

1、jan1n757dur中文资料 do-35 (do-204ah) applications / benefits regulates voltage over a broad operating current and temperature range standard voltage tolerances are plus/minus 5% with a suffix identification and 10 % with no suffix tight tolerances available in plus or minus 2% or 1% with c or d suffix r

2、espectively flexible axial-lead mounting terminals nonsensitive to esd per mil-std-750 method minimal capacitance (see figure 3) note 1: standard tolerance on jedec types shown is +/- 10%. suffix letter a denotes +/- 5% tolerance; suffix letter c denotes +/- 2%; and suffix letter d denotes +/- 1% to

3、lerance. note 2: voltage measurements to be performed 20 seconds after application of dc test current. note 3: zener impedance derived by superimposing on i zt , a 60 cps, rms ac current equal to 10% i zt (2ma ac). see micronote 202 for typical zener impedance variation with different operating curr

4、ents. note 4: allowance has been made for the increase in v z due to z z and for the increase in junction temperature as the unit approaches thermal equilibrium at the power dissipation of 400 mw. r a t e d p o w e r d i s s i p a t i o n - m w temperature coefficient mv/o c t e m p e r a t u r e c

5、o e f f i c i e n t %/c t l lead temperature (o c) 3/8” from body or nominal zener voltage (volts) t a on fr4 pc board figure 1 figure 2 power derating curve zener voltage temperature coefficient vs. zener voltage microsemi scottsdale division 8700 e. thomas rd. po box 1390, scottsdale, az 85252 usa, (480) 941-6300, fax: (480) 947-1503 page 2 copyright 2021 10-31-2021 rev b 元器件交易网 microsemi scottsdale division 8700 e. thomas rd. po box 1390, scottsdale, az 85252 usa, (480) 941-6300, fax: (480) 947-1503 page 3copyright 2021 10-31-2021 rev b