油水分离器试验程序

1、油水分离器试验程序一）试 验前应具备的条件。Test condition1 管路安装正确性和完整性。Inspection pipe systems have been installed correctly and completely.2 管路密性试验结束。Inspection pipe systems tightness test have been finished.3 确定各部分的电气配线按要求安装， 电动机、 自动排油装置、 油分浓度计 等各自的供给电源的正确性。Check that wirings for each part of the oily water separator

2、system have been completed as planned and the electric power source indicates proper values for each equipment.4 油水分离器处理水装配了自动停止装置，在 15ppm 报警装置通电后，进 行适当的操作，确认自动停止装置的动作。When an automatic stopping device for the oily water separator treated water is provided, energize the 15ppm bilge alarm and operate

3、 it properly, in order to check that the change over valve functions normally.二）安全、故障报警模拟试验。1 压力调整阀。 Pressure adjusting valve.（ 0.1 Mpa ）2 15ppm 报警。 15ppm Bilge seprator.3 自动停止外排。 Automatic discharge stop device三）运行功能试验。Running Function Test1注意油水分离器的各压力表的情况记录，注意压差Record readi ngs of the pressure gau

4、ges at various parts of the oily water separator, and check for differe nt pressure.2确认自动排油装置的当作是否正常。Check that the function of automatic oil drain system is normal.3通过该装置的排出侧的取样口的取样，目测确认处理水的状态。Take a sample from cock on the discharge side of the oily water separator, and check the properties of tre

5、ated water visually to assure no irregular phe nomena caused.系泊试验记录表( MOORING TEST RECORD )船名项目：Ship n ame:Article:项目号试验日期记录单序号：Job No: Date: Record No: 设备名称：设备编号Eqt Name: Eqt Serial No: 油水分离器试验记录内容Descriptio n单位Unit结果Result油水分离器和泵Oily Water Separator and Pump冷/热态绝缘电阻Cold/Hot In sulati on Resista neeMQ起动/工作电流Start/R unning Curre ntA油份浓度计报警Bilge Alarm油分浓度咼报警，排舷外三通阀关闭15ppm alarm and overboard stop用清水检查零位Zero Point with clea n water三通阀功能试验Three-way valve油份浓度低于15ppmOil Co ntent within 15ppmfun cti on test油份浓度咼于15ppmOil Content over 15ppm功能试验Fun