手机跌落测试标准_第1页
手机跌落测试标准_第2页
手机跌落测试标准_第3页
手机跌落测试标准_第4页
手机跌落测试标准_第5页
已阅读5页,还剩2页未读 继续免费阅读

下载本文档

版权说明:本文档由用户提供并上传,收益归属内容提供方,若内容存在侵权,请进行举报或认领

文档简介

1、1 / 7 文档可自由编辑 TestTest specificationspecification TestTest namename DROPDROP TESTTEST FORFOR UNPACKEDUNPACKED APPARATUSAPPARATUS Evaluate the shock resistance of an apparatus unpacked to resist a series of drop tests. 评估无包装的仪器的耐震强度来进行一系列下落测试 2 / 7 文档可自由编辑 1.1. STANDARDSTANDARD 标准标准 This test is acco

2、rding to the standard NFC 20 732 equivalent to the standard CEI 68-2-32 此测试根据等同于标准 cei68-2-32 的标准 nfc20732 2.2. PRINCIPLEPRINCIPLE 原理原理 The test samples suffer 14 successive drops with different angles on a pinewood board. 测试样品满足 14 次连续不同角度下落在松木板上 3.3. DIRECTIONSDIRECTIONS FORFOR USEUSE : :使用方向使用方向

3、3.13.1 TestTest surfacesurface 测试表面测试表面 Pinewood board of 5 cm thickness 5cm 厚度的松木板 3.23.2 DroppingDropping heightheight 下落高度下落高度 The height shall be measured from the part of the specimen nearest to the test surface, when the specimen is suspended prior to letting it fall. Its 1.5 m 当样品悬挂好时,下落高度应从最

4、靠近测试表面的样品的部分来测试 3 / 7 文档可自由编辑 3.33.3 MethodMethod ofof releaserelease 释放方法释放方法 The method of releasing the specimen shall be such as to allow free fall from the position of suspension, with a minimum of disturbance at the moment of release. 释放样品的方法应是伴随释放时扰动的最小值,从悬挂处自由落体 3.43.4 InitialInitial measure

5、mentsmeasurements 首次测试首次测试 The specimen shall be visually examinated and electrically and mechanically checked. 样品外观要检查,电力方面和机械方面也要检查 Points to check : Switch on and off the mobile 开关手机 All buttons/keys are functioning.所有的按钮都要检查是否 能使用 Transaction with SIM card 处理 sim 卡 Check that all the pixels are

6、functional (Use the specified function of the software for this test. Example for BE1 and BE3, type 000000* then choose the function “checker”). 检查所有像素使用供测试用的专门软间,比如 be1,be3 Check the communication 检查通讯 4 / 7 文档可自由编辑 3.53.5 NumberNumber ofof productsproducts minimumminimum 产品最小值产品最小值 3 apparatus min

7、imum must be tested.三个仪器的最小值必须被检查 3.63.6 DuringDuring thethe testtest 测试时测试时 14 consecutive drop tests on all the faces as defined in the diagram : one on each face and corner while the apparatus is working. EvenEven ifif thethe apparatusapparatus doesntdoesnt fallfall onon thethe faceface oror corn

8、ercorner desired,desired, thethe dropdrop isntisnt donedone again.again. 所有表面上的 14 个连续下落测试如图表中定义的:当仪器在运转中,每一 个表面和角落上的.即使仪器没有下落在理想的表面或角落上,下落也无须 再做 1 次 The battery, unless a contrary request, must not be fixed with an external tool. 除非有相反的要求,否则电池组无须固定在外部工具上 Between each drop, the specimen shall be vis

9、ually examinated and electrically and mechanically checked. 在每一次下落间, 样品外观要检查,电力方面和机械方面也要检查 Points to check : Switch on and off the mobile 开关手机 All buttons/keys are functioning.所有的按钮都要检查是否 能使用 5 / 7 文档可自由编辑 Transaction with SIM card 处理 sim 卡 Check that all the pixels are functional (Use the specified

10、 function of the software for this test. Example for BE1 and BE3, type 000000* then choose the function “checker”). 检查所有像素使用供测试用的专门软间,比如 be1,be3 Check the communication 检查通讯 12 4 8 1 9 11 5 13 10 2 6 14 6 / 7 文档可自由编辑 4.4. JUDGEMENTJUDGEMENT 判断判断 The specimen shall be visually examinated and electric

11、ally and mechanically checked after each drop. 在每一次下落后,样品外观要检查,电力方面和机械方面也要检查 Checking performances of equipment.检查设备的性能 -Possibility to switch on and off the mobile 开关手机 -Mobile stay switched on alone 手机保持单独打开 -All buttons/keys are functioning. 所有的按钮都要检查 是否能使用 -Transaction with SIM card possible. 处理

12、 sim 卡 -Check that all the pixels are functional (Use the specified function of the software for this test. Example for BE1 and BE3, type 000000* then choose the function “checker”). 3 7 7 / 7 文档可自由编辑 检查所有像素使用供测试用的专门软间,比如 be1,be3 - -Check that communication is possible.检查通讯 Check the aspect of the equipment after the falling:在 下落后,检查仪器的每一方面 -no injury can be caused due to damage.由

温馨提示

  • 1. 本站所有资源如无特殊说明,都需要本地电脑安装OFFICE2007和PDF阅读器。图纸软件为CAD,CAXA,PROE,UG,SolidWorks等.压缩文件请下载最新的WinRAR软件解压。
  • 2. 本站的文档不包含任何第三方提供的附件图纸等,如果需要附件,请联系上传者。文件的所有权益归上传用户所有。
  • 3. 本站RAR压缩包中若带图纸,网页内容里面会有图纸预览,若没有图纸预览就没有图纸。
  • 4. 未经权益所有人同意不得将文件中的内容挪作商业或盈利用途。
  • 5. 人人文库网仅提供信息存储空间,仅对用户上传内容的表现方式做保护处理,对用户上传分享的文档内容本身不做任何修改或编辑,并不能对任何下载内容负责。
  • 6. 下载文件中如有侵权或不适当内容,请与我们联系,我们立即纠正。
  • 7. 本站不保证下载资源的准确性、安全性和完整性, 同时也不承担用户因使用这些下载资源对自己和他人造成任何形式的伤害或损失。

评论

0/150

提交评论