交换机代码

4_SW2#sh mac-address-table Mac Address Table-Vlan Mac Address Type Ports- - - - All 0100.0ccc.cccc STATIC CPU All 0100.0ccc.cccd STATIC CPU All 0180.c200.0000 STATIC CPU All 0180.c200.0001 STATIC CPU All 0180.c200.0002 STATIC CPU All 0180.c200.0003 STATIC CPU All 0180.c200.0004 STATIC CPU All 0180.c200.0005 STATIC CPU All 0180.c200.0006 STATIC CPU All 0180.c200.0007 STATIC CPU All 0180.c200.0008 STATIC CPU All 0180.c200.0009 STATIC CPU All 0180.c200.000a STATIC CPU All 0180.c200.000b STATIC CPU All 0180.c200.000c STATIC CPU All 0180.c200.000d STATIC CPU All 0180.c200.000e STATIC CPU All 0180.c200.000f STATIC CPU All 0180.c200.0010 STATIC CPU All ffff.ffff.ffff STATIC CPU 1 0088.9900.1828 DYNAMIC Fa0/47 1 0099.8800.31f1 DYNAMIC Fa0/11 1 0099.8800.31fc DYNAMIC Fa0/12 1 64d9.8987.8033 DYNAMIC Fa0/47 1 64d9.8987.8034 DYNAMIC Fa0/48 1 64d9.8987.8040 DYNAMIC Fa0/47Total Mac Addresses for this criterion: 264_SW2#sh mac-address-table Mac Address Table-Vlan Mac Address Type Ports- - - - All 0100.0ccc.cccc STATIC CPU All 0100.0ccc.cccd STATIC CPU All 0180.c200.0000 STATIC CPU All 0180.c200.0001 STATIC CPU All 0180.c200.0002 STATIC CPU All 0180.c200.0003 STATIC CPU All 0180.c200.0004 STATIC CPU All 0180.c200.0005 STATIC CPU All 0180.c200.0006 STATIC CPU All 0180.c200.0007 STATIC CPU All 0180.c200.0008 STATIC CPU All 0180.c200.0009 STATIC CPU All 0180.c200.000a STATIC CPU All 0180.c200.000b STATIC CPU All 0180.c200.000c STATIC CPU All 0180.c200.000d STATIC CPU All 0180.c200.000e STATIC CPU All 0180.c200.000f STATIC CPU All 0180.c200.0010 STATIC CPU All ffff.ffff.ffff STATIC CPU 1 0099.8800.31f1 DYNAMIC Fa0/9 1 0099.8800.31fc DYNAMIC Fa0/10 1 64d9.8987.8033 DYNAMIC Fa0/47 1 64d9.8987.8034 DYNAMIC Fa0/48 1 64d9.8987.8040 DYNAMIC Fa0/47Total Mac Addresses for this criterion: 25全局设置状态4_SW2#configure terminalEnter configuration commands, one per line. End with CNTL/Z.设置交换机名称4_SW2(config)#hostname swtich_2swtich_2(config)#设置交换机ip地址swtich_2(config)#int vlan1swtich_2(config-if)#ip address 192.168.10.2 255.255.255.0swtich_2(config-if)#exitswtich_2(config)#interfacef1/0/2进入接口设置状态swtich_2(config)#interface f0/10设置交换机接口的duplex方式swtich_2(config)#interface f0/10swtich_2(config-if)#speed 100swtich_2(config-if)#duplswtich_2(config-if)#duplex half退出配置状态swtich_2(config-if)#exitswtich_2(config)#exitswtich_2#show interfaces f0/10FastEthernet0/10 is down, line protocol is down (notconnect) Hardware is Fast Ethernet, address is 64d9.8987.548c (bia 64d9.8987.548c) MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, Encapsulation ARPA, loopback not set Keepalive set (10 sec) Half-duplex, 100Mb/s, media type is 10/100BaseTX input flow-control is off, output flow-control is unsupported ARP type: ARPA, ARP Timeout 04:00:00 Last input never, output 00:04:39, output hang never Last clearing of show interface counters never Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 Queueing strategy: fifo Output queue: 0/0 (size/max) 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 280 packets input, 18286 bytes, 0 no buffer Received 4 broadcasts (0 multicasts) 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored 0 watchdog, 0 multicast, 0 pause input 0 input packets with dribble condition detected 699 packets output, 57894 bytes, 0 underruns 0 output errors, 0