磷化底漆.doc

磷化底漆Intended Uses用途一种作为铝、钢材，镀锌钢和轻合金表面处理和头道涂层The first coat for surface preparation of aluminium, steel galvanised steel and other light alloy ProductDescription产品简介二罐装聚乙烯醇縮丁醛磷化底漆Two packages, polyvinyl butyral etching primerProductInformation产品数据Volume Solids 固体份12%Dry Flm Thickness干膜厚度6microns 6微米Theoretical Coverage 理论涂布率20m2 /Kg 20平方米/公斤Practical Coverage 实际涂布率Allow appropriate loss 允许适量损耗Application Details施工详述Mix Radio 混合比A : B=5:1(by weight) 甲:乙=5:1Method of Application 施工方法 Airless Spray 无空气喷涂 Not Recommended 不推荐采用 Brush or Roller 涂刷或辊涂 Recommended 推荐采用 Conwentional Spray 传统喷涂 Recommended 推荐采用Thinner 稀释剂 C006Cleaner 油漆设备清洗剂 C006Pot Life 使用期 23:8h Storage 贮存期 One year 一年Drying time 干燥时间 SubstrateTemperature底材温度Touch Dry表干（min） Hard Dry 硬干（h）Over coating Interval覆涂间隔Mix最短Max最长52335401510241682 hour 小时1 hour 小时1hour 小时24 hour 小时24 hour 小时24 hour 小时StorageandHandling贮存与管理Storage 贮存 Store in cool and dry conditions 贮存于阴凉干燥处 Pack size 包装规格 A;15Kg in 20 liter container 甲:15公斤装于20公升容器中 B:3Kg in 4 liter container 乙:3公斤装于4公升容器中Flash Point 闪点 mixed paint:above 4 混合漆：高于4Specific Gravity 比重 1.10-1.20Kg/L 1.10-1.20公斤/公升Specification and Surface preparation技术要求及表面处理Clean all grease according to SSPC-SP1 by solvent cleaningEnsure that the area is clean, dry and free from metallic corrosion.根据 SSPC-SP1用溶剂清洗表面去除油脂。保证该区域清洁干燥无金属腐蚀物Limitations限制Avoid excessively thick film in application the dry-film thickness should be no more than 12um避免施工漆膜过厚，其干膜厚度不超过12微米，乙组份含有磷酸Safety Precautions安全措施The product must be used in painting area by professionals. When painting, please be sure to refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying the product.The product is a kind of solvent-based paint. In order to avoid the accident or dangerous occurrence, minimal safety precaution, as follow, should be down.The paint contains volatile solvent and it is flammable, So must keep away from sparks and open flames. No smoking at workplace, Effective precautions (such as using explosion-proof electrical equipments. No static electricity accumulation or metal collision etc) also should be done so as to avoid product sparks. Enough ventilation is necessary at application sites. In order to remove any danger of explosion, must keep the ratio of gas / air is less than 10 %, Usually 200 m3of ventilation quantity per 1 Kg solvent (according to the solvent) is necessary, it canMaintain the minimum explosive limit. Take effective precautions to prevent skin and eye contact with the coating (such as the use of overalls, gloves, goggles, face shields and protective oil coating and so on). If paint gets in touch with skin,If accidental skin contact with the product, please use fresh water and soap or an appropriate industrial cleaning agents thoroughly cleansed. In case of eyes being contaminated, rinse with fresh water for 10 min at least and give medical treatment immediately.During painting, it is recommended to wear face shields to prevent inhalation of paint mist and harmful gases.Especially in poorly ventilated environment, it is more necessary.Finally, be handled with care so as not to waste paint barrels of pollution of the environment.NOTICE: If consumers have not taken effective safety precautions (Refer to the specification), our company will NOT be responsible for any accident. 本产品必须由专业人员在工业场所使用。使用时请务必参照本说明书以及相关健康安全手册。若客户在使用本产品前,未能详细了解本产品的相关健康安全知识,请与本公司人员联系。该涂料为溶剂型涂料，为避免事故或危险发生，应采取最低限度的安全措施如下：此涂料为易燃物,并含有挥发性易燃溶剂，故必须远离火星和明火。严禁在作业场所吸烟，并应该采取有效措施，防止火星产生(如采用防爆电器设备，杜绝静电积累,避免金属撞击等)。 施工场所应尽量保持良好通风。为消除使用过程中的爆炸隐患,应保证足够的通风量以维持气体/空气比例不超过最低爆炸极限的10 %,通常每千克溶剂需要200立方米通风量,(与溶剂种类相关)就能维持最低爆炸极限10 %的工作环境。 采取有效措施，防止皮肤和眼睛与涂料直接接触(如使用工作服,手套,护目镜,面罩及涂防护油等)。若皮肤不