封箱机故障显示.doc

故障显示01. COMPRESSED AIR LOW PRESSURE.“压缩空气压力不足”，02. “STACKER INFEED CONVEYOR FULL” “堆叠装置入口皮带堆满”. （检查光电管39F1）03. “ONE MORE LAYER STACKED ”. “堆叠超过五层” （检查光电管47F1和47F2）04. “BUNDLE JAMMED AT STACKER ENTEY ZONE”“堆叠装置入口位置堵塞” （检查感应开关47X1）05. “STACKING UNIT JAM”.“堆叠装置堵塞” （检查接近开关46X1）06. “STACKER MOTOR OVERLOAD” “堆叠电机M46过载”07. STACKER MOTOR INVERTER FAULT堆叠电机变频器故障08. STACKS TRANSFER MOVEMENT JAMMED填充运动堵塞09. STACKS CONTAINER MOVEMENT JAMMED活动储存器运动堵塞10. STACKS CONTAINER MOVEMENT SLOW RETURN 活动储存器返回运动太慢11. CASE FILLING MOVEMENT JAMMED装箱运动堵塞12. CASE FILLER MOTOR INVERTER FAULT装箱电机过载13. CASE FILLER MOTOR INVERTER FAULT装箱运动变频器故障14 MOUTHPIECS NOT OPENED 连接导板没有打开15 . MOUTHPIECES NOT CLOSED 连接导板没有闭合16. CASE MAGAZINE ELEVATOR MOTOR OVERLOAD 箱皮提升电机过载M5317 CASE MAGAZ ELEVATOR MOTOR INVERTER FAULT 箱皮提升电机变频器故障18. CASE MEGAZINE EXTRACTION LEVEL TOO HIGH 箱皮拾取料位太高19. CASE MAGAZINE EMPTY箱皮用完20. FLAT CASE TRANSFER MOVEMENT JAMMED 箱皮传送运动堵塞21. CASE ERECTION MISSED 箱皮没有打开22. FULL CASE TRANSFER MOVE M OVERLOAD箱皮传送电机过载M53923. CASE ERECTION MOVEMENT OVERLOAD 纸箱打开运动过载24 ACTIVATET CASE ERECTION VACUUM 没有接通打开的负压25 FLAT CASE TRANSFER/ERECTION MOVEM.SAFETY 箱皮传送运动/纸箱打开运动冲突28. CASE CONTENTS CHECK SYSTEM FAILURE 纸箱内条盒数量检测系统故障29. CASE CONTENTS CHECK DISACTIVATED 纸箱内条盒数量检测系统关闭30. COLD GLUE APPLICATOR DISACTIVATED 喷胶系统关闭31. TAPE END OR BROKEN SIDE A A面胶带用完或断裂32. TAPE END OR BROKEN SIDE B B面胶带用完或断裂33. TAPE REEL LOW SIDE A A面胶带料位不足34. TAPE REEL LOW SIDE B B面胶带料位不足35. TAPE APPLICATION FAILURE SIDE A A面胶带故障36. TAPE APPLICATION FAILURE SIDE B B面胶带故障37. TAPE CONTROL DISACTIVATED 胶带功能关闭38. INCOMPLETE CASE AT MACHINE EXIT机器出口有次品纸箱39. DOWNSTREAM WORKING CONSENT MISSING无下游机使能信号40. CPU BATTERY LOWCPU电池不足41. INCORRECT PASSWORD口令错误42. UNIOP BATTERIES LOW面板电池电压低43. STOP MACHINE TO CONSENT REQUESTED OPERAT本操作只有停机才能执行44. DOW NSTREAM CONSENT SIGNAL EXCLUDED下游机使能信号短路45. SELECT PROGRAMMED CAM FORMAT请选择已编程的凸轮46. MOTOR OVERLOAD OR AUTO . SWITCH TRIPPED电机过载或自动开关脱开47. TRANSFER UNIT GUARD OPENED传送单元防护门打开48. STACKING UNIT GUARD OPENED堆叠单元防护门打开49. MACHINE GUARD OPEN机器防护门打开50. EMERGENCY STOP ACTIVATED紧急按扭被按下51. GUARDS SAFETIES BY ACTIVATED 防护门被短路52. TRANS UNIT MAIN OVERLOAD JOINT TRIPPED 转送单元主电机过载保护离合器脱开53. TRANS UNIT BELTS CARRIAGE OVERLOAD JOINT TRIPPED转送装置皮带支架打开54. TRANSFER UNIT M