丙烯酸铁红底漆.doc

丙烯酸铁红底漆Intended Uses用途适用于各种镀锌、未镀锌的钢结构作防腐底漆或屏蔽型中涂漆。涂层具有优异的附着力和防锈性。It is suitable for a various of galvanized and non-galvanized steel structures as primer or barrier intermediate coat. With excellent adhesion and corrosion resistance.ProductDescription产品简介Iron red, Primer or intermediate coat.铁红色，底漆或中涂漆ProductInformation产品数据Volume Solids 固体份45.5%Dry Film Thickness 干膜厚度50-80 m up to 100 m 50-80微米，最大可达100微米Theoretical Coverage 理论涂布率7.4 m2 /Kg 50 m of dry film thickness 7.4 m2 /Kg ,以50微米干膜计Practical Coverage 实际涂布率Allow appropriate loss 允许适量损耗Application Details施工详述Mix Radio 混合比One package 单罐装Method of Application 施工方法Airless Spray 无空气喷涂 Recommended 推荐采用Brush or Roller 涂刷或辊涂 Recommended 推荐采用Conventional Spray 传统喷涂 Recommended 推荐采用Thinner 稀释剂 Not necessary in normal. If need, use COO8 一般不需要，如需要用 COO8 Cleaner 油漆设备清洗剂 COO8Pot Life 使用期 Not limit 不限制Storage 贮存期 One year 一年Drying time干燥时间SubstrateTemperature底材温度,Touch Dry表干,hHard Dry硬干,hOver coating Interval覆涂间隔Mix最短Max最长250.52416 hNot limited不限Storage andHandling贮存与管理Storage 贮存 Store in cool and dry conditions, away from fire and heat sources 贮存于阴凉干燥处,远离火源、热源 Pack size 包装规格 20 Kg in 20 liter container 20 Kg装于20 L容器中Flash Point 闪点 35 Specification andSurface preparation技术要求及表面处理Blast cleaning to Swedish Standard Sa2.5 and rust-removed manually or with power tool to Swedish Standard St3.Preceding coat: One-component zinc-rich primer, zinc phosphate primer etc.Subsequent coat: Acrylic rubber paint etc.钢材表面喷砂处理至瑞典标准Sa2.5或手工除锈或动力工具除锈至瑞典标准St3。前道配套涂料：单组份富锌底漆，磷酸锌底漆等。后道配套涂料：丙烯酸橡胶面漆等。Limitations限制Not recommended follow-coated epoxy resin, polyurethane-type paint.不推荐覆涂环氧树脂类、聚氨酯类涂料。Safety Precautions 安全措施The product must be used in painting area by professionals. When painting , please be sure to refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying the product.The product is a kind of solvent-based paint. In order to avoid the accident or dangerous occurrence, minimal safety precaution, as follow, should be down.The paint contains volatile solvent and it is flammable, So must keep away from sparks and open flames. No smoking at workplace, Effective precautions (such as using explosion-proof electrical equipments. No static electricity accumulation or metal collision etc) also should be done so as to avoid product sparks. Enough ventilation is necessary at application sites. In order to remove any danger of explosion, must keep the ratio of gas / air is less than 10 %, Usually 200 m3of ventilation quantity per 1 Kg solvent (according to the solvent) is necessary, it canMaintain the minimum explosive limit. Take effective precautions to prevent skin and eye contact with the coating (such as the use of overalls, gloves, goggles, face shields and protective oil coating and so on). If paint gets in touch with skin,If accidental skin contact with the product, please use fresh water and soap or an appropriate industrial cleaning agents thoroughly cleansed. In case of eyes being contaminated, rinse with fresh water for 10 min at least and give medical treatment immediately.During painting, it is recommended to wear face shields to prevent inhalation of paint mist and harmful gases.Especially in poorly ventilated environment, it is more necessary.Finally, be handled with care so as not to waste paint barrels of pollution of the environment.NOTICE: If consumers have not taken effective safety precautions (Refer to the specification), our company will not be responsible for any accident. 本产品必须由专业人员在工业场所使用。使用时请务必参照本说明书以及相关健康安全手册。若客户在使用本产品前,未能详细了解本产品的相关健康安全知识,请与本公司人员联系。该涂料为溶剂型涂料，为避免事故或危险发生，应采取最低限度的安全措施如下：此涂料为易燃物,并含有挥发性易燃溶剂，故必须远离火星和明火。严禁在作业场所吸烟，并应该采取有效措施，防止火星产生(如采用防爆电器设备，杜绝静电积累,避免金属撞击等)。 施工场所应尽量保持良好通风。为消除使用过程中的爆炸隐患,应保证足够的通风量以维持气体/空气比例不超过最低爆炸极限的10 %,通常每千克溶剂需要200立方米通风量,(与溶剂种类相关)就能维持最低爆炸极限10 %的工作环境。 采取有效措施，防止皮肤和眼睛与涂料直接接触(如使用工作服,手套,护目镜