新加坡金字塔公司项目管理模式英文版(4).doc

STANDARD OPERATING PROCEDURESSOP-ST-00STRUCTURAL WORKRef. No.ContentsSOP-ST-01Excavation and BackfillingSOP-ST-02Foundation WorkSOP-ST-03Timber FormworkSOP-ST-04Steel ReinforcementSOP-ST-05ConcretingSOP-ST-06Lifting of Precast Hollow Core SlabSOP-ST-07Lifting of Precast ColumnSOP-ST-08Grouting to Precast ItemsPARK HYATT SAIGON HOTEL PROJECTSTANDARD OPERATION PROCEDURE NO SOP ST 06 WORK TITLE :Lifting of precast follow core slab APPROVED BY :Head, Control DeptCHECKED BY : PROJECT MANAGERREVISION : A EFFECTIVE DATA : 18/5/98WORKMANSHIP STANDARD : ACCEPTANCE /REJECTION CRITERIATo comply with specification REFERENCE STANDARDS/ CODES & QUALITY PLAN :To comply with specialist requirement FACILITIES /INSPECTION INSTRUMENT : Hoist beam & clambers are attached with shackle/sling ENVIRNMENT CONTROLS :NA NECESSARY RECORDS :Shop drawings FREQUENCY :Every inspection SPECIAL REQUIREMENTS : NASAFETY & HEALTH REQUIREMENTS :Check the safety working load for hoisting equipment WORK PROCEDURECHECKING METHODREMEDIAL MEASURERESPOSIBILITYProject ManagerEngineerForemanAssistant ForemanTrade WorkerCheckerSubconOthers 1.When delivery arrives inform the driver where to park the trailer 2. Slabs shall be off loaded using a lifting beam and clampers or a lifting beam and bells , Both systems are attached by shackle and sliding to the claim block of the crane 3.Check the condition of all lifting equipment 4.Place clampers at the correct position on the slabs5. Check that area for lifting is clear 6. Once the slab is lifted slightly, attach the safety chains around the component and latch on the other site of the clampersBy visual By visual By visual Measure by tape By visualBy visual Re-park again Re place by the correct size Re-place by the correct size Re-adjust Clear the area Re-do FFFFFFCCCCCPPPPPPFile : ST - 06 DISK: SOP A : APPROVE F : CONFIRM P : PERFORM C: CHECK PARK HYATT SAIGON HOTEL PROJECT STANDARD OPERATION PROCEDURE NO SOP ST 06 WORK TITLE :Lifting of precast follow core slab APPROVED BY :Head, Control DeptCHECKED BY : PROJECT MANAGERREVISION : A EFFECTIVE DATA : 18/5/98WORK PROCEDURECHECKING METHODREMEDIAL MEASURERESPOSIBILITYProject ManagerEngineerForemanAssistant ForemanTrade WorkerCheckerSubconOthers 7.Hoist the slab to the installation location and lower it slowly into the correct position.8.Once the slab is in position and seated safety, the safety chains are released , clampers are removed to pick up the next slab 9.Check that the position of the slab is correct10.If the slab is seated in the wrong location, adjust by using a crowbar By visual By visual By visual By visual Re-do Re-doRe-doRe-doAFFFFCCCCPPPPFile : ST - 06 DISK: SOP A : APPROVE F : CONFIRM P : PERFORM C: CHECK PARK HYATT SAIGON HOTEL PROJECT STANDARD OPERATION PROCEDURE NO SOP ST 07 WORK TITLE :Lifting of precast column APPROVED BY :Head, Control DeptCHECKED BY : PROJECT MANAGERREVISION : A EFFECTIVE DATA : 18/5/98WORKMANSHIP STANDARD : ACCEPTANCE /REJECTION CRITERIATo comply with specification REFERENCE STANDARDS/ CODES & QUALITY PLAN :To comply with specialist requirement FACILITIES /INSPECTION INSTRUMENT : ENVIRNMENT CONTROLS :NANECESSARY RECORDS :Shop drawings FREQUENCY :Every inspection SPECIAL REQUIREMENTS : SAFETY & HEALTH REQUIREMENTS :Check the safety working load for hoisting equipment WORK PROCEDURECHECKING METHODREMEDIAL MEASURERESPOSIBILITYProject ManagerEngineerForemanAssistant ForemanTrade WorkerCheckerSubconOthers 1.When delivery arrives inform the driver where to park the trailer 2.Check the condition of all lifting equipment 3.Mrak a straight line at the center of two sides of the column, to check the alignment after installation.4.Check that area for lifting is clear 5.Lift the column from the trailer to a location close to the installation position.6.Insert the lifting pin through the column and lift from its resting position.By visualBy visual By theodolite & dumpy levelBy visual By visualBy visual Re- parkRe-pair Re-doClear the areaRe-doRe-doFFFFFFCCCCCCPPPPPPFile : ST - 07 DISK: SOP A : APPROVE F : CONFIRM P : PERFORM C: CHECK PARK HYATT SAIGON HOTEL PROJECT STANDARD OPERATION PROCEDURE NO SOP ST 07 WORK TITLE :Lifting of precast column APPROVED BY :Head, Control DeptCHECKED BY : PROJECT MANAGERREVISION : A EFFECTIVE DATA : 18/5/98WORK PROCEDURECHECKING METHODREMEDIAL MEASURERESPOSIBILITYProject ManagerEngineerForemanAssistant ForemanTrade WorkerCheckerSubconOthers 7.The column is then hoisted slowly to upright position and raised above the right of the starter bars8.Lower the column down so that starter bars slot neatly into the correct ducts9.The column is then lowered to its seated position with the aid of slim plates to adjust the level ensure that the base of the column is seated on the slim plates and there are no obstructions.10. Props ate then secured and fastened both to the column and floor 11.Crane is released to pick the next column By visualBy visual Dumpy level By visual By visual Re- doRe-doRe-adjust Re-doRe-doFFFFFFCCCCCCPPPPPPFile : ST - 07 DISK: SOP A : APPROVE F : CONFIRM P : PERFORM C: CHECK PARK HYATT SAIGON HOTEL PROJECT STANDARD OPERATION PROCEDURE NO SOP ST 08 WORK TITLE :Grouting to precast items APPROVED BY :Head, Control DeptCHECKED BY : PROJECT MANAGERREVISION : A EFFECTIVE DATA : 18/5/98WORKMANSHIP STANDARD : ACCEPTANCE /REJECTION CRITERIATo comply with specification REFERENCE STANDARDS/ CODES & QUALITY PLAN :To comply with specialist requirement FACILITIES /INSPECTION INSTRUMENT : Gout mixer/stirrer . pail , measurement jug ENVIRNMENT CONTROLS :NANECESSARY RECORNA FREQUENCY :Every inspection SPECIAL REQUIREMENTS : NASAFETY & HEALTH REQUIREMENTS :NAWORK PROCEDURECHECKING METHODREMEDIAL MEASURERESPOSIBILITYProject ManagerEngineerForemanAssistant ForemanTrade WorkerCheckerSubconOthers 1.Ensure firstly that the base of the column is cleat , free from dirt and debris 2.Check that the grouting sleeve is clear 3.The base of the column is then seated off and formed up by means of timber formwork4.Grout mixer /stirrer , pail, measuring jug to be made available 5.The grouting is then mixed by pouring the measured volume of water with a stirrer 6.After mixing is completed , pour/pump into the grouting h