8K86正常开机信息.docx

Boot-Preloader T8032 NO ack!（启动预载T8032结束）DRAM Channel A Calibration.（开始检测DDR）HW Byte 0 : DQS(9 35), Size 27, Set 22.HW Byte 1 : DQS(7 32), Size 26, Set 19.HW Byte 2 : DQS(10 32), Size 23, Set 21.HW Byte 3 : DQS(3 33), Size 31, Set 18.DRAM A Size = 256 Mbytes.Boot （开始检测BOOT）Start Pmain0x000030a4NID=0x9510daecLZHS addr:0x00100040LZHS size:0x0005d150LZHS checksum:0x000000caBootStart LmainMT5395 Boot Loader v0.9MUSB none SoftReset 0x29424 = 0x01030000.MUSB pBase = 0xF0029000 init ok.MUSB none SoftReset 0x29424 = 0x01030000.MUSB pBase = 0xF002E000 init ok.Boot reason: A/C power on!Load VGA internal EDID. Load HDMI internal EDID. SIF_Master0: new designSIF_Master1: old designSet IRCLKSEL as 6 for USR TYPE IR!Boot reason: A/C power on!T8032 init A/C on case loader stage.Load T8032 FW (addr: 0x d34194, size: 12288)success!T8032 FW version: 66T8032 change to loader stage.LDR_FlashCopy 0xf010 0x2ba80 0x80 Detect SLC NAND flash ID: 0x9510DAECDetect SS K9F2G08U0B NAND flash: 256MBNAND_BDM_Mount: Partid=0, offset=0x0, size=0x200000BDM Partition: 0, Bad Block Count: 0Boot reason: A/C power on!Boot reason: A/C power on!Org:0x30 Flags:0x30 Do USB upgrade（常规检测，是否有升级需求）No USB device.USB upgrade stopBoot reason: A/C power on（上电）!Not support LdrLedBlinkikng!Reset Demod GPIO=41, 0-1NAND load lzhs header from 0x40000 to dram(0xfe3060), size=2048（加载NAND开始）Decompression uboot to 0x00f00000.NAND load image from 0x40000 to dram(0xfe3060), size=0x33550LZHS hardware decode startLZHS hardware decode doneStarting image.U-Boot starts.NAND Flash: Detect NAND flash ID: 0x9510DAEC detDetect SS K9F2G08U0B NAND flash: 256MB（detect：检测）256 MiBBooting sequence is from NAND FlashIn: serial (串行)Out: serialErr: serialSIF_Master0: new designSIF_Master1: old designBoot from kernelA and rootfs at partition 6 Hit any key to stop autoboot: 0 （按任意键停止自动引导）Partition rootfsA defined at mtdparts:ID:6, Offset:0x00c00000, Size:0x00600000Loading from nand0, offset 0x800000Automatic boot of image at addr 0x00008000 .# Booting kernel from Legacy Image at 00008000 . XIP Kernel Image . OKOKStarting kernel .Uncompressing Linux. done, booting the kernel.INIT: version 2.86 booting（init：初始化）Mounting local filesystems: mount mount: according to /proc/mounts, /dev/root is already mounted on /Running .ipv4.tcp_window_scaling = 6# mount basicUBI device number 0, total 280 LEBs (35553280 bytes, 33.9 MiB), available 0 LEBs (0 bytes), LEB size 126976 bytes (124.0 KiB)real 0m 0.10suser 0m 0.00ssys 0m 0.05sreal 0m 0.14suser 0m 0.00ssys 0m 0.09skobject_add_internal failed for ramzswap0 with -EEXIST, dont try to register things with the same name in the same directory.ERROR: ld.so: object /3rd/lib/preloadable_libiconv.so from LD_PRELOAD cannot be preloaded: ignored.AppManagerinitAppManagerinit dfb startAppManagerinit dfbinput threads parent pid is 304 tid is 304DirectFB: Wait to Init IR.!=DFB capability not changed!ProcessManagerinitProcessManagerinitAM init succeed-1,8-AM init input NON_CANONICAL_INPUT success AM default process state 4 dtv_app_mtk dtv_app_mtkERROR: ld.so: object /3rd/lib/preloadable_libiconv.so from LD_PRELOAD cannot be preloaded: ignored. dtv_app_mtk FakeDM Init.FakeDM Init FM. dtv_app_mtk/dev is created./mnt is already existed. That is OK./mnt/usb is created.FakeDM FM inited. dtv_app_mtkDM _dm_cb_msg_thread enter dtv_app_mtkDM _dm_nfy_req_thread enterdtv_app_mtkDM _dm_nfy_req_thread get_nl_sock:57mtkDM _dm_open_dev_thread: entered dtv_app_mtk input thread pid is 304 tid is 307 original scheduler policy 0 scheduler nice -10 original child scheduler policy 0 prio 0 new child scheduler policy 2 prio 99 Start to wait IR event.FM-LinuxMount /dev/mtd8 to /basic successfully._app_mtkFM(/dev/mtd8) is mounted to (/basic) successfully(0)app_mtkDT Real Time Clock is available on this system. dtv_app_mtk wakeup reason = 6 dtv_app_mtkCDB Loading metadata (version 7)CDB Loading metadata (version 7)dtv_app_mtkINFO: _357_(sys_ap_start.c:a_appl_init)p_mtkINFO: _358_(sys_ap_start.c:a_appl_init)dtv_app_mtkINFO: _359_(sys_ap_start.c:a_appl_init)dtv_app_mtkINFO: _360_(sys_ap_start.c:a_appl_init)dtv_app_mtkACFGIPCvideoSettingThreadCreateACFGIPC+videoSettingThreadFuncmsgReceiveId :0x0 msgSendId :0x0 INFO: _363_(sys_ap_start.c:a_appl_init) dtv_app_mtkchina_atv_vol_get_comp line 5794 ui4_mask_idx=0 dtv_app_mtk nav_custom_register_components1122 a_tv_set_input_src_id#8138#t_g_crnt_src_ret_id=0 a_tv_set_input_src_id#8141#t_g_b_first_src=1 a_tv_set_input_src_id#8153#t_g_last_src_ret_id=0 a_tv_set_input_src_id#8154#t_g_crnt_src_ret_id=0 a_tv_set_input_src_id#8155#ui1_input_src=0china_atv_vol_get_comp line 5794 ui4_mask_idx=0 Open audio outport: 0 ms dtv_app_mtkAPP_TV TV Brdcst type = 1 TV_SCART Enabled: 0 Monitor_SCART Enabled: 1 dtv_app_mtkchina_atv_vol_get_comp line 5794 ui4_mask_idx=4 dtv_app_mtk _nav_updater_usb_handle_msg451b_delay_start=0 Call function : a_msg_convert_register. dtv_app_mtk dtv_app_mtk Call function _mc_app_init_fct. dtv_app_mtk msg_convert_custom_init NPTVAdaptiveLuma: Enable Luma HistogramSet TDTV datamode to(1)*bDrvUpdateInternalFrameRate*bDrvUpdateInternalFrameRate*dtv_app_mtk#dtv_app_mtk dtv_app_mtk:dtv_app_mtk,am,:started=menu dtv_app_mtk dtv_app_mtk:dtv_app_mtk,am,:started=factory# mount 3rd dtv_app_mtk dtv_app_mtkUBI device number 1, total 520 LEBs (66027520 bytes, 63.0 MiB), available 0 LEBs (0 bytes), LEB size 126976 bytes (124.0 KiB) dtv_app_mtkrea0m 0.19s dtv_app_mtkuser 0m 0.00s dtv_app_mtksys 0m 0.13s UBIFS: recovery neededUBIFS: recovery completeddtv_app_mtkreal 0m 0.06s dtv_app_mtkuser 0m 0.00s dtv_app_mtksys 0m 0.02s dtv_app_mtkFM-LinuxMount /dev/mtd9 to /3rd successfully. dtv_app_mtFM(/dev/mtd9) is mounted to (/3rd) successfully(0) usbcore: registered new interface driver usbfsusbcore: registered new interface driver hubusbcore: registered new device driver usbusbcore: registered new interface driver r871x_usb_drvrtw driver version=v2.0.1126.20101020usbcore: registered new interface driver rtw_usb_drv Creat WPA supplicant dtv_app_mtk send init indication by supc wndrv indication: success dtv_app_mtkINET x_net_network_init dtv_app_mtkINET share memory initializedpp_mtk dtv_app_mtkDragon_Inet :_read_mac_config$ loop: module loadedSCSI subsystem initializedDriver sd needs updating - please use bus_type methodsUSB USB_PWR_SWITCH_GPIO_CUST.hub reset: Set GPIO20 = 0.USBMUSB ResetPhy u4Reg 0x24= 0x1c30000MtkUsbHcd MtkUsbHcd.0: USB Host ControllerMtkUsbHcd MtkUsbHcd.0: new USB bus registered, assigned bus number 1MtkUsbHcd MtkUsbHcd.0: irq 15, io mem 0xf0029000usb usb1: configuration #1 chosen from 1 choicehub 1-0:1.0: USB hub foundhub 1-0:1.0: 1 port detectedINET _read_mac_config: the network config star: star_open(eth0)star: request interrupt vector=8star: Internal PHY modeUSBMUSB ResetPhy u4Reg 0x24= 0x1c30000checksum err, byte: 0xff, ret: 0xeaINET x_neMtkUsbHcd MtkUsbHcd.1: USB Host ControllerMtkUsbHcd MtkUsbHcd.1: new USB bus registered, assigned bus number 2MtkUsbHcd MtkUsbHcd.1: irq 11, io mem 0xf002e000usb usb2: configuration #1 chosen from 1 choicehub 2-0:1.0: USB hub foundhub 2-0:1.0: 1 port detectedt_ni_set_mac, eth0 0xbc83a7219e46INET if disable eth0 dtv_app_mtkINET if enable eth0 dtv_app_mtkINET if enable eth0dtv_app_mtkINET x_net_set_if_type (6)p_mtk Initializing USB Mass Storage driver.usbcore: registered new interface driver usb-storageUSB Mass Storage support registered.usbcore: registered new interface driver usbhidusbhid: v2.6:USB HID core driverINET wifi0 is unplug!INET eth0 is unplug! dtv_app_mtk Get MW OP FFFFFF Set plane enable by MW OP idx: 0 enable:0Get MW OP FFFFFF Set plane enable by MW OP idx: 0 enable:1USB USB_PWR_SWITCH_GPIO_CUST.Hub: Reset GPIO20 = 1.CustomCode is 0x e0e, KeyCode is 0x11U4KEY: 0x8f001 pbFlag =1MW_IRRC_NotifyFunc sound play.dtv_app_mtkGet MW OP FFFFFF Set plane enable by MW OP idx: 0 enable:0Get MW OP FFFFFF Set plane enable by MW OP idx: 0 enable:1dtv_app_mtk dtv_app_mtk:dtv_app_mtk,am,:paused=navigator scrn_svr_view_hide516menu_custom_resume 594ENTRY HERE!can not do here! ir move btn repeat REPEAT Frame, send PrevKey 0x 8f001dtv_app_mtk(#) DirectFBError p_dst_surf-p_dfb_surf-Blit( p_dst_surf-p_dfb_surf, p_src_surf-p_dfb_surf, &dfb_rect, i4_dst_x, i4_dst_y): Invalid area present! dtv_app_mtk dtv_app_mtk:dtv_app_mtk,am,:re