IP--SLA-- EEM 配置实验.docx

IP-SLA- EEM 配置实验作者：救世主220实验日期：2015.11.1实验拓扑如下：实验配置信息：R1配置：R1#show running-configBuilding configuration.!track 1 ip sla 1 reachability!track 2 ip sla 2 reachability!interface Loopback0 ip address !interface Serial1/0 ip address serial restart-delay 0!interface Serial1/1 ip address serial restart-delay 0!interface FastEthernet2/0 ip address ip policy route-map ccie duplex auto speed auto!router ospf 10 router-id log-adjacency-changes network area 0 network area 0 default-information originate!ip route track 1ip route track 2!ip sla 1 icmp-echo source-ip timeout 1000 threshold 2 frequency 3ip sla schedule 1 life forever start-time nowip sla 2 icmp-echo source-ip timeout 1000 threshold 2 frequency 3ip sla schedule 2 life forever start-time nowaccess-list 100 permit ip any host access-list 101 permit ip any host !route-map ccie permit 10 match ip address 100 set ip next-hop !route-map ccie permit 20 match ip address 101 set ip next-hop !event manager applet track1 event track 1 state down action 1.0 cli command enable action 2.0 cli command conf t action 3.0 cli command int s1/0 action 4.0 cli command shevent manager applet track2 event track 2 state down action 1.0 cli command enable action 2.0 cli command conf t action 3.0 cli command int s1/1 action 4.0 cli command sh实验截图：R2配置：R2#show running-configBuilding configuration.!interface Serial1/0 ip address serial restart-delay 0!interface FastEthernet2/0 ip address duplex auto speed auto!router ospf 1 router-id log-adjacency-changes network area 0 default-information originate!ip route !实验截图：R3配置：R3#show running-configBuilding erface FastEthernet1/0 ip address duplex auto speed auto!interface Serial2/0 ip address serial restart-delay 0!router ospf 1 router-id log-adjacency-changes network area 0 default-information originate!ip route !R4配置：R4#show running-configBuilding configuration.!interface Loopback0 ip address !interface Loopback1 ip address !interface FastEthernet1/0 ip address ip ospf priority 0 duplex auto speed auto!interface FastEthernet1/1 ip address ip ospf priority 0 duplex auto speed auto!router ospf 1 router-id log-adjacency-changes network 55 area 0实验截图： R5配置：R5#show running-configinterface Loopback0 ip address !interface FastEthernet1/0 ip address duplex auto speed auto!router ospf 10 router-id log-adjacency-chan