




免费预览已结束,剩余3页可下载查看
下载本文档
版权说明:本文档由用户提供并上传,收益归属内容提供方,若内容存在侵权,请进行举报或认领
文档简介
英文 sci 论文投稿过程信件模板一览一、英文 sci 论文:最初投稿 cover letterdear editors:we would like to submit the enclosed manuscript entitled “paper title ”, which we wish to be considered for publication in “journal name ”. no conflict of interest exits in the submission of this manuscript, and manuscript is approvedby all authors for publication. i would like to declare on behalf of my co-authorsthat the work described was original research that has not been published previously, and not under consideration for publication elsewhere, in whole orin part. all the authors listed have approved the manuscript that is enclosed.in this work, we evaluated(简要介绍一下论文的创新性 ). i hope this paper is suitable for “journal name ”.the following is a list of possible reviewers for your consideration:1) name ae-mail:2) name be-mail:wedeeplyappreciateyourconsiderationofourmanuscript,andwelookforward to receiving comments from the reviewers. if you have any queries, please don t hesitate to contact me at the address below.精品资料thank you and best regards.yours sincerely,corresponding author:name:e-mail:二、英文 sci 论文:催稿信dear prof.:sorry for disturbing you. i am not sure if it is the right time to contact you toinquire about the status of my submitted manuscript titled“paper title ”. (id:文章稿号 ), although the status of“with editor ”has been lasting for more than two months, since submitted to journal three months ago. i am just wonderingthat my manuscript has been sent to reviewers or not?i would be greatly appreciated if you could spend some of your time check the status for us. i am very pleased to hear from you on the reviewers comments.thank you very much for your consideration.best regards!yours sincerely,corresponding author:name:e-mail:三、英文 sci 论文:修改稿 cover letterdeardr/prof.( 写上负责你文章编辑的姓名,显得尊重 ,因为第一次的投稿不知道具体负责的编辑 ,只能用通用的editors):onbehalfofmyco-authors,wethankyouverymuchforgivingusan opportunity to revise our manuscript, we appreciate editor and reviewers verymuchfor theirpositiveandconstructivecommentsandsuggestionson our manuscript entitled“paper title ”. (id:文章稿号 ).we have studied reviewers comments carefully and have made revision whichmarked in red in the paper. we have tried our best to revise our manuscript accordingto thecomments.attachedpleasefindthe revisedversion,which we would like to submit for your kind consideration.wewouldliketo expressourgreatappreciationto youandreviewersfor comments on our paper. looking forward to hearing from you.thank you and best regards.yours sincerely,corresponding author:name:e-mail:四、英文 sci 论文:修改稿回答审稿人的意见(最重要的部分 )list of responsesdear editors and reviewers:thankyoufor yourletterandforthe reviewers commentsconcerningour manuscriptentitled“papertitle ”(id:文章稿号 ).thosecommentsare all valuableand veryhelpful for revising and improving our paper, as well as the important guiding significance to our researches. we have studied comments carefully and have madecorrectionwhichwehopemeetwithapproval.revisedportionaremarkedinredinthepaper.themaincorrectionsinthepaperandthe responds to the reviewers comments are as flowing:responds to the reviewers comments:reviewer #1:1. response to comment: (简要列出意见) response:2. response to comment: (简要列出意见)response:。逐条意见回答 ,切忌一定不能有遗漏针对不同的问题有下列几个礼貌术语可适当用用:we are very sorry for our negligence of.we are very sorry for our incorrect writing.it is really true as reviewer suggested thatwe have made correction according to the reviewers comments.we have re-written this part according to the reviewers suggestionas reviewer suggested thatconsidering the reviewers suggestion, we have最后特意感谢一下这个审稿人的意见:special thanks to you for your good comments.reviewer #2:同上述reviewer #3:other changes:1. line 60-61, the statements of“”were corrected as“”2. line 107,“”was added3. line 129,“”was deletedwe tried our best to improve the manuscript and made some changes inthe manuscript.these changes will not influence the content and frameworkof the paper. and here we did not list the changes but marked in red in revisedpaper.weappreciatefor editors/reviewerswarmworkearnestly,and hopethat the correction will meet with approval.onceagain,thankyouvery muchfor yourcommentsandsuggestions.andhere we did not list the changes but marked in red in r
温馨提示
- 1. 本站所有资源如无特殊说明,都需要本地电脑安装OFFICE2007和PDF阅读器。图纸软件为CAD,CAXA,PROE,UG,SolidWorks等.压缩文件请下载最新的WinRAR软件解压。
- 2. 本站的文档不包含任何第三方提供的附件图纸等,如果需要附件,请联系上传者。文件的所有权益归上传用户所有。
- 3. 本站RAR压缩包中若带图纸,网页内容里面会有图纸预览,若没有图纸预览就没有图纸。
- 4. 未经权益所有人同意不得将文件中的内容挪作商业或盈利用途。
- 5. 人人文库网仅提供信息存储空间,仅对用户上传内容的表现方式做保护处理,对用户上传分享的文档内容本身不做任何修改或编辑,并不能对任何下载内容负责。
- 6. 下载文件中如有侵权或不适当内容,请与我们联系,我们立即纠正。
- 7. 本站不保证下载资源的准确性、安全性和完整性, 同时也不承担用户因使用这些下载资源对自己和他人造成任何形式的伤害或损失。
最新文档
- 金融行业资金清算流程标准化
- 环境监测数据分析与风险预警
- 隐患排查安全管理标准清单模板
- BIM信息模型技术应用方案书
- 高校在线英语课程作业解析2024
- 高三生物期中模拟试题及解析
- 流动儿童心理健康服务工作报告
- 高效时间管理技巧在职场的运用
- 2025-2030区块链技术在供应链金融中的应用前景与投资策略研究
- 设备调试及试车记录标准表格
- 钢琴基础教程课件完整版
- 机关档案管理工作培训课件
- 生物武器伤害及其防护课件
- 简约大气商业计划书项目融资模板
- 内经选读上古天真论课件
- GJB9001C标准内审员考试自测题试题含答案
- 一、长方体和正方体表面涂色的
- GB∕T 36667-2018 船舶和海上技术 船舶系泊和拖带设备舷内带缆桩(钢板型)
- 猪肉采购服务方案(完整版)
- kinetix6200和6500模块化多轴伺服驱动器用户手册
- 【图文】GB8624-2012建筑材料及制品燃烧性能分级(精)
评论
0/150
提交评论