学术论文英文翻译[科技学术论文英文翻译参考]

学术论文英文翻译科技学术论文英文翻译参考 列入表中 1. are listed in 2. is presented in 3. are summarized in 4. is shown in 5. As we know, the sample failure time of step-stress test in Table II has to be converted into the failure time at constant-stress. 6. The physical parameters of the flue gas are given in Table.2. 如图所示 1. The specific coupling relationship is illustrated in Fig. 2.（示意图、流程图） 2. can be found from Fig. 4. 3. as shown in 4. is plotted in Fig. 2, 5. Fig. 5a and b respectively show 6. Fig. 6 gives dynamic curves of 7. Fig. 7 displays the characteristic curves of the maximum amplitude of the plate versus the magnitude of the applied magic field with different impulse parameter time 8. The detailed iterative procedures are displayed in Fig. 4. 9. Fig. 8 plots the characteristic curves of the critical value varying with the lengththickness ratio of the plate for different electric conductivity 10. the numerical results shown in Fig. 7 exhibit that 11. From Fig. 7, it will be found that 12. It can be found, from Fig. 5a, that 13. , shown in Fig. 5b, 14. It is found from Fig. 3 that 15. Similar to Fig. 7, Fig.9 also exhibits that 16. Fig. 8 exhibits that 17. The curves given in Figs. 8 and 9. 18. Fig.5 pares present overall efficiency with the result got by Huang Z. et al. (xx). It is very clear that the calculated overall efficiency shows a very good agreement with the one 19. Comparing Fig. 6 (a) and (b), 20. As shown in Fig. 6 (b), (c) and (d), 21. Two effects of applied magic field on PM2.5 collection efficiency can be further identified in Fig. 10. 22. Fig. 6 depicts the vipation divergence curves of maximum displacement and Mises stress under three conditions with UFSI considered, and it is clear that: 23. Fig. 6 depicts the vipation divergence curves of maximum displacement and Mises stress under three conditions with UFSI considered, and it is not difficult to find that 24. the maximum Mises stress of the blade also increases with time and divergence phenomenon bees visible (see Fig. 6 (b), (d) and (f). 从看出： 1. It can be seen that 2. It is very clear that the calculated overall efficiency shows a very good agreement with the one 3. It can be seen in Fig. 9 that 4. Furthermore, it is identified that 5. Fig. 11 presents the PM2.5 overall efficiency under the same conditions as used in Fig. 10. 6. which is consistent with the second point drawn from Fig. 10. 7. Further, from top four curves in Fig. 12, it can be seen, at a given particle size that 8. (see Figs. 10 and 11) 公式描述 1. bining (16) and Fig. 2, the following transition formula is obtained: 2. can be written as 3. can be rewritten as 4. is estimated by 5. , namely 6. can be expressed as 7. is transformed to 8. one can obtain 9. one can get 10. , that is 11. defined as 12. are respectively taken as 13. are respectively listed as follows 14. one can obtain a basic equation on the eddy current vector potential T as follows 15. Substituting mi(i = 1, 2, 3, 4), given in Table III, and n1=n3= 10, n2= n4= 8 into (22), the shape parameter was found to be m = 5.8043. 16. Using (21), obtained life information at I0 is: = 15138.6h and t0.5=15437.9h. 17. could ping some differences in the life estimation 18. here 19. where 20. thus 意义 1. The optimized model provides significant guidelines for researchers and manufacturers in aspect of life prediction methodology for its development. 2. Which provides significant guidelines to help engineers make decisions in design and manufacturing strategy from the aspect of reliability life. 3. The optimized model in this study not only achieves the aurate estimation for the HPWLED life, but also further improves the life prediction methods, which can provide technical references for manu