思科第一学期期末考试最新考题CCNA1

1、.1窗体顶端Refer to the exhibit. Which Layer 2 protocol could be used inside nework A and network C?IPTCPUDPEthernet窗体底端2窗体顶端Refer to the exhibit. Which set of devices contains only intermediary devices?A, B, D, GA, B, E, FC, D, G, IG, H, I, J窗体底端3窗体顶端Refer to the exhibit. The headers added at each layer

2、 are shown. Which layer adds the destination and source process numbers to ensure that data is delivered to the correct application?physical layerdata link layernetwork layertransport layer窗体底端4窗体顶端The Layer 4 header contains which type of information to aid in the delivery of data?service port numb

3、erhost logical addressdevice physical addressvirtual connection identifier窗体底端5窗体顶端Which fiber connector supports full-duplex Ethernet?窗体底端6窗体顶端Which device should be used for routing a packet to a remote network?access switchDHCP serverhubrouter窗体底端7窗体顶端Refer to the exhibit. Host A sends a frame to

4、 host C with a destination MAC address CC. The MAC address for host C is not in the MAC table of switch SW1. How will SW1 handle the frame?Switch SW1 will drop the frame.Switch SW1 will forward the frame to host C.Switch SW1 will flood the frame out all ports.Switch SW1 will flood the frame out all

5、ports except port Fa0/1.窗体底端8窗体顶端Refer to the exhibit. A network technician has made several changes to R1 since the configuration has last been saved. The modified configuration did not produce the desired changes. The technician wants to store a backup copy of the saved configuration on a TFTP ser

6、ver before reloading. Which action will cause the unmodified data to be saved on the TFTP server?窗体底端9窗体顶端Which three statements are true about network layer addressing? (Choose three.)It uniquely identifies each host.It assists in forwarding packets across internetworks.It uses a logical 32-bit IPv

7、4 address.It is not a configurable address.It is a physical address.It identifies the host from the first part of the address.窗体底端10窗体顶端What is the result of using the clock rate 56000 command at the serial interface of the router?The interface is configured as a DCE device.The interface timers are

8、cleared.The FastEthernet interface is made to emulate a serial interface by assigning it a timing signal.The IP address for the serial interface is configured.窗体底端11窗体顶端Examine the graphic with current configurations. Host A in the Clerical office failed and was replaced. Although a ping to 127.0.0.

9、1 was successful, the replacement computer cannot access the company network. With proxy ARP disabled on the Fa0/0 interface of the New York router, what is the likely cause of the problem?network card failurenetwork cables unpluggedIP address incorrectly enteredsubnet mask incorrectly entered窗体底端12

10、窗体顶端As network administrator, what is the subnet mask that allows 510 hosts given the IP address ?28窗体底端13窗体顶端Which OSI layer uses a connection-oriented protocol to ensure reliable delivery of data?application laye

11、rpresentation layersession layertransport layer窗体底端14窗体顶端A network has grown too large for technicians to configure network addresses and hosts files for name resolution. Which two application layer services should be added to the server to allow these needs to be satisfied dynamically? (Choose two.

12、)DNSFTPDHCPHTTPSMTP窗体底端15窗体顶端Refer to the exhibit. Host A wants to access the Internet. Which combination of a Layer 2 address and a Layer 3 address will enable this access from host A?Destination MAC: 0030.8596.DE83 Default gateway: 30Destination MAC: 0030.8596.DE82 Default gateway: 17

13、Destination MAC: 0030.8517.44C4 Default gateway: Destination MAC: 0030.8517.44C4 Default gateway: 30窗体底端16窗体顶端A network administrator is asked to design a new addressing scheme for a corporate network. There are 60 users in the main office, 40 users in the branch offic

14、e, 28 users in manufacturing, 12 in the sales office, and 4 users in the research office. Which VLSM addressing scheme that uses the /24 network will fulfill the requirements while wasting the fewest addresses?/26 main2/26 branch4/26 manufacturing192.1

15、68.88.96/27 sales28/28 research/26 main4/26 branch28/27 manufacturing60/28 sales76/29 research/27 main2/27 branch4/28 manufacturing0/29 sales8/30 research/2

16、7 main4/28 branch0/28 manufacturing6/29 sales04/30 research窗体底端17窗体顶端Which physical connector type is used for a serial V.35 connection to the CSU/DSU?窗体底端18窗体顶端Refer to the exhibit. Which two facts can be determined about the topology? (Choose two.)Fo

17、ur collision domains are present.One logical network is represented.Two broadcast domains are present.Three networks are needed.Three logical address ranges are required.窗体底端19窗体顶端What are three characteristics of CSMA/CD? (Choose three.)It monitors the media for presence of a data signal.After dete

18、cting a collision, hosts can resume transmission after a random timer has expired.A jam signal is used to ensure that all hosts are aware that a collision has occurred.Devices can be configured with a higher transmission priority.Data is transmitted only when the data signal is present.It uses a tok

19、en system to avoid collisions.窗体底端20窗体顶端Refer to the exhibit. The serial interface of the router was configured with the use of the commands that are shown. The router cannot ping the router that is directly connected to interface serial 0/0/0. What should the network technician do to solve this pro

20、blem?Configure the description at interface serial 0/0/0.Configure an IP address on interface serial 0/0/0.Remove the no shutdown command at interface serial 0/0/0Reboot the router.窗体底端21窗体顶端Which OSI layer uses the header information to reassemble the data segments into streams?application layernet

21、work layerpresentation layersession layertransport layer窗体底端22窗体顶端Refer to the exhibit. The NAT functionality of the router is enabled to provide Internet access to the PC. However, the PC is still unable to access the Internet. Which IP address should be changed to to enable the PC to

22、 access the Internet?910154窗体底端23窗体顶端Refer to the exhibit. A technician uses the nslookup command on the PC and views the output that is displayed in the exhibit. What is the IP address of the primary domain name server used by the host?2192.168.

23、1.5900窗体底端24窗体顶端Which memory contents will change as a result of using the Router# erase startup-config command on a router?RAMROMflashNVRAM窗体底端25窗体顶端While configuring a router, a network technician wants to name the router. Which prompt should the technician see when entering

24、the hostname command?RouterRouter#Router(config)#Router(config-line)#窗体底端26窗体顶端Refer to the exhibit. The PC, the routing table of which is displayed, is configured correctly. To which network device or interface does the IP address 54 belong?PCswitchrouter interface fa0/0router interface

25、fa0/1窗体底端27窗体顶端Refer to the exhibit. A network administrator is troubleshooting a link that is down between Router1 and Router2. To correct the problem, which wire pairs need to be switched on one of the Ethernet cable ends?pair 1 and pair 2pair 1 and pair 3pair 2 and pair 3pair 2 and pair 4窗体底端28窗体

26、顶端Refer to the exhibit. A PC is connected to a network. Which action will verify that the PC can communicate with its default gateway?Use the ping command.Use the ipconfig command.Use the ipconfig/all command.Use the ping 54 command.窗体底端29窗体顶端Refer to the exhibit. Host B was powere

27、d off. What change will occur in the MAC table of the switch?The table will remain unaffected.The switch will remove the MAC address at Fa0/19.The switch will retain the MAC address until host B is powered on again.The switch will rebuild the MAC table by assigning the FFFF.FFFF.FFFF address to port

28、 Fa0/19.窗体底端30窗体顶端What information is contained in the header of Layer 3 to help data delivery?port numberdevice physical addressdestination host logical addressvirtual connection identifier窗体底端31窗体顶端A network technician is tasked with setting up a network for six users, but the users should be able

29、 to use their accounts to log on from any of the six computers. What type of network should be used?workgroupP2P applicationspeer-to-peer networkclient-server network窗体底端32窗体顶端Refer to the exhibit. A web browser is running on host PC1 with an IP address /24. A dynamic port number of 49152 i

30、s assigned to the browser. The browser sends a request for a web page to the web server with an IP address 54/24. Which statement is true?The session is established using TCP, and the socket number for the web server is 54: 80.The session is established using TCP, and the socke

31、t number for the web server is 54: 49152.The session is established using UDP, and the socket number for the web server is 54: 80.The session is established using UDP, and the socket number for the web server is 54: 49152.窗体底端33窗体顶端Refer to the exhibit. An administra

32、tor on PC1 wants to view some HTML code from a web page housed on the web server. Which client application will allow this request to be started?窗体底端34窗体顶端Refer to the exhibit. What is required on host A for a network technician to create the initial configuration on Router1?an FTP clienta Telnet cl

33、ienta terminal emulation programa web browser窗体底端35窗体顶端What are two characteristics of the data link layer? (Choose two.)It segments and reorders the data.It exchanges the frames between nodes.It defines the method by which network devices place data onto the media.It manages the transfer of data be

34、tween the processes that run on each host.It retrieves signals from the media and restores them to their bit representations.窗体底端36窗体顶端A network administrator wants to restrict access to the router privileged EXEC mode. Which password should the administrator use?enableauxconsoleVTY窗体底端37窗体顶端Which t

35、hree IPv4 addresses represent a broadcast for a subnet? (Choose three.)3 /2629 /2691 /261 /275 /2721 /27窗体底端38窗体顶端Refer to the exhibit. Host X is unable to communicate with host Y. Which command can be run at host X to determine which inter

36、mediary device is responsible for this failure?telnet ping ftp tracert 窗体底端39窗体顶端Refer to the exhibit. Which option shows the correct topology given the configuration of Router1?窗体底端40窗体顶端If an administrator wished to return a router to the default state,

37、 what additional step must be taken after issuing the command erase start-up config?Reload the device.Issue the command copy running-config start-up config.Perform a show running-config to verify that the file was removed.Enter the interface commands to allow the device to connect to the network.窗体底

38、端41窗体顶端By using the ipconfig command, a network administrator determines that a workstation has the address 8 with 29 bits set in the subnet mask. To what network does the workstation belong?642窗体底端42窗体顶端Which statement is true about router host

39、names?A hostname should be unique on each router.A router hostname cannot contain capital letters.A router hostname is configured in privileged executive mode.A router hostname must be created before any other configurations can be added to the device.窗体底端43窗体顶端A user types the enable command. What

40、task can be performed at the privileged EXEC mode?Configure the device.Configure individual interfaces.Configure individual terminal lines.Issue show and debug commands.窗体底端44窗体顶端Refer to the exhibit. Which logical topology describes the exhibited network?starringpoint-to-pointmulti-access窗体底端45窗体顶端

41、Refer to the exhibit. A user wants to access the Internet from the PC. A part of the running configuration of the router is shown. Which default gateway IP address should be configured at the PC to enable this access?4窗体底端46窗体顶端Which statement is true about th

42、e ICMP protocol?It is an application layer protocol.It is designed to make IP a reliable protocol.It is often filtered out of networks for security purposes.If a host does not respond to an ICMP echo request, the host is not functioning.窗体底端47窗体顶端Refer to the exhibit. At which OSI layer is serial interface 0/0/1 experiencing problems?Layer