图片灰度分析ImageJ

1、Western Blot图片灰度分析 -Image JThis method is the Gel Analysis method outlined in the ImageJdocumentation: Gel Analysis . You may prefer to use it instead of the methods outlined below. There will likely be very little difference in the results between the various methods1. Open your file.2. Go to Analy

2、ze>Gels>Gel Analyzer Options and click the boxes for Label With Percentages, Outline Lanes and InvertPeaks.3. Choose the Rectangular Selection tool. Draw a rectangle around your first lane. Encompass some area of the lane above and below the band of interest. Edit July 2009: Note that for a ge

3、l with the lanes oriented vertically as shown here (i.e. the visible bands are horizontal across the image), you want to make your bounding rectangle taller than it is wide. However, if you have the image rotated so that the lanes are running horizontally, you need to make your bounding rectangle at

4、 least twice as wide as it is tall, at which point Image-J will recognize that your lanes are horizontal and it will allow you to move the box up or down the image to enclose the neighboring lanes.4. Press the 1 button (or go to Analyze>Gels>Select First Lane). A new window will pop up with a

5、copy of your image and a label over your first rectangular selection.5. Use the arrow keys to move the rectangle over the next lane. Press 2 (or go to Analyze>Gels>Select Next Lane) to place a selection around the lane. Repeat this for each lane on the membrane, moving the box and pressing 2 t

6、o place the selection.6. When finished, press 3 (or go to Analyze>Gels>Plot Lanes), which pops up a new window with a profile plot of each lane.7. Now choose the Straight Line selection tool. At the base of each peak, draw a line from one side of the peak to the other. This encloses the area o

7、f the peak. The tails to either side of the peak are the background signal. Note that if you have many lanes, the later lanes will be hidden at the bottom of the profile plot. To see these lanes, press and hold the space bar, and use the mouse to drag the profile plot upwards.8. When each peak has b

8、een closed off at the base with the Straight Line tool, choose the Magic Wand (Wand tracing tool) from the tool palette.9. Using the spacebar and mouse, drag the profile plot back down until you are at the top peak. With the wand, click inside the peak. Repeat this for each peak as you go down the p

9、rofile plot.10. When each peak has been selected, go to Analyze>Gels>LabelPeaks. This labels each peak with its size expressed as a percentange of the total size of all the measured peaks. You can go to the Results window and choose Edit>Copy All to copy the results for placing in a spreads

10、heet.Note: If you accidentally click in the wrong place with the Magic Wand, the program still records that clicked area, and it will factor into the total area used to calculate the percentages. Obviously this would skew your results if you click in areas that aren't peaks. Therefore, if you sh

11、ould click in the wrong place, simply go to Analyze>Gels>LabelPeaks to plot the current results, which displays these incorrect values, but more importantly resets the counter for the Results window. If you now go back to the Profile Plot and click in the peaks with the Magic Wand, the Results window clears and starts over. When you'