贴片机Cm培训记录学习教案

1、会计学1贴片机贴片机Cm培训培训(pixn)记录记录第一页，共9页。1.Power OFF machine and drain out air supply.2.Remove Head cover to expose connectors and air lines.3. Disengage connectors and air line(s).5. Remove allen bolts (with special stopper) and pull out head assembly.Allen bolt with stopperHead assembly disengaged from m

2、achine.4. Remove camera connectors/ grease tubesDAIICHI JITSUGYO (Philippines), INC.第2页/共8页第二页，共9页。1. Remove Solenoid Valve screws.2. Remove the following allen screws.5. Remove the bearing.3. Remove set screw of nozzle holder.4. Push the spline shaft upwards while pulling on the top side of the hea

3、d unit. See spline shaft assembv.The spline shaft assemblyDAIICHI JITSUGYO (Philippines), INC.第3页/共8页第三页，共9页。1. Remove Solenoid Valve screws.2. Remove the following allen screws.3. Remove stopper screw to disengage spring while supporting body with a spanner.4. Pull down spline shaft with base and n

4、ozzle holder. 5. Pull down bearing (Take note of orientation)DAIICHI JITSUGYO (Philippines), INC.第4页/共8页第四页，共9页。1. After the removal spline shaft removal of theta motor and theta motor is accessible, standard belt direction should be followed.TOP SIDEBOTTOM SIDETENSION BELTTHETA MOTOR SHAFTDAIICHI J

5、ITSUGYO (Philippines), INC.第5页/共8页第五页，共9页。1. Remove connectors to give way to removal of LED unit.2. Remove top cover, then remove fixing screws of LED Unit.LED Unit disengaged from main Line Camera unit.Note: Camera board is a part of the whole camera unit3. Remove the allen screw to remove the who

6、le Line camera unit.4. During installation the Theta can be adjusted using the adjusting bolts found beneath the camera.DAIICHI JITSUGYO (Philippines), INC.第6页/共8页第六页，共9页。1. Remove connecting bolts and connectors attached (CCU & CCD are all in one) 2. During replacement maintain the distance X s

7、hown below.cameraBracket15.0mm (high speed)10.8 (multi speed)3. Focus can be adjusted by the aid of 50mm X 50mm jig.Width adjustment/ recog mainte/ For adjustLamp1: 30Lamp 2: 20-304. Perform PCB recog camera angle teach (tolerance: = 0.2) 5. Camera allignment can be adjusted using the fixed conveyor as reference and adjust . (Follow the diagram below for deviation adjustments)cameraFor (-) deviationFor (+) deviationDAIICHI JITSUGYO (Philippines), INC.第7页/共8页第七页，共9页。感谢您的观看感谢您的观看(gunkn)！