版权说明:本文档由用户提供并上传,收益归属内容提供方,若内容存在侵权,请进行举报或认领
文档简介
1、NEW MEXICAN REGULATIONS FOR LED LAMPS,MEXICAN STANDARD REGULATION NOM-030-ENER-2012,Objective: 目标: Establish the test methods to determinate if the led lamps saling in Mxico accomplish with the requirements to efficay and Power Energy consumption. 建立一套检测方法来确定在墨西哥销售的LED灯是否达到光效和功率消耗要求。,Application: Th
2、is NOM applies to any integrating LED lamp, directional or Ominidirectional which input voltage will be manage in the following range: 100-240 V and with a frequency of 50/60 Hz 应用: 这份NOM的标准适用于任何一种输入电压在100-240V,频率50/60HZ的有方向性的或者全方位发光的一体化LED灯。,CLASSIFICATION 分类,Led lamps in this NOM are divided as Di
3、rectional and Omnidirectional lamps. 在LED NOM 的标准中,LED 灯分为 有方向性的灯 和 全方位发光的灯。 Directional lmps: Any lamp should be considered in this category if the shape of the product is like any one to appear in the image below or similar. 有方向性的灯:任何与以下显示的产品外形一样或相似的灯都视为有方向性的灯。,CLASIFICATION 分类,Omnidirectional lam
4、ps: Any lamp should be considered in this category if the shape of the product is like any one to appear in the image below or similar. 全方位发光的灯:任何与以下显示的产品外形一样或相似的灯都视为全方位发光的灯。,Relevant points to consider Omnidirectional Lamps: 对全方位发光的灯的相关要求: 1.- Luminoux flux and Efficacy 1.-光通量和光效的要求: lamps integrat
5、ed Omni-directional bulb A, BT, P, PS and T-shaped 具有A,BT,P.PS,和T 外形的全方位发光的一体化LED灯的要求:,2.- Variation in the nominal total luminous flux. The measured initial total luminous flux of all Omni-directional integrated LED lamps should not be less than 90% of the nominal value marked on the product. 2.-标称
6、光通量的变化。所有全方位发光的一体化LED灯的初始光通量不得小于标称在产品上的光通量的90%。 Example: Lamp is declare with 800 lm, then the minimum value accepted during the test will be 720 lm that is equivalent to lose just a 10 % of the initial value. 例如: 产品宣称800lm,在测试中能接受的最小值是720lm,等同于在初始光通量中允许10%的光衰。,1.- Luminoux flux and Efficacy; Omni-d
7、irectional BA bulb-shaped LED lamps C, CA, F and G. 1.-光通量和光效的要求- 具有BA,C, CA, F, 和 G 外形的全方位发光的一体化LED灯的要求:,3.- Correlated color temperature (CBT) All Omni-directional integrated LED lights must comply with the CCT indicated in table, 3.-相关色温所有全方位发光的一体化LED灯必须符合以下表格的色温要求:,4.- Minimum total luminous flu
8、x maintained and correlated color temperature maintained. All Omni-directional integrated LED lights must comply with the total minimum luminous flux maintained established and the correlated color temperature the total luminous flux and initial correlated color temperature, and measured after a tri
9、al period equivalent to 25% of the declared of the lamp life, with a maximum of 6 000 h. 4.-最低光通维持率和相关色温的持续时间。所有全方位发光的一体化LED灯必须符合最低光通维持率和相关色温的要求。光通量和相关色温的测试是在产品上宣称寿命的25%这段时间测试的,测试时间最长6000小时。,5.- Color (IRC) performance index. All Omni-directional integrated LED lights must have a minimum 77 IRC. 5.-
10、 显色指数 所有全方位发光的一体化LED灯的显色指数必须达到最低77的要求。 6.-Power factor (PF). For all the LED lights integrated Omni-directional with less than or equal to 5 W electrical powers, it will not be necessary to specify the FP. For all the Omni-directional LED lights with electrical powers greater than 5 W, PF must be gr
11、eater than or equal to 0.7. 6.-功率因素 1)所有小于或等于5W的全方位发光的一体化LED灯,没有功率因素的要求。 2) 所有大于5W的全方位发光的一体化LED灯,功率因素必须大于或等于0.7.,Relevant points to consider Directional Lamps: 对LED方向性灯的相关要求: 1.- Luminoux flux and Efficacy 1.- 光通量和光效 Lamps integrated directional bulb AR111, BR, ER, TM, Pair and R-shaped 具有AR111,BR,
12、ER,MR,PAR 和 R外形的有方向性的一体化LED灯的要求:,2.- Variation in the nominal total luminous flux. The measured initial total luminous flux of all Directional integrated LED lamps should not be less than 90% of the nominal value marked on the product. 2.-标称光通量的变化。 所有具方向性的一体化LED 灯的初始光通量不得小于标称在产品上的光通量的90%。 Example: L
13、amp is declare with 80 lm, then the minimum value accepted during the test will be 72 lm that is equivalent to lose just a 10 % of the initial value. 例如:产品宣称80lm,在测试中能接受的最小值是72lm,等同于在初始光通量中允许10%的光衰。,3.- Correlated color temperature (CCT) All Directional integrated LED lights must comply with the CCT
14、 indicated in table, 3.相关色温所有具方向性的一体化LED灯必须符合以下表格的色温要求:,4.-Minimum total luminous flux maintained and correlated color temperature maintained. The total luminous flux and correlated color temperature initial and measured after a trial period equivalent to 25% of the declared useful life of lamp, wit
15、h a maximum of 6 000 h. 4.-最低光通维持率和相关色温的持续时间。光通量和相关色温的测试是在产品上宣称使用寿命的25%这段时间测试的,测试时间最长6000小时。,5.- Color (IRC) performance index. All Directional integrated LED lights must have a minimum 77 IRC. 5.- 显色指数所有具方向性的一体化LED灯的显色指数必须达到最低77的要求 6.- Power factor (PF). For all the LED lights integrated Directional with less than or equal to 5 W electrical powers, it will not be necessary to specify the FP. 6.-功率因素。 1)所有小于或等于5W的具方向性的一体化LED灯,没有功率因素的要求。 For all the LED light integrated directional with electrical powers greater than 5 Watts and less than or equal to 25 W FP mu
温馨提示
- 1. 本站所有资源如无特殊说明,都需要本地电脑安装OFFICE2007和PDF阅读器。图纸软件为CAD,CAXA,PROE,UG,SolidWorks等.压缩文件请下载最新的WinRAR软件解压。
- 2. 本站的文档不包含任何第三方提供的附件图纸等,如果需要附件,请联系上传者。文件的所有权益归上传用户所有。
- 3. 本站RAR压缩包中若带图纸,网页内容里面会有图纸预览,若没有图纸预览就没有图纸。
- 4. 未经权益所有人同意不得将文件中的内容挪作商业或盈利用途。
- 5. 人人文库网仅提供信息存储空间,仅对用户上传内容的表现方式做保护处理,对用户上传分享的文档内容本身不做任何修改或编辑,并不能对任何下载内容负责。
- 6. 下载文件中如有侵权或不适当内容,请与我们联系,我们立即纠正。
- 7. 本站不保证下载资源的准确性、安全性和完整性, 同时也不承担用户因使用这些下载资源对自己和他人造成任何形式的伤害或损失。
最新文档
- 施工组织方案的优化
- 红袖标综合项目工程实施专项方案
- 圆管柱加工制作设计组织基本工艺作业流程图
- 汽车修理店促销专项方案
- 精细化工配方实训总结报告及参观实习
- 轴流通风机安装综合项目施工基本工艺统一标准
- 大班其他教案:小红帽
- 大概念教学15讲读后感
- 小区突发疫情处置预案
- 实验活动中的应急预案
- 2024年《职业病防治法》宣传周答题活动竞赛考试题库300题(含答案)
- 2024年体育单招政治试题与答案-3
- 2021年国家义务教育质量监测模拟测试四年级心理健康
- 工厂供电课程设计某机械制造厂车间变电所及其低压配电系统设计
- 第十章 思想政治教育的环境 思想政治教育学原理 马工程
- 银行信贷业务基本操作流程 详解
- 膝关节AKS评分
- 洁净实验室项目监理规划
- 临时设施施工方案培训讲学
- 如何概括新闻的主要内容(整理版)
- GB∕T 38597-2020 低挥发性有机化合物含量涂料产品技术要求
评论
0/150
提交评论