ShimadzuConfigGriffin岛津仪器培训资料.ppt

You see any of these things happen?,Cant do injections, but no error shows up Injected fine the first few days, then stopped Shimadzu controller gets a red light, but no error Random parts of the stack dont work. Nothing shows up in Analyst, yet MS wont start acquiring.,There is an easy way to fix this if the Shimadzu is the cause,Internet Explorer A Network Cable Duct Tape Pocket Knife A Tube sock,Actually, just the cable and IE are important,Default IP address is 192.168.200.99 Type that into IE to get to this screen,Click on System Name to access this screen. Default user ID is “admin” and password is “Admin”,Click here,This screen allows you control over all attached Shimadzu units.We only care about the System Controller,Check the “configuration” tab under the Shimadzu software and make sure nothing is checked. If it is, check it off. Once its checked off go back to the “analysis” tab.,After clicking on “system controller” this screen will appear. We only care about the “configuration” button,Locate the “Communication Mode” under the “Data Processing System Setting” LCsolutions = bad for us.,Bad LCsolutions,Here we see all the options from the pull down menu. “Class VP” is our target.,Target locked.,Mission Accomplished. The crowd is cheering your vanquishing of random glitches and lockups,WOO HOO!,What to do if the customer is on RS-232?,Install network cable between controller and computer Check internet connection properties of network card Run Shimadzu software as shown in previous slides,Network connections is accessed via “control panel. If there is a second network card make sure you are on the correct one”,Right click to get to properties,Highlight TCP/IP and click properties afterwards,Click 1st,Click 2nd,Change the setting to “use the following IP address”. For “IP address” use 192.168.200.100 and for the Subnet mask use 255.255.255.0 MAKE SURE YOU DONT ERASE ANY ADDRESSE