电解电容规格书.doc

样 品 承 认 书SPECIFICATION FOR APPROVAL 客 户: (Customer)品 名: 铝电解电容器(Product Name) 型 号： (Series） 日 期： 2010年 月 日 （Date） 贵公司承认： Approval Signature批 准 : 审 核:制作:Approved Checked Prepared电容器有限公司CAPACITOR CO.,LTD.地址: 电话 传真(FAX)邮编(P.C.): 网址(Internet):Parts lists物料清单:Customers Part No.客户代码Leaguers Part No.LeaguerSeriesSize(mm)DLW.V(V)Cap.(F)Cap.Tol.(%)tan损耗Iu(uA)漏电流Ripple Current纹波电流(mA)RT181225220200.1455150RT1132116330200.1652.8302RT11321252200200.14550725 RT1 Series Type (系列)(105,1000H) Electrical Requirements电解电容器规格书:1Capacitance Tolerance容量偏差20% at 120Hz,202Operation TemperatureRange工作温度6.3V100V-40+105160V400V-25+1053Rated Working VoltageAnd Surge Voltage 额定电压与浪涌电压W.V.6.3101625355063100160200250350400S.V.7.311.518.4294058731151842302874004604Leakage Current漏电流After DC Voltage is applied to capacitor through the series protective resistance(1K),and then terminal voltage may reach the rated working voltage. The leakage current when measured after 2 minutes (6.3-400V)shall be below the value of the following equation.串联(1K)保护电阻后，对产品施加额定直流工作电压(6.3400V)两分钟后，漏电流值不大于下列规定值。6.3100VI0.01CV or 3A(取较大值)Whichever is greater160400VI0.03CV +10(A)Where I=Leakage Current(A) C=Capacitance(F) V=Rated DC Working Voltage(V)5Dissipation Factor损耗角正切值(at 120Hz,20)RatedVoltage6.3101625355063100160200250300400450Tan(max)0.240.200.160.140.120.100.090.080.120.120.150.150.230.23标称容量大于1000F时，每增加1000F，损耗角正切值增加0.02。Endurance characteristic特性检测:NoItem测试项目Conditions测试条件Specification特性要求1RotationalTemperatureTest温度快速变化Capacitor is place in an oven whose temperatures follow specific regulation to change. The specific regulation is “+20(3 min)-40(30 min)+20(3 min)+105(30 min)+20(3 min)”,and it is called a cycle. The test totals 5 cycles. And then the capacitor shall be subjected to standard atmospheric Conditions for 16 hours, after which measurement shall be made.电容器在规定的温度范围内循环如下：“+20(3 min)-40(30 min) +20(3 min)+105(30 min)+20(3 min)”，以上循环运行5次后,将电容器放置于标准气候中恢复16小时测量其值满足特性要求。Physical外观No broken and undamaged无可见损伤及泄漏2HighTemperatureLoad Life Test耐久性Capacitors shall be placed in oven with application of ripple current and rated voltage for 1000hrs at 105.在 105条件下，对电容器施加带有额定纹波电流的额定工作电压1000小时后，在标准气候下恢复16小时测量。CapacitanceChange容量变化Within20% of the initial value初始值的20%以内TAN损耗角正切Less than 200% of specified value不大于规定值的200%Leakage Current漏电流Within specified value不大于规定值Physical外观No broken and undamaged无可见损伤及泄漏3HighTemperatureUnload Life Test高温储存特性After 500 hrs test at 105 without rated working voltage. And then the capacitor shall be subjected to standard atmospheric conditions for 16 hours, after which measurements shall be made.将电容器无负载放置于105条件，500小时后取出，放置于标准气候下恢复16小时测量.CapacitanceChange容量变化Within20% of the initial value初始值的20%以内TAN损耗角正切Lessthan200% of specified value不大于规定值的200%Leakage Current漏电流Less than 200% of specified value不大于规定值的200%Physical外观No broken and undamaged无可见损伤及泄漏4Humidity Test稳态湿热Capacitors shall be exposed for 5006 hrs in an atmosphere of 9095% R.H. at 40. And then the capacitor shall be subjected to standard atmospheric conditions for 16 hours, after which measurements shall be made.电容器放置于湿度9095% R.H.，温度40的大气中5006小时.取出后在标准气候下恢复16小时测量.CapacitanceChange容量变化Within10% of the initial value初始值的10%以内TAN损耗角正切Lessthan200% of specified value不大于规定值的200%Leakage Current漏电流Within specified value不大于规定值Physical外观No broken and undamaged无可见损伤及泄漏5Vibration Test振动测试1.Fix it at the point 4mm or less form body. For ones of 12.5mm or more in diameter or 25mm or more length, use separate fixture.2.Direction and during of vibration: 3 orthogonal directions Mutually each for 2hrs total 6hrs.3.Frequency:10to 55Hz reciprocation for1 min. 4. Total amplitude: 0.75mm.1.安装点距产品4mm以上。2.在三个互相垂直轴的每一方向各振动2小时，共6小时。3.频率:10到55Hz 每分钟互换。4.振幅: 0.75mm.CapacitanceChange容量变化Within10% of the initial value初始值的10%以内TAN损耗角正切Within specified value不大于规定值Leakage Current漏电流Within specified value不大于规定值Physical外观No broken and undamaged无可见损伤及泄漏6SolderHeat-Resistance Test耐焊接热The section of lead below 4mm form the body of capacitor must be immersed in 2605 liquid tin 101 seconds. Then. after removing the following specifications shall be satisfied when capacitor terminal is restored to 20 within two hours or over an hour.距电容器本体4mm以下浸入 2605 的液体中101 秒. 取出后放入标准气候下恢复12小时测量。CapacitanceChange容量变化Within5% of the initial value初始值的5%以内Physical外观No broken and undamaged无可见损伤及泄漏7Surge Voltage Test浪涌电压 After surge voltage applied at a cycling rate of 30 seconds charge and 5.5 minutes discharge 1000 successive test cycle.加1.15倍额定电压充电30秒后放电5分30秒，连续循环1000次后测量。 CapacitanceChange容量变化Within15% of the initial value初始值的15%以内TAN损耗角正切Within specified value不大于规定值Leakage Current漏电流Within specified value不大于规定值Physical外观No broken and undamaged无可见损伤及泄漏8Solderability Test可焊性 After the lead wire fully immersed in the solder for 20.1secs at a temperature of 2352,the solder coating must be more than 95%引线浸入2352的焊料中，持续 20.1秒，拔出后引线表面被焊料覆盖的面积不少于浸入面积的95%。9MechanicalCharacteristicsTest引出端的强度1.The test is about lead tabs strength.1.本测试主要测试引出端的强度.2.Tension Test: The lead tabs shall not be broken or any malformed condition after fixing capacitor vertically and pressing the following weight on the lead tabs of capacitor for 101 secs.2.拉力测试：垂直固定电容器后，在引出端施加以下重量101秒钟，引出端不允许出现任何损伤和变形。Lead tabs diameter引出端直径(mm)Weight重量(Kg)0.50.50.6、0.80.83.Bending Test: The capacitor is held in vertical position. Attach a weight to the lead tabs, slowly rotate the capacitor 90 to a same way in the opposite direction. Repeat it again(5secs per cycle). The lead tabs shall not be broken or cracked. 3.弯曲测试:竖直放置电容器，在其引出端悬挂下表重量的重物，转动电容器90度，恢复后，向相反方向转动90度，再恢复为一个周期，重复1次(每个循环5秒钟)。引线不会损伤破损。Lead tabs diameter引出端直径(mm)Weight重量(Kg)0.50.50.6、0.80.810 Standards引用标准 Satisfies Characteristic of GB2693，IEC383、IEC384 11.Diagram of Dimensions尺寸图: (mm)D0.51.056or6.3810131619F0.52.02.53.55.05.07.57.5L2.0(max)11111213,16,2020,2525,3135,40d0.050.50.50.5or0.60.60.812. Case Size and Ripple Current尺寸和纹波电流DL(mm) wvmAF6.3( 0J )10( 1A )16( 1C )25( 1E )35( 1V )50( 1H )63( 1J )DLmADLmADLmADLmADLmADLmADLmA0.1 ( 0R1)51130.22 ( R22)51140.33 ( R33)51150.47 ( R47)51161.0 ( 010)51192.2 ( 2R2)511113.3 ( 3R3)511154.7 ( 4R7)511185112010 (100)511205112551125511255113022 (220)511305113551135511406.3115033 (330)5114051140511506.311608126047 (470)5114551150511506.311656.3117381290100 (101)51160511806.311806.311908121108121201012150220 (221)6.3111006.311110812140812150101319010162401020270330 (331)81212081216013213021013220101626010203201320380470 (471)812170812190101325010162901020350132043013255001000 (102)10133001016360102044013205401325620162579016319002200 (222)13205801320620132570013217251631103019351230194013103300 (332)1320670132580016259701631112019351320194014004700 (472)162510001625105016311240193514406800 (682)1625112016311300193515301940163010000 (103)193513201935162019401730DL(mm) wvmAF100( 2A )160( 2C )200( 2D )250( 2E )350( 2V )400( 2G )450(2W)DLmADLmADLmADLmADLmADLmADLmA0.47 ( R47)51165118812681261.0