德国伏科控制器 Phocos英文版本.doc

YANTAI SHANYOU ELECTRIC CO., LTDContact : Mr. Abner Xin TEL: +86-535-6398539 FAX: +86-535-6393592MSN: Email : MPPT 100/30Maximum Power Point Tracker Maximum Power Point Tracking Technology increases the efficiency of your PV system Less expensive solar-panels for grid-feed-in systems can now be used for 12/24V off-grid systems Electronic protection (reverse polarity, over-current, short-circuit, over-temperature) High efficiency DIN Rail compatible Negative grounding With innovative maximum-power-tracking technology, Phocos MPP-Tracker ensures maximum performance from your solar array at all times and in all weather conditions. The MPPT can yield an energy gain of up to 30% from your PV array (with the average gain being 10%-25%).When a Central Unit is used, up to 16 MPPTs can be used together in one system. The charge regulation is then done via data bus by the Central Unit. This will enable you to increase your system capacity substantially.The temperature-compensated three-stage I-U curve charge regulation alogarithm significantly extends the lifespan of your battery.The possibility to use less expensive grid-feed-in solar-panels with up to 95V open circuit voltage for 12V or 24V stand-alone systems will significantly reduce the cost of the total system.TYPEMPPT 100/30Nominal Voltage12V/24V,automatic recognitionNominal battery charge current30AMax. Solar Input Voltage Voc95VMax. PV Input Power450W12V, 900W24V Max. Battery Charge Current33A Power Conversion Efficiencyover 98 %Standby Power Consumption 30mW at 12V system voltage ( 2mA) 80mW at 24V system voltage ( 3mA)Temperature compensation-4 mV/cell*KMax. wire size32mm2Dimensions185 x 150 x 115mm Weight1.6kg Temperature range-40 to +50 CType of protection IP22 CX10, CX20, CX40Solar Charge Controller with LCD Display Battery State-of-Charge display LCD Charge and discharge status display Acoustic load disconnect pre-warning Load status indication Choose between 5 load disconnect algorithms boost/absorption/float PWM-regulation (series type) Integrated temperature compensation Covered terminals(up to 16mm2 wire size) Full solid-state protection The CX series is a sophisticated solar charge controller family with exceptional features for its price range. Beside a perfect PWM regulation with integrated temperature compensation the controllers provide extraordinary display, programming and safety functions. The battery state of charge is clearly displayed with a bar chart, as well as energy flows from and to the battery and the load status (e.g. overload, load short circuit). The deep discharge protection function can be set up to three different modes: voltage controlled, SOC controlled or adaptive (fuzzy logic).Acoustic warnings are built in, and also a programmable nightlight function.As an accessory we can provide an Excess Energy Management output to control special Phocos appliances like the SF solar refrigerators/coolers.The compact case design is prepared for DIN rail mounting (mounting device available as an accessory). TYPECX10CX20CX40Charge current max.10A20A40ALoad current max.10A20A40ASystem voltage12/24V12/24V12/24VSelf power consumption4mA4mA4mADimensions89x90x39mm89x90x39mm89x90x39mmType of protectionIP22IP22IP22CML05, CML08, CML10, CML15, CML20Solar Charge Controllers Battery State-of-Charge display with 3 LEDs Acoustic load disconnect pre-warning PWM-regulation (series type) Boost, Equalize and Float charging, also for VRLA Automatic 12/24 Volt detection Integrated temperature compensation Large terminals (up to 16mm2 wire size) SOC and voltage controlled LVD Fully electronically protected The CML series is a sophisticated solar charge controller family for low-cost applications. The electronic circuit is equipped with a microcontroller that provides high-efficiency charging technology together with a number of outstanding status display, warning and safety functions. The temperature-compensated three-stage PWM charging method (boost-equalization-float) is now adjustable to sealed and vented lead-acid batteries. The new version also allows an either SOC or voltage controlled low voltage disconnect function. The battery status is clearly indicated by three LEDs. As the first controller on the market in this price range it comes with an acoustic low voltage load disconnect pre-warning feature. TYPECML05CML08CML10CML15CML20Max. module current5A8A10A15A20AMax. load current 5A8A10A15A20ASystem voltage 12/24VSelf power consumption 4mADimensions80 x 100 x 32 mmType of protection IP22CML05NL, CML08NL, CML10NL, CML15NL, CML20NLCharge Controller with Nightlight Function One programmable nightlight function PWM regulation (series type) Integrated temperature compensation Three-state charging method SOC and voltage controlled LVD Solid-state circuit and load protection Reverse polarity protection Fully electronically protected The CMLNL series is a sophisticated solar charge controller family for low cost applications.The electronic circuit is equipped with a microcontroller that provides high-efficiency charging technology together with a number of outstanding status display, warning and safety functions. The CMLNL series comes with two nightlight function mode. One of them is programmable that switch on the load output for a adjustable number of hours from dusk.The nightlight function is overridden by a battery deep discharge protection to avoid excessive discharge and damage of the battery.The temperature-compensated three-state PWM charging method (boost-equalize-float) is now adjustable to sealed and vented lead-acid batteries.The low voltage disconnect function can be controlled either by SOC or by voltage.The battery status, charging status and load status are clearly indicated by 5 LEDs.TYPECML05NLCML08NLCML10NLCML15NLCML20NLNominal voltage12/24V automatic recognitionMax. solar panel current5A8A10A15A20AMax. load panel current 5A8A10A15A20ABoost voltage 14.5V / 29.0V 25CEqualization voltage14.8V / 29.6V 25CLow voltage disconnect function11.4-11.9V /22.8-23.8V controlled by state of charge 11.0/22.0V controlled by voltageLoad reconnect voltage12.8 / 25.6VTemperature compensation-4mV / cell*KSelf consumption4mAMax. wire size16mm2 (AWG#6)Dimensions80 x 100 x 32 mmWeight180grTemperature range-20 to +50 CType of protectionIP22SPS High-end Solar Regulation System 12,24 and 48V versions available RS232/485 data interface Fully programmable Designed for Telecom applications Ultra low noise emissions due to bank switching design Almost any accessory feature possible The SPS series Solar Regulation System is an advanced electronic control unit for solar power supplies in remote locations. It will prevent overcharging, reduce electrolyte loss and stop over discharge. This will extend battery life and reduce maintenance. State of the art technology has been combined with simple modular construction to create a system with better performance and more features than any other controller in its class. All control levels are fully adjustable and can be changed by remote control. They are flexible in use, easy to service and are powering telecommunications in some of the most remote parts of the world.TYPESPS12D100,200,300SPS24D100,200,300 SPS48D100,200,300 Voltage12V24V 48V Charge Current 100A, 200A, 300A100A, 200A, 300A100A, 200A, 300ALoad Crrrent 50A 50A 50A PL SERIES PL20, PL40, PL60Energy System Controllers 12V, 24V, 32V, 36V and 48V in one controller Built-in 30 days data logger Multifunctional LCD Display External current sensing (optional) RS232 interface (optional) Hybrid system control Widely programmable Built-in programmable logic The PL series controllers offer complete control over the charge cycle and gives information about current and past performance. PL regulators have a built-in low battery disconnect switch. In addition, the versatile event controller can switch power on or off according to criteria set by the user. This allows the PL to do extra tasks such as switching a light on at night or keeping a water tank full by operating a pump when needed. Regulation can be done in slow speed switching and PWM in both series and shunt modes. Other features include backup generator control and charging a second battery. Display shows battery voltage, cha