电脑针车XY原点设置(针秆原点).pdf

10 01 LOAD CLEARANCE 間間隔隔 1 Fig 1 ON OFF Turn the power on by pressing ON OFF and 擊 ON OFF 鍵 鍵 開 2 Fig 1 2 3 Press 2 3 times 擊2 3 鍵 Fig 2 Fig 1 3 Fig 2 Check if the needle comes to the center of the cutter hole of the needle plate 机孔 Fig 3 4 Fig 3 6EA If the needle is not in the center turn the power off loosen the screw 6EA and disassemble the top cover 果 關 開固 6EA 開 盖 1 1 X X origin Setting Needle Bar Origin X 杆 M 12 SPS B BH3000 Fig 4 Fig 1 1 Fig 1 READY 1 Turn the power on Press the pedal Push READY Press the pedal by 1 step 開 擊 擊READY鍵 擊1 Fig 2 2 Fig 2 2mm Check if a clearance between the end tip of the presser foot and the hole of the needle plate in 2mm 脚 孔間距 2mm Fig 3 3 Fig 3 Y 2EA Lay down the sewing machine towards the left hinge direction and loosen the screw 2EA of the feed sensor support 沽桔 机 開Y 感器 架固 2EA 4 Fig 3 Y 2EA Fine tune feed sensor support left and right and close the screw 2EA Left more clearance Right less clearance Y 感器 架 固 2EA 間隔 間隔 5 Fig 4 READY 1 2mm Turn the power on Press the pedal Push READY Press the pedal by 1 step Check if a clearance between the end tip of the presser foot and the hole of the needle plate in 2mm 開 擊 擊READY鍵 擊1 脚 孔 2mm 6 3 5 Accurately set as described in 3 5 3 5 1 2 Y Y origin Setting Y 2mm M Maintenance Book11 01 LOAD CLEARANCE 間隔 Fig 4 5 Fig 4 Loosen the screw of the needle bar zigzag lever R and manually adjust the needle to be located in the center of the cutter hole Fix the screw afterwards 開 杆鋸 杆 固 孔 汽緊固 Fig 5 6 Fig 1 ON OFF 2 3 Turn the power on by pressing ON OFF and Press 2 3 times 擊 ON OFF 鍵 鍵 開 擊2 3 鍵 7 Fig 5 When the needle comes to the center of the needle plate tightly turn the s