三台路由器 静态路由 超详细.doc

BY 小福仔更多教程 欢迎光临小福仔百度博客 /492311578设置静态路由命令注意：在设置缺省路由的时候需要考虑，路由回环的问题。路由间链接要设置时钟频率为64000静态路由里的下一跳 是出去路由后的第一个IP地址。静态配置命令全局模式Ip route 目标网络 目标网络子网掩码 下一跳IP地址R4 配置r4(config)#int s0/0r4(config-if)#no shutdown%LINK-5-CHANGED: Interface Serial0/0, changed state to downr4(config-if)#ip address r4(config)#int s0/1r4(config-if)#ip address 配置静态路由r4(config)#ip route r4(config)#ip route 设置时钟频率（有时钟端）r4(config)#int s0/1r4(config-if)#clock rate 64000R5 设置r5(config)#int s0/0r5(config-if)#no shutdown%LINK-5-CHANGED: Interface Serial0/0, changed state to downr5(config-if)#ip address r5(config)#int f0/1r5(config-if)#ip address 配置静态路由r5(config)#ip route r5(config)#ip route 设置时钟频率（有时钟端）r5(config)#int s0/1r5(config-if)#clock rate 64000R6设置r6(config)#int s0/0r6(config-if)#no shutdown%LINK-5-CHANGED: Interface Serial0/0, changed state to downr6(config-if)#ip address r6(config)#int f0/1r6(config-if)#ip address 配置静态路由r6(config)#ip route r6(config)#ip route 设置时钟频率（有时钟端）r6(config)#int s0/1r6(config-if)#clock rate 64000R4 查看路由表命令特权模式下 show ip route路由表Gateway of last resort is not set /24 is subnetted, 2 subnetsC is directly connected, Serial0/0C is directly connected, Serial0/1S /24 1/0 via S /24 1/0 via R5 路由表C is directly connected, Serial0/0S 1/0 via S /24 1/0 via C /24 is directly connected, FastEthernet0/0R6 路由表S 1/0 via C is directly connected, Serial0/1C /24 is directly connected, FastEthernet0/0S /24 1/0 via 测试PC1PC0PCping Pinging with 32 bytes of data:Reply from : bytes=32 time=60ms TTL=253Reply from : bytes=32 time=93ms TTL=253Reply from : bytes=32 time=50ms TTL=253Reply from : bytes=32 time=60ms TTL=253Ping statistics for : Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),Approximate round trip times in milli-seconds:Minimum = 50ms, Maximum = 93ms, Average = 65msPC0PC1PCping Pinging with 32 bytes of data:Request timed out.Reply from : bytes=32 time=80ms TTL=125Reply from : bytes=32 time=80ms TTL=125Reply from : bytes=32 time=80ms TTL=125Ping statistics for : Packets: Sent = 4, Received = 3, Lost = 1 (25% loss),A