SAM-IP-Address_ndern__Ethernet_engl.doc

Change SAM IP address after battery lowusing the network connectionE-KonstruktionChange SAM IP address1. When the HMI has no connection to the SAM with INCO error 0X10012, the cause can be the SAM losing the IP address settings due to the memory battery being low.2. The IP address is then reset to the value 0.0.0.1 3. To be able to change the address we first need to be able to communicate with the SAM by setting the PC network to this range.Press4. Call the network settings under Start | Settings | Network Connections | SAM-LAN which will display the following dialog screen:Select Internet Protocol (TCP/IP)then the button Properties5. Then press the Properties button and in the area This connection uses the following items select Internet Protocol (TCP/IP) and press again the button Properties as shown below: Press6. In the next dialog screen press the Advanced button which will display the dialog screen below and press on the Add. button of the IP addresses which shows the TCP/IP Address setting Set to 2.2.2.5and press Add7. As Windows does not allow an IP Address with a value of 0 we need to place an entry (eg. 2.2.2.5) which we can then manipulate in the registry database. Close all network screensIPAddress partial from 2.2.2.5 to 0.0.0.58. Call the registry database using Start | Run give in regedit and press Ok then go to entry HKEY_LOCAL_MACHINESYSTEMControlSetServicesTcpipParametersInterfacesxxxwhere xxx is the interface which has the IPAddress partial value 2.2.2.5 as shown below:Change this value9. Edit the IPAddress partial value from 2.2.2.5 to 0.0.0.5 as shown below:Disable then Enable again10. For the new address to be active the network needs to be disabled and then enabled again. This is done in Start | Settings | Control Panel | Network connections | Select the SAM-Lan with the right mouse button select Disable then straight away back to Enable as below:11. Call the INCO registry in Start | Programs | Indel Master Desk | INCO Registry and change the setting for the machine from the SAM address (usually 192.168.2.2) to 0.0.0.1 Set TargetAddress to 0.0.0.112. Now the SAM IP address can be changed back (usually 192.168.2.2) using the INCO Explorer.For the SAM to take over the IP address call the Indel Master Desk load the project and select Target | Reset Target (it is not necessary to switch the SAM off and back on)13. In the network settings as explained in point 4 remove the entry 0.0.0.514. Change the IP address in the INCO-Registry back to the original address (usually 192.168.2.2) as described in point 1015. Start the HMI and load the System parameters and a Preselection Type before