注塑机常用英语.doc

常用注塑术语中英文对照表注塑参数Injection parameter注射量Injection rate计量行程Screw back position余料量Cushion防诞量Sucking back rate螺杆转速Screw speed塑化量Plastic rate预塑背压Screw back pressure注射压力Injection pressure保压压力holding pressure/packing pressure注射速度Injection speed/velocity合模参数Clamping parameter合模力Clamping force合模速度Clamping speed/velocity合模行程Clamping stroke开模力Opening force开模速度Opening speed/velocity开模行程Opening position顶出压力Ejector advance pressure顶出速度Ejector advance speed/velocity顶出行程Ejector advance position温控参数Temperature parameter烘料温度Dry resin material temperature料筒Cylinder temperature喷嘴温度nozzle temperature模具温度Mold temperature油温Oil temperature成型周期Molding cycle循环周期Cycle time冷却时间Cool time注射时间Injection time保压时间Holding pressure time塑化时间Plant time顶出Knocking out time停留时间delay time低压保护时间Mold protect time注塑英语大全 成型工艺流程及条件介绍Molding technique procedure and parameter introduction 第一节 成型工艺Section 1 molding technique. 1.成型工艺参数类型Sorts of molding parameter. (1).注塑参数ction parameter. a.注射量ction rate. b.计量行程Screw back position c.余料量Cushion d.防诞量Sucking back rate e.螺杆转速Screw speed f.塑化量Plastic0 rate g.预塑背压Screw back pressure h.注射压力和保压压力ction pressure and holding pressure i.注射速度ction speed (2)合模参数Clamping parameter a.合模力 Clamping force b.合模速度Clamping speed c.合模行程.Clamping stroke d.开模力Opening force e.开模速度Opening speed f.开模行程Opening position g.顶出压力Ejector advance pressure h.顶出速度Ejector advance speed i.顶出行程Ejector advance position 2.温控参数Temperature parameter a.烘料温度Dry resin material temperature b.料向与喷嘴温度Cylinder temperature and nozzle temperature c.模具温度Mold temperature d.油温Oil temperature 3.成型周期Molding cycle a.循环周期Cycle time b.冷却时间Cool time c.注射时间ction time d.保压时间Holding pressure time e.塑化时间Plant timf.顶出及停留时间Knocking out and delay time g.低压保护时间Mold protect time成型工艺参数的设定须根据产品的不同设置. Molding technique parameter setting differs depending on type of product 第二节成型条件设定 Section 2 Molding parameter Setting 按成型步骤:可分为开锁模,加热,射出,顶出四个过程.Molding steps: mold opening/closing, heating ction and knocking out. 开锁模条件: Mold opening parameter: 快速段中速度 High-speedmid-speed 低压高压速度 Low pressure high pressure speed 锁模条件设