doc-官网资料Windchill相关资料-1

replicated objects as change task resulting objects最佳做法wind chill development best practicesname : replicated objects as change task resulting objects变更历史3360日期AuthorDescription4/25/2013鲍勃拉什Initial version。1.最佳做法name and classification1.1 Namereplicated objects as change task resulting objects1.2 Classifications低级别replication，customization。2.Objective2.1 Problem Statementadd a replicated object as resulting object of a change task，and optionally assign it an effectivity value。2.2 Backgroundthe term“replicated object”defines a non-modifiable object that is copied，or replicated，From a different wind chill installatedunder normal circumstances a replicated object could not be added as a resulting object to a change task because the change process would not be able t OIt is required in some circumstance，however，to be able to add a replicated object that has already been released to a change task(e . git may also be required to add an effectivity value to the replicated object when it is used a resulting object。2.3 scope/applicability/assumptionsthis document assumes familiarity with creating change tasks，adding resulting objects，and assigning effectivity values。2.4 Intended Outcomea resulting object is added to a change task as a resulting object . in the example below，Pump is a replicated object that is added to the engine changedFurther，a serial effectivity has been added pump。to implement the change pump is added to the engine structure。when the change notice is completed the engine is advanced to a released state。the pump，which was already in a released state，is not changed。3.Solution3.1 Solution Statementcustomize wind chill to allow replicated objects as change task resulting objects，and prevent the change process from attempting to promote resulting objects3.2 Prerequisite知识文库To apply this best practice，you need to have an understanding of the following :Setting a system property创建自定义生命周期模板creating an import life cycle mapping4.Customization Pointsthe customization steps in this section should be completed prior to importing replicated objects that are to be used as change task resulting objectsif they are completed after the import is complete then you can use the reassign life cycles action to reassign the life cycle template of a reassign4.1 replicated resulting objects的系统属性设置a system property allows a replicated object to be added as a change task resulting object .Perform the following steps:a)添加the following line to $ wt _ home/site . xconf 3360b)run this command in a wind chil shell : xconfmanagerpfC) Restart the method server(s)。4.2为replicated objects创建自定义生命周期模板the out of the box(OOTB)Wind chill change notice workflow includes a step to promote resulting objects to a released state。this should not be attempted for replicated objects howebber，Because their life cycle state is controlled by a different wind chill installation。to prevent this you can create special life cycle templates for re Plica ted objects that do not include change transitions from non-released to releareasedthe only change transition such templates should include is from the released state back to itself .For example，the ootb basic workflow includes these change transitions :1.In Work Released2.Released Releasedreplicated objects that use the basic life cycle template should not include transition in work released ，so a new template that does notPerform the following steps:a)Open the life cycle template administration utility and use the save as action to make a copy of an existing template that you want tob)edit the copied template and remove all change transitions from non-released to released States，and keep only a change transition from ttransitionfor example :c)save and check in the custom life cycle template。d)repeat this process for all life cycle templates that will be used for replicated objects。4.3为replicated object life cycles创建import mappingswhen replicated objects are imported they are normaly assigned to the life cycle template that is specified in the exported zip file . in this casethis is accompressed by creating life cycle import mappings prior to importing the objects。Perform the following steps:a)open the mapping management utility an