自动串焊机资料

1、clsolar原创1. Basic check points1-3 : Tab holding pins Upper pins (single / double) Angle adjustment of pins Measure the height of pin holders (A and B in the drawing below) for both sides and unscrew the fixing bolt for cylinder for pins movement to adjust the angle. Adjustment of vertical positionin

2、g of pins (to press the tabs)Find out the distance C in the drawing by measuring the positions at lifted and lowered positions.Then, loosen fixing bolt for cylinder for pins movment and adjust positioning.NPC IncorporatedPositioning and straightness of the pins Check if the pins point exactly the mi

3、ddle of busbar. See also if the pins are pressing the middle of a tab transferred. For adjustment, loosen the bolt on the upper part of the fixing bracket of the cylinder for pin-operation.PDF 文件使用 "pdfFactory Pro" 试用版本创建 炣clsolar原创 : Bottom holding pins (double pins)NPC Incorporated Highe

4、st position of the bottom holding pins is approx. 1mm from the surface of the welding table. (fig. A) Place a cell on the welding table and adjust to keep it contacted to the table when upper and lower pins hold it. Adjust the pin heads to the center of the holes in the welding table. (fig. B) PDF 文件使用 "pdfFactory Pro" 试用版本创建 炣clsolar原创Tools needed : hexagon wrench, open head wrench, 1