Aruba2400移动控制器基本操作-v

1、.Aruba 交换机基本操作命令登录：(Aruba2400)User: adminPassword: * （缺省口令通常是admin）NOTICENOTICE - This switch has active licenses that will expire in 26 daysNOTICENOTICE - See 'show license' for details.NOTICE(Aruba2400) >enPassword:* （缺省口令通常是admin）(Aruba2400) #恢复出厂值：(Aruba2400) #write eraseAll the confi

2、guration will be deleted. Press 'y' to proceed :Write Erase successful(Aruba2400) #reloadDo you really want to reset the system(y/n): yAruba交换机重启初始化配置：Enter System name Aruba2400: Enter VLAN 1 interface IP address 54: Enter VLAN 1 interface subnet mask : Enter IP Defau

3、lt gateway none: Enter Switch Role, (master|local) master: Enter Country code (ISO-3166), <ctrl-I> for supported list: CNYou have chosen Country code CN for China (yes|no)?: yEnter Password for admin login (up to 32 chars): *Re-type Password for admin login: *Enter Password for enable mode (up

4、 to 15 chars): *Re-type Password for enable mode: *Do you wish to shutdown all the ports (yes|no)? no: Current choices are:System name: Aruba2400VLAN 1 interface IP address: 54VLAN 1 interface subnet mask: IP Default gateway: noneSwitch Role: masterCountry code: CNPorts shutdo

5、wn: noIf you accept the changes the switch will restart!Type <ctrl-P> to go back and change answer for any questionDo you wish to accept the changes (yes|no)yCreating configuration. Done.保存配置文件：(Aruba2400) >enPassword:*(Aruba2400) #configure t(Aruba2400) # copy running-config tftp: 192.168.

6、4.100 aruba2400-0904.cfg恢复配置文件：(Aruba2400) >enPassword:*(Aruba2400) #configure t(Aruba2400) (config) #copy tftp: 00 aruba2400-0904.cfg flash: 2400.bak(Aruba2400) (config) #copy flash: 2400.bak flash: 2400.cfg(Aruba2400) (config) #boot config-file 2400.cfg(Aruba2400) (config) #reloadDo y

7、ou really want to reset the system(y/n): ySystem will now restart!Image 升级：(Aruba200) #show bootConfig File: default.cfgBoot Partition: PARTITION 0(Aruba2400) #show image version(Aruba2400) #copy tftp: 0 A2400_FCS2.0.X_6577 system: partition 1Upgrading partition 1(Aruba2400) #reload(Aruba2

8、00) #boot system partition 0PC：telnet 54 2300connect 1/2重启AP4秒内Stop>purgenv>bootlogin as: adminadmin0's password:(Aruba-master) >enablePassword:*(Aruba-master) #configure terminalEnter Configuration commands, one per line. End with CNTL/Z(Aruba-master) (config) #telnet soeOnce SOE is enabled, you can connect to the AP serial port with the following procedure:1 Telnet to the Aruba mobility controller using port 23002 Log in using the admin account3 Connect to the Ethernet port that the AP is attached toUser: adminPassword: *Availab