ST STPMS1智能传感器解决方案

1、ST STPMS1智能传感器解决方案关键字：工业控制,传感器;消费类电子,智能电表ST公司的STPMS1是嵌入PGA的双路1位2MHz1阶Sigma0Delta调制器,也称为智能传感器. STPMS1是混合信号器件,包括了模拟和数字部分, 模拟部分包括前置放大器和连个1阶Sigma0Delta调制器区块,能带隙基准电压,低压降稳压器和DC缓冲器;而数字部分包括时钟发生器和输出复接器.器件具有中等分辨率.VCC电源3.2V-5.5V,支持50-60Hz 交流电表,主要应用在电表,马达控制,工业过程控制,衡器和压力传感器.本文介绍了STPMS1主要特性,方框图, 应用电路图, 电表应用电路图和基于

2、DSP的应用框图,以及多相演示板STEVAL-IPE010V1方框图,主板和子板电路图和相应的材料清单(BOM).STPMS1: Dual-channel 1-bit, 2 MHz, 1st order sigma-delta modulator with embedded PGAThe STPMS1, also called a smart-sensor device, is an ASSP designed for effective measurement in power line systems utilizing the Rogowski coil, current transfo

3、rmer, or shunt principle. It is used in combination with the STPMC1 programmable poly-phase energy calculator IC, as a building block for single-phase or poly-phase energy meters. The STPMS1 is a mixed signal IC consisting of an analog and a digital section. The analog section consists of a pre-ampl

4、ifier and two 1st order modulator blocks, band-gap voltage reference, a low-drop voltage regulator, and DC buffers, while the digital section consists of a clock generator and output multiplexer. This device is designed for use in medium resolutionSTPMS1主要特性: VCC supply range: 3.2 V - 5.5 V Two 1st

5、order sigma-delta modulators Programmable chopper-stabilized low noise and low offset amplifier Supports 50-60 Hz AC watt meters Internal low-drop regulator at 3 V (typ.) Precision voltage reference: 1.23 V and 30 ppm/°C (typ.)STPMS1应用: Power metering Motor control Industrial process control We

6、ight scale Pressure transducers图1.STPMS1方框图图2.STPMS1应用电路图: P = 64000 imp/kWh, INOM = 5 A, IMAX = 60 A图2.STPMS1电表应用电路图图3.STPMS1基于DSP应用的连接框图STPMC1和STPMS1多相演示板STEVAL-IPE010V1STEVAL-IPE010V1 poly-phase demonstration kit for the STPMC1 and STPMS1This application note describes the STEVAL-IPE010V1 poly-ph

7、ase demonstration kit for the STPMC1 and STPMS1.The STPMC1 is a metering ASSP implemented through an advanced 0.35 m BCD6 technology.The STPMC1 device functions as an energy calculator in power line systems, using the Rogowski current transformer and shunt or Hall current sensors. It is used in comb

8、ination with one or more STPMS1 devices. It implements all the functions needed in a 1, 2 or 3- phase energy meter, providing the effective measurement of active and reactive energies, VRMS, IRMS, instantaneous voltage and current-per-phase in 1, 2 or 3-phase wye and delta services, from 2 to 4 wire

9、s.In a stand-alone configuration the STPMC1, which sends a pulse train signal with a frequency proportional to the cumulative active power, can directly drive a stepper motor,therefore implementing a simple active energy meter.This device can also be coupled to a microprocessor for multi-function en

10、ergy meters. In this case, the measured data is read at a fixed time interval from the device internal registers by the microcontroller through the SPI interface.AO-Electronics 傲壹电子 官网： 中文网：modulators, band-gap voltage reference, a low-drop voltage regulator and DC buffers in its analog section, and

11、 a clock generator and output multiplexer in its digital section. The STPMS1 is an ASSP designed as a building block for single or multi-phase energy meters. It consists of a pre-amplifier and two 1st order Delta-Sigma The demonstration kit is made up of a main board with the STPMC1 mounted, and it can be coupled with up to