局域网使用说明

1、局域网使用说明Network cable instruction1、 将驱动分别安装到主、副机两台电脑上（带网络线电脑为主机），桌面将显示图标如下：Install driver for host and guest computer.(the host computer is the one with a lan cable). Desktop will show the following diagram: 图1 Diagram 1 2、 双击图标（ANSI），出现以下图片，单击图片左上角File 中change device mode，分别出现图片如下： Double click Icon

2、 (ANSI), Diagram 2 will show up. Slect “change device mode” in the “File” on the upper left of Diagram 2. Then Diagram 3 will go up. 图2 图3Diagram 2 Diagram 33、 选择图3Mode中的Network cabie(局域网)；注：High speed Data bridge为对拷；Select “Network cable” in “Mode” of Diagram 3. Note: High Speed Data Bridge is for

3、link.4、 打开主机电脑网上邻居，查看网络连接，将多出一个USB本地网络11（如图4）；Open “network neiborhood” in host computer to check network link. A “USB Local Network Link 11” will come up (Diagram 4). 图5图4 5、 右键点击图4本地连接选属性，选择高级，将网络设为共享(如图5)，使用IP地址不变（如图6），（主电脑自动获得IP地址同样可以使用，但主、副电脑网段不能相同），同时打开USB本地网络连接11属性，将IP地址另设，网关及首选、备用服务器不用设置（如下图

4、7）Right click “Properties” of “Local Link” in Diagram 4. Select “Senior Setting”. Share the Network Link (like Diagram 5), and keep the IP Adress as before (as Diagram 6). (The IP Adress automatically gained by host computer can also apply, but Network Segment of the host and guest computer shall be

5、 different.) Meanwhile, select “Properties” from “USB Local Network Link 11”, set another IP Adress. Leave “gateway”, “Prior Choice”, and “Spare Server” as they are (refer to Diagram 7).主機USB连接IP 图6 图7主機本地连接IP Diagram 6 Diagram 7 6、 打开副电脑网络邻居，查看网络连接，也多出一个USB网络本地连接4，右键单击选属性，将IP地址网段设置为与主电脑USB网段相同（图7网段

6、为0），IP不能相同，同时默认网关填上主电脑USB本地连接11的IP地址（如图8、图9）；Open “Network Neighborhood in guest computer to check internet link. And another “USB Local Network Link 4” will show up.Right click “Properties”, and set the IP Adress the same as that of the host computer (Network Segment is “0” in Diagram 7). IP shall be different. In the meanwhile, maintain the defaults of gateway, and input the IP Adress for “USB Local Network Link 11” of host computer into “Prior DNS Server” (like the following Diagram 8 & 9).副機USB连接IP 图8 图9Diagram 8 Diagram 9要相同1填上主機本地連接的默认网关7、 将主电脑USB本地连接11停用，再重新启用，副电脑即可上网。 Stop “