单片机串行通信发射部分设计gc摘要

1、单片机串行通信发射部分设计摘要:我所做的是单片机串行通单片机串行通信发射部分设计摘要:我所做的是单片机串行通信发射机，它能显示数字信号能将信号发射出去。采用串行工作方式，能显示 00-99 的数字，用片机89C51 来控制，采用共阳极数码显示写部分由汇编语言单片机串行通信发射机是用来发射信息能完成信息准确无显示发射，使信息能够在两地之间传递，给人们在通信上带来方便发射机设计的思路是:由一片单片机来控制信息的发射和显示用汇编语言编写发射程序和显示程序，使硬件发射机的设计加以结合，完硬件的设计要考虑多方面，以自己设计的目的为出发点，设计理的方案。发射机需要硬件的配合、补充编写要和接机达成相同的通信

2、协议，这样才能完成预期的效果：单片机，汇编语言，数字信号，发TheDesignofMicroControllerUnitAbstract: What s a Micro Controller Unit correspondence blast-device, it can show the digital signal, and also can send TheDesignofMicroControllerUnitAbstract: What s a Micro Controller Unit correspondence blast-device, it can show the digi

3、tal signal, and also can send out the signal uses serial-port operating mode, can show the number from 00 to 99, languageplaittoA Micro Controller Unit correspondence blast-off device is used for sending out the information, it can complete the information blast-delivered betn the two sides and brin

4、g the convenience on the correspondence to the people.The way of t blast-off design is controlled the blast-off of information by a machine of saving and ion, use to edit collected materials the plait to write to shoot the procedure and the ion make hardware and softwares blast-offo combine, complete the design The design of the hardware need to any ways,taking et lf design as the of departure to design reasonable project.The blast-off device need moderate n correspondence protocol of the machine demand hardware, then completei