免费预览已结束,剩余1页可下载查看
下载本文档
版权说明:本文档由用户提供并上传,收益归属内容提供方,若内容存在侵权,请进行举报或认领
文档简介
1 as 122009australian standardmethods of testing soils for engineering purposesmethod 3.3.1: soil classification tests calculation of the plasticity index of a soil1 scopethis standard sets out a method to calculate the plasticity index of a soil as derived from the liquid limit and the plastic limit of a soil.2 referenced documentsthe following documents are referred to in this standard: as1289methods of testing soils for engineering purposes12 method 3.1.1: soil classification testsdetermination of the liquid limit of a soilfour point casagrande method12 method 3.1.2: soil classification testsdetermination of the liquid limit of asoilone point casagrande method (subsidiary method)12 method 3.2.1: soil classification testsdetermination of the plastic limit of a soilstandard method3 procedurethe procedure shall be as follows:(a) determine liquid limit in accordance with as 12 or as 12. if the liquid limit cannot be determined the soil is considered to be non-plastic and the plastic limit need not be determined.(b)if a liquid limit value has been determined, perform the plastic limit in accordance with as 12 ensuring that the same method of preparation of the soil for the liquid limit and plastic limit has been followed.on4 calculati using the reported values of wl and wp, calculate the plasticity index (ip) from thefollowing equation: standards australiawhereip= wlwpas 122009ip = plasticity index, in percent.wl = liquid limit, in percent.wp = plastic limit, in percent.as 122009 25 test reportthe following shall be reported:(a)the plasticity index (ip), in percent, when both the liquid limit and the plastic limit are determined.(b)when the liquid limit or the plastic limit cannot be determined, report the plasticity index as np (i.e., non-plastic), together with the liquid or plastic limit, if either has been determined.(c) when the plastic limit is equal to or greater than the liquid limit, report the plasticity index as 0 (zero) and also report both the liquid limit and the plastic limit.(d)the method used to determine the liquid limit, i.e., as 12 or as 12. (e)method of preparation and the history of the sample.(f) reference to this method, i.e., as 12. standards a.au3 as 122009notesas 122009 4this australian standard was prepared by committee ce-009, testing of soils for engineering purposes. it was approved on behalf of thecouncil of standards australia on 9 december 2008 and published on 6 february 2009.the following are represented on committee ce-009: austroadsassociation of geotechnical testing authorities (qld)australian building codes boardaustralian chamber of commerce and industryaustralian geomechanics societyaustralian stabilisation industry associationcement concrete and aggregates australiadepartment of planning and infrastructure (nt)engineering and construction laboratories associationengineers australianational association of testing authorities australiauniversity of melbourneuniversity of sydneyvictorian construction materials laboratories associationkeeping standards up-to-datestandards are living documents which reflect progress in science, technology and systems. to maintain their currency, all standards are periodically reviewed, and new editions are published. between editions, amendments may be issued. standards may also be withdrawn. it is important that readers assure themselves they are using a current standard, which should include any amendments which may have been published since the standard was purchased.detailed information about standards can be found by visiting the standards web shop at .au and looking up the relevant standard in the on-line catalogue.we also welcome suggestions for the improvement in our standards, and especially encourage readers to notify us immediately of any apparent inaccuracies or ambiguities. contact us via email at .au, or write to the chief executive, standards australia limited, gpo box 476, sydney, nsw 2001.originated as as a89.4a1966.revised and redesignated as as 1289.c3.11977. revised and redesignated as as 121995. second edition 2009.this standard was issued in draft form for comment as dr 06693.copyright standards australiaall rights are reserved. no part of this work may be reproduced or copied in any form or by any means, electronic or mechanical,
温馨提示
- 1. 本站所有资源如无特殊说明,都需要本地电脑安装OFFICE2007和PDF阅读器。图纸软件为CAD,CAXA,PROE,UG,SolidWorks等.压缩文件请下载最新的WinRAR软件解压。
- 2. 本站的文档不包含任何第三方提供的附件图纸等,如果需要附件,请联系上传者。文件的所有权益归上传用户所有。
- 3. 本站RAR压缩包中若带图纸,网页内容里面会有图纸预览,若没有图纸预览就没有图纸。
- 4. 未经权益所有人同意不得将文件中的内容挪作商业或盈利用途。
- 5. 人人文库网仅提供信息存储空间,仅对用户上传内容的表现方式做保护处理,对用户上传分享的文档内容本身不做任何修改或编辑,并不能对任何下载内容负责。
- 6. 下载文件中如有侵权或不适当内容,请与我们联系,我们立即纠正。
- 7. 本站不保证下载资源的准确性、安全性和完整性, 同时也不承担用户因使用这些下载资源对自己和他人造成任何形式的伤害或损失。
最新文档
- 2026年卫生统计综合题库及答案
- 2026年测试考试专科法律知识杭州题库及参考答案
- 2026年医德医风考试模拟题及答案
- 2026年广东省中小学教师招聘考试模拟题题库及参考答案
- 2026年国考选择题题库带答案
- 2026年四川水安b证考试题库(含答案)
- 2025年有限空间作业应急处置考试题及答案
- 2026年新课改理念题库及答案
- 2026年机动车检测工考试题库(含答案)
- 2026年安徽省计算机一级考试模拟题库带答案
- 美食城经营管理合同范本
- 直流系统培训课件
- 2025年数智供应链案例集-商务部
- JG/T 14-2010通风空调风口
- DB33T 1368-2024医院“一站式”综合服务中心建设与服务规范
- 起重机岗位职责规章制度
- 《人才盘点完全应用手册》
- 2024年共青团团课考试测试题库及答案
- (正式版)QC∕T 625-2024 汽车用涂镀层和化学处理层
- 特殊教育教师职业生涯规划
- 医学大数据分析 课件 第1章 医学大数据概述
评论
0/150
提交评论