【AS澳大利亚标准】AS NZS 3160-2001 Amdt 2-2006 Approval and Test Specification-Handheld Portable Electric Tools.doc

accessed by university of south australia on 12 mar 2007as/nzs 3160/amd 2/2006-10-20standards australia/standards new zealandamendment no. 2 toas/nzs 3160:2001approval and test specification - hand-held portable electric toolsrevised textthe 2001 edition of as/nzs 3160 is amended as follows; the amendments should be inserted in the appropriate places.summary:this amendment applies to preface, clauses 3, 11, 16 and 17.2. published on 20 october 2006approved for publication in australia on behalf of the council of standards australia on 15 august 2006approved for publication in new zealand by the standards council of new zealand on 25 august 2006this amendment take effect from the date of publication except the amendment to clause 16 and 17.2, which takes effect 24 months from the date of publication.prefacereplace the fourth paragraph by the following:this standard incorporates amendment no. 1 (june 2005) and amendment no. 2 (october2006). the changes required by the amendments are indicated in the text by a marginal bar and amendment number against the clause, note, table, figure or part thereof affected. where an application date other than immediate is applicable to an amendment the date of application (doa) is indicated by the marginal bar against the part affected.3referenced documentsunder the list of approval and test specifications delete “as” immediately prior to the reference to “3190”.11tools with double insulation (class ii tools and tools with class ii construction)11.2.3 residual current devicesreplace “as 3190” by “as/nzs 3190” in three places.16switches and speed control devicesadd the following paragraph.overload protection devices incorporated in hand-held motor-operated electric tools shall be of the non-self-resetting type.isbn 0 7337 7737 6accessed by university of south australia on 12 mar 2007electronic speed and load regulators that interrupt the operation of the tool and that allow automatic resumption of the operation of the tool within 2 s are not considered to be overload protection devices.17marking17.2add the following:grinders fitted with an electronic speed or load regulator that interrupts the operation of the tool and that allows automatic resumption of the operation of the tool within 2 s shall be fitted with a label permanently attached to the supply cord. the label shall contain the substance of the following warning:warning: this tool will restart automatically if stalled. do not remove this label. the size of the label shall be approximately 50 mm x 70 mm.the lettering of the word “warning” shall be upper case and be not less than 5 mm high. other lettering shall be at least 2 mm high.access