水性丙烯酸防锈底漆.doc

水性丙烯酸防锈底漆Intended Uses用途适用于各种钢结构表面作防锈底漆，它具有不含铅、无毒、快干和防锈性能佳等优点。As an anti-corrosive primer, suited for various steel surfaces. It is lead-free, non-toxic, quick-drying performance and excellent anti-rust, etc.ProductDescription产品简介基于合成树脂基料，黑色。Based on synthetic resin binder. Black.ProductInformation产品数据Volume Solids 固体份41%Dry Film Thickness干膜厚度35microns equivalent to 85 microns of wet film35微米相当于35微米湿膜厚Theoretical Coverage 理论涂布率About 10 m2/Kg 约10平方米/公斤Practical Coverage 实际涂布率Allow appropriate loss 允许适量损耗Application Details施工详述Mix Radio 混合比One package 单罐装Method of Application 施工方法Recommended-Tip range: 0.43-0.53 mmTotal output fluid pressure: no less than 15 M pa 出口液压不低于（150 Kg/cm2）15 M paRecommended 推荐使用Recommended， but only for small area推荐适用，仅适用于Airless Spray 无空气喷涂Brush or Roller 刷涂或辊涂Conventional Spray 传统喷涂Thinner 稀释剂Water 水Cleaner 油漆设备清洗剂 COO8Water 水Pot Life 使用期Not limit 不限制Storage 贮存期One year 一年Drying time干燥时间SubstrateTemperature底材温度,Touch Dry表干,hHard Dry硬干,hOver coating Interval覆涂间隔Mix最短Max最长2522416 h 3months 3个月Storage andHandling贮存与管理Storage 贮存 Store in cool and dry conditions, keep in close containers 贮存于阴凉干燥处,保持密封 Pack size 包装规格 20 Kg in 20 liter container 20 Kg装于20 L容器中Flash Point 闪点 35 Specific Gravity 比重 Approx 1.19 Kg/L 约1.19公斤/公升Specification and Surface preparation技术要求及表面处理Steel surface: Blast to Swedish Sa2.5 and rust-removed manually or with power tool to St3 before application.钢材表面：喷砂处理至瑞典标准Sa 2.5级或手工、动力工具除锈至St3 Limitations限制Please mix and still to even before application, during the application. The temperature of the environment should be 10, the relative humidity should be less than 80%, the substrate temperature should be more than 3 above the dew point, enough ventilation is necessary at the application site. No application when the temperature is too low during night. No application when it is raining or there is dew The front coating :Zinc-rich primer or others paint which is permitted.施工及干燥期间，环境温度最好在10度以上，相对湿度低于80%，底材温度高于露点3以上，并保证良好的通风SafetyPrecautions安全措施This product should be used in painting area by professional operators. When painting , please refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and heath when applying this product. This paint is based on water, In general, this paint has no danger of combustion and explosion. However , enough ventilation is necessary at application site Protect skin and eyes, and avoid touching with paints (Recommend to wear working clothes, gloves, eyes protection,face masks, barrier creams and so on). If paint gets in touch with skin, wash fully with a large amount of fresh water and soap or appropriate cleaner. In case of eyes being contaminated, rinse with fresh water for 10min at least and give medical treatment immediately.Handle empty containers with care and do not bring about environmental contamination.NOTICE: If consumer have not taken effective safety precautions(Refer to thespecification), our company will Not be responsible for any accident. 本产品由专业人员在工业场所使用，使用时请参照本说明书及安全健康手册，如客户在使用本产品前，未能仔细了解有关产品的安全健康知识，请与本公