3584加一路扩展柜简易操作手册.doc

3584加一路扩展柜简易操作手册For 1 expansion frame MES:1， Power off base frame, Level base frame.2， Remove expansion frame right door, if exist.3， Remove base frame right door4， Remove base frame X-axis end stop5， Expansion frame, install upper X-axis guide rail, do not connect with base frame6， Expansion frame, install lower X-rail, not connect with base frame7， Loose expansion frame locknuts8， Place frame skate under the 2 leveling pads on the left side of expansion frame9， Raise left side of expansion frame, move toward base frame, alignment rod should be aligned with the hole in base frame10， Push alignment rod into hole11， Insert M8 bolt between base frame and expansion frame, should not be tight.12， Remove frame skates from left13， Use E-shaped tool to ensure the frames are correctly aligned one another14， If step 13 is ok, re-tighten 2 M8 bolts, just finger-tight.15， Place level of lower expansion frame X-rail, Raise expansion frame right side until X-rail is level.16， Align upper X-rails17， Put down left leveling pads, and tight manually, not too tight18， Install long T-nut19， Move expansion frame X-rail to base frame 20， Check alignment rod fully seated in base frame.21， Tight 2 M8 bolts22， Use alignment tool on the X-rails23， Hammer the alignment tool24， Tighten X-rail T-nuts25， Tighten the long T-nut26， Tighten upper X-rails27， Use clamp tool from left to right. Press rod in place28， Install X-rail right side end stop.29， Install frame spacers on base frame and expansion frame.30， Install frame-to-frame attachment brackets.31， If you just install 1 expansion frame, no need to change X-axis track cable. If not, install the cable32， In expansion frame, install X-axis cable cover33， Test X-axis cable movement34， Tighten all leveling pads35， Install right door36， Connect power cables J5 on expansion frame to J7 of Base frame. J5 to J5, J7 to J737， Connect interface signal cable from J6 of expansion to J8 of base frame38， Connect inter-frame EPO cable connectors P23 on Base frame39， Ensure Jumper of EPO cable is installed on last expansion frame 40， Remove J15 terminator of PIC cards on expansion frame41， Remove J16 terminator of PIC cards on base frame42， Check all J15,J16 terminator are fully installed. 43，