THE USE GUIDE OF PROGRAMMING SOFTWARE(20130125).doc

THE USE GUIDE OF PROGRAMMING SOFTWARE Time :2013-1-25Author:MaozerongNote :the file path can not have a Chinese word, because if some Chinese words in the software file path, it could make the programming software failed.(English will be OK!) If you have any question about programming the software, please contact me by email (). 1.When you install MPLAB IDE , you should pay attention to this step .click icon of “NO” to finish installing MPLAB IDE 2.Install HI_TECH_PICC9.8 2.1 Double this folder to install HI_TECH_PICC9.8,according to picture 2-1. During the installing ,when display “Select Activate PRO/Standard mode with serial number” ,please input six number such as“111111”；then click “NEXT” untill finish.Double this folder 2-1 2.2 Next you could open the file “the key for XP”, here is the key for using .double click “ HI-TECH” , it wil pop up the ico , just as the picture 2-2 2-22.3 Open the the “HCPICP-111111-activation-request” to activation ,just as bellow picture 2-3. 2-3then the button activate will become effective ,like the following picture4. please Click the button “activate” then the installing is finished and you can find a text file“ HCPICP-11111-activation-response.txt”will generate in the installing path. Click the button to finish installingAfter selecting “HCPICP-111111-activation-request”, click here3. Connect the PICKit3 to the target device(the climate controller)and your computer, please see picture 3-13-23-3 3-1 PICKit3 interface definition 3-2 Controller panel programing interface definition Use the bus line to connect PIC Kit3 to the controller or use the specially making bus to connect 4. Build(compile) the software and program the software 4.1 choose the language Tollsuite as below, if you use the compile tool firstly you should do follow these steps . Click this icon to set the language toolsuiteClick this iconClick this file (picc) to finish selecting the languageMake sure the language tool suite is piccClick OK4.2 After you have chosen the language toolsuite (picc), you can build (compile ) the software as below.Click this red icon to build (compile the software) , Build (compile ) the software successfully Build (compile ) the software failed , you will see some words which tell you that there are some error or problems5. Program the software5.1 Connect the PICKit3 to our MPLAB IDE , connection definition according to THREE above.5.2 The power of target device ( controller panel) from PITKIT 3 as below .Click the icon “setting”Click the icon PICKit3 to connect the PICKit3 with MPLAB IEDThen click the button “OK”choose the power target circuit from PICkit 3Click the OK icon to finish power setting5.3 After the hard job done above, then you can start to download the software to the MCU of controller panel as belo