夜光Brinyte专业潜水手电筒DIV01说明书.docx

夜光Brinyte专业潜水手电筒DIV01说明书u 产品说明：此手持式专业潜水手电筒采用美国最新CREE XM-L2(U2) LED,最高亮度达1000lumen, 头部旋转开关，便于操作，使用3节C电池或2节18650电池, 高亮续航时间可达7小时.3层防水圈保护，优良的密封设计，5mm厚度的钢化玻璃,使此款电筒可承受150米的潜水深度，加上11度的发光角度, 是您潜水照明工具的必选之一。This handheld flashlight utilize the USA CREE XM-L2 LED, max 1000lumens output, twist on/off switch at head, very easy for you to operate, powered by 2*18650 lithium rechargeable batteries or 3*C size batteries, 7 hours runtime in high output.Three O-rings protection, excellent sealing design and 5mm toughened glass，making this flashlight can dive to the depth underwater 150m, 11 degree excellent beam angle, absolutely it is one of the necessary back-up lighting for your technical and leisure diving.u 产品参数：ANSI高亮档中亮档低亮档爆闪档SOS档亮度1000流明/续航时间7小时/最大光强25000坎德拉最大射程320米防跌落测试1.5米防水等级IP68 水下150米注：以上参数是在实验室环境中测试所得，可能会随着手电的使用环境和电池不同而发生变化。Technical Parameters:ANSIHighMediumLowStrobeSOSOutput1000lumens/Runtime7 Hours/Intensity25000cdDistance320mDrop Resistant1.5mWaterproofIP68 underwater 150mThe parameters above have been tested under laboratory conditions, so they may vary between different batteries and environments.u 产品规格：-采用美国进口CREE XM-L2 U2 LED 灯珠，寿命超过50000小时；-可以使用3节C电池或者2节18650可充电锂电池；-电流稳定,亮度恒定；-过热保护,防止外壳温度过高影响使用；-防反接保护，防止因电池反装而损害手电；-尾盖（凸台）大挂绳孔设计，可以悬挂快扣；-旋转头部或者筒身即可开关手电，操作方便；-三层防水圈设计，使潜水深度达到150米；-航空铝材并采用军工三级硬质阳极氧化抗磨和抗腐蚀处理，经久耐用-采用镀膜防刮花钢化玻璃；-光学分析设计的铝合金反光杯；-产品大小: 46 mm (头)*34 mm (中)*35 mm (尾)*210 mm (长 ) * 285g（净重）-配件：O圈，润滑油，手绳，说明书，中性牛皮纸盒；-其他可选配件：礼盒，手腕带，电池，充电器.Product Specification:-Utilize Cree XM-L2(U2) LED, lifespan is over 50,000 hours;-Uses 3* C size batteries or 2* 18650 li-ion rechargeable batteries;-Regulated power supply can maintain constant output; -Over-heat protection, preventing the high temperature from influencing the normal use-Low voltage warning function to remind the user to change the batteries; - Reverse polarity protection to protect from wrong battery installation;-Super big lanyard hole design for bolt snap mount; -Twist on/off switch, very easy to operate; -Three O rings design to ensure underwater 150 meters;-The crust is made of durable Aircraft-grade aluminum;-Premium type III military hard-anodized finish for abrasion and corrosion resistance.-5mm Toughened glass can stand higher water pressure resistance- Alloy aluminum reflector-Dimensions: 46(Head dia.)*34(Body dia.)*35(Tail dia.)*210(Length )mm* 285g（net weight）-Standard accessories: 3 spare O-rings, Lubricant, lanyard, user manual and Neutral box; -Other accessories (optional): gift box, wrist strap，battery，charger.u 产品分解图及说明：Products structure and instruction; u 操作说明：a) 电池安装电池正极对准灯头方向(如图)，旋紧头部即可使用b) 开关电源拧紧头部和筒身可以开关电筒，拧松就可以关闭；Operation:a) Battery installationKeep the battery positive pole direction same as the light head (as shown in the picture), tighten the head to turn on the light.b) Tighten the head to turn on the light, unscrew the head to turn off.u 注意事项：1）所有潜水电筒的连接处（除开关部位）在出货前都会密封，用户请不要擅自打开；2）为了避免进水的可能，我们建议潜水前就打开电筒（开关一定拧紧）；3）避免水下多次拧动；4）手电长时间不用，需将电池取出，否则可能因电池漏液或者爆炸造成手电损害。Note:1) All of the connections(except the switch) are sealed before shipment, PLEASE dont disassemble;2) Avoiding the possibility of the dive light leaking underwater, we suggest turn on the light before diving. 3) Dont twist the switch many times underwater4) Please take the batteries out of the light if you dont use it for long time, or the light may be damaged by the battery leakage or detonation. u 手电保养：1）每次潜水后请及时用淡水浸泡电筒；2）每次使用之后开关部分建议擦润滑油；3）请勿将电筒放在沙地上，以防细沙进入开关和螺纹缝隙；4）请经常检查O圈，如有损害请及时更换，以维持手电的防水性能；5）请经常清洁手电的导电接触面以保证手电的正常工作。Flashlight maintenance:1） Please immerse the dive flashlight in the fresh water for few minutes after diving and clean the water after immersing;2） Please put lubricant on the switch threads after diving3） Please dont drop or place your dive flashlight in sand, in case the sand go into the switch and threads4） Please inspect the O-rings often, change a new one once there is any damage5） Please clean the conductive connections often to ensure the flashlight work normally. u 手电常见问题自我检测：当手电出现异常闪烁或者无法工作的时候，以用以下方法来自我检测：1) 电池电量不足-需要更换电池；2) 螺纹或者PCB板的导电接触面被弄脏-请用酒精清理接触面如果上述方法无效，请联系经销商并按照售后服务条款接受保修。FAQ and Detection:When the flashlight flash unusually or cant turn on, it might be the reasons below1) The battery voltage is too low-please replace new batteries2) The threads or conductive connections parts are dirty-please clean them with alcohol.Please contact the dealers for warranty if the flashlights still dont work w