KISTER包装机基本知识

1、KISTERS包装机切膜 包装机的切膜部件认识 上膜滚与压膜滚的间距 切膜刀的角度 陈道江. Film Feed The film is drawn off the reel by a pair of feed rollers, cut by an intermittently rotating knife and fed onto the film feed conveyor by a second pair of rollers.膜站部件的认识 1/7 Steel roller. 2 Rubber roller. 3 Stripper finger bar. 4 Adjuster for

2、5 5 Film guide plate 6 Anti-static bar 1/7钢辊。 2胶辊。 3剥膜手指杆。 4调整金属板的角度 5薄膜引导金属板 6除静电杆 8 Rubber roller 9 Stripper finger bar 10 Knife mounting angle 11 Film cutting knife 12 Film cutting point 13 Air jet bar 8胶辊 9剥膜手指杆 10刀安装角 11切膜刀 12薄膜切割点 13空气喷射杆 1 Pressure springs for regulating the pressure of the r

3、ubber rollers on the steel rollers. Normal setting - a spring length of between 35 and 40mm. 2 Drive chain. 3 Chain tensioner. 4 Reversal preventer - ensures running in one direction only. 1压力弹簧的压力调整能改变钢模滚与橡胶膜滚的间距。 正常设置弹簧的长度为35 - 40毫米之间。 2传动链。 3紧链器。张紧轮- 4逆转确保只在一个方向上运行。切膜刀与膜的角度 WARNING !: There is a

4、danger of injury when work is carried out in the area of the film cutting knife if great care is not taken. Do not hurry the work ! Do not allow yourself to be distracted !1. Setting the Stripper Finger BarsSetting stripper finger bars and .- fingers centred between the slots in the rubber roller.-

5、correct height - the film must not be touched.Attention: Care must be taken to ensure that the fingers of stripper bars and do nottouch the side of the slots in the rubber rollers.2. Setting the Knife Stop Position on the CB6 ClutchNote: The setting operation should only be carried out with the brake being applied.In its stop position the film cutting knife must not touch the film. It should be at an angle ofabout 70 to the film. 手指集中在胶辊之间的槽。正确的高度，薄膜不能碰。注意:必须小心,以确保剥膜手指杆和不接触橡胶辊的槽