说明分析教案lk1946

1、17.06.2014 (No Brand)Comments for TETSMA-180(ZS140440)-6-5 mold drawing of NameTagBack & NameTagFront Remarks No. 1Please locate the parallel locks on the same center linePlease approved or remark 要加俩个边锁17.06.2014 (No Brand)Comments for TETSMA-180(ZS140440)-6-5 mold drawing of NameTagBack & NameTagF

2、ront Remarks No. 2Make the spru shorterPlease approved or remark 忌嘴要加深02.06.2014 (No Brand)Comments for TETSMA-180(ZS140440)_5-29 mold drawing of NameTagBack & NameTagFront Remarks No. 8Try to use 3 bafflers for every partWhen the cooling line diameter is 8 mm the baffler diameter need to be 12 mmPl

3、ease approved or remark done模要再加一个水井There is 2 baffler in every part with distance of 50 mm between themI usually make smaller distance between bafflers02.06.2014 (No Brand)Comments for TETSMA-180(ZS140440)_5-29 mold drawing of NameTagBack & NameTagFront Remarks No. 26O-ring should be VITON O-RINGO-

4、ring pocket need to be done according HASCO standard (see enclose PDF)O-ring size need to be done according HASCO standard (see enclose PDF)Please approved or remark doneWaste added to the part list2D清单上没有注明胶圈的规格02.06.2014 (No Brand)Comments for TETSMA-180(ZS140440)_5-29 mold drawing of NameTagBack

5、& NameTagFront Remarks No. 9Make 2D with full part list and define the steel type and hardnessmold base, core and cavity main inserts, core and cavity sub inserts, slide base, slide inserts, pistons, wear plates, slide rails ( guiding blocks), slide retainer, angle pins, guide pins and bushings, spru bushing , parallel locks, EJP, jiggle bars / lifter, jiggle bars / lifter guiding, jiggle bars / lifter base, O-ring, legs , transportation bridge, water plugs,watre connectors,