航发pcf1报告全尺寸.part1113

1、CHECK RESULT 检查结果OK.RATIOTitle 项目Part codeP1P2P3TOTAL全尺寸OK Ratio100%OK Pos34Total Pos34SURF.型面OK Ratio100%OK Pos18Total Pos18TRIM修边OK Ratio100%OK Pos13Total Pos13HOLE孔位孔径OK Ratio100%OK Pos3Total Pos3Title 项目Content 内容CS11_Fully measured ReportProject Name 项目名称CS11Part Code 零件号CAD NumberCAD 号-012Part

2、 Name 零件名称HINGE REINFORCEMENT UPPER FR RHTie1r 供应商Toolingr 模具供应商tianyueMaterial standard code 板材牌号VDA 239-CR300LActual Material 替代牌号Thickness 板材厚度1.2Coating thickness 镀锌层厚度GI50/50-UDetection time 检测日期2016.12.10RPS InformationStep 1 : MP CheckingStep 2 : Surface CheckingStep 3 : Trim CheckingStep 4 :

3、 Hole size CheckingSD918H2RSD921H1Rnominal10.+0.15/-08.10+0.22/-012.00.5actual10.138.2312.45deviationStep 5 : ThinningREPORT CHECKING THINNESMeasure thickness request: 1.2 mmactual thickness 1.2 mmLIMITS MAX : 20%11.172.5%21.172.5%31.181.7%41.163.3%51.172.5%61.163.3%71.172.5%8910111213141516THINNING

4、 MAXStep 6 : Appearance CheckingAppearance Checking 外观检查NO判定标准 Control standard检验方法 Methond判定 OK、NG、N/APicture1零件是否正确？ Is the rignt part?Visual目视OK2变薄率是否 料厚的 20%范 内？ THINNING MAX no more 20%Venire caliper 游标卡尺OK3是否有开裂、暗裂？ No crack,deformationVisual目视OK4毛边、毛刺、尖角是否 0.3mm 范围内？ glitches, indenion,damage

5、d,Venire caliper 游标卡尺OK5是否有模痕、压伤（无手感可接受）？ No roughness detect with the handwith the handOK6是否有拉伤、划伤？No degradation or deformation手触 with the handOK7是否有起皱、变形（装配面平面度需 0.2MM 以内）？No crack,deformationVisual /Venire caliper目视/游标卡尺OK8是否有生锈？Rust?Visual目视OK9字印是否正确、明显且无手 感？Marking information crrect ?Visual/ with the hand目视/手触OK10公差是否与 3D 公差相符？ Report tolerance is the same with 3D?检查 checkingOK11零件定位是否与检具定义相符？ PRS is the same with gauge?检具 gaugeOK12料边断差是否超过公差带的 50%？ Trim no moren 50% out of tolerance