3机舱inst9个zch文件和轮毂安装

1、机舱和轮毂安装Installation of nacelle with hub检查项目和规范：由现场填写 To be filled in by the site已校准设备Calibrated equipment位置.nr设备描述（类型、名称等）Description of equipment(Type ,name,etc)设备校准号Equipment calibration number123456789101112在上面的列表中详列设备，随后使用该设备时参考其位置。Specify equipment in list above, and subsequently refer to theNo

2、, when the equipment is used客户/业主：Customer/owner:项目名称：Project Name：项目：Project No:风机：Turbine No.:参照作业指导书：ZWI 1040333Work Instruction:ZWI 1040333ECN 222562 PTL 2015.11.10Check-item and specification:已校准设备位置： Cal. equipment完成日期（日/月/年） Date completed安装 签字installer signature监督签字 Supervisor signature. no:

3、1安装机舱前塔筒顶部法兰Tower top flange cleaned before nacelle is installed.2根据作业指导书对螺栓涂抹润滑脂根据作业指导书要求正确放置垫片和螺母，确保方向正确Stud bolts lubricated according to work instruction.Washers and nutsitioned correctly according to work instruction.3根据指导书要求安装法兰面螺栓根据指导书要求预紧法兰面螺栓Flange bolts mounted according to work instructio

4、n.Flange bolts pretightened according to work instruction.4按终拧力矩要求拧紧螺栓，力矩Nm Stud bolts tightened to final toqueTorque:Nm风速风向仪安装在合适位置Wind sensor support mounted in normal ition移除轮毂吊具螺母托在吊具的螺栓安装盲塞Nut holder for hub lifting bracket removed Bling plugs mounted in bolt holes forlifting bracket安装吊具的开口处安装导

5、流罩分段。依据D1197831 “螺栓紧固-扭矩和紧固”拧紧螺栓Spinner sections in opening for lifting bracket mounted.Bolts tightened according to D1197831 “Bolt tightening - torque and ten”.备注：Remarks 全部完成，ZCH 完成。Completed, ZCH complete.监督员签字： 日期： Supervisor signatureDate安装签字： 日期： Installation Signature：Date备注:检查表必须在安装或调试过程阶段进行填写,严禁提前填写或后补,特此.Note: The checklist must be filled during