配置静态路由实现区域网连通

案例4.1静态由实现络互连【案例描】边现希望通过【教学目】【使用设】设名

设及口配地Router1Router2PC1PC2

/

【案例实】步骤1在路器上置接口的地Router1(config)#interfaceRouter1(config-if)#ipRouter1(config-if)#exitRouter1(config)#interface1Router1(config-if)#ip172.16.2.1试验证路由器接口的配置Router1#showipIP-AddressOK?MethodStatusProtocolYESupupunassigneddownunassignedYESunsetdownSerial0YESunsetSerial1unassignedYESadministrativelyRouter1#showinterfacesFastEthernet1步骤2在路器上置接口的地Router2(config)#interfaceRouter2(config-if)#ipRouter2(config)#interfaceRouter2(config-if)#ip172.16.2.2试验证接口的配置Router2#showipIP-AddressOK?MethodStatusup/

Protocol

upunassigneddownunassigneddownSerial0YESunsetSerial1YESunset步骤3确定由器的直连段和非直连段。步骤在路器Router1上配置静态由Router1(config)#ip172.16.3.0Router1(config)#ip172.16.3.0试验证Router1#showiprouteS-O-OSPF,IA-OSPFarea1,E2-OSPF2oflastisnotissubnetted,3Cisdirectlyconnected,FastEthernet0Cisdirectlyconnected,FastEthernet1172.16.3.0[1/0]via步骤在路器上配置态路由Router2(config)#ip172.16.1.0Router2(config)#ip172.16.1.01试验证router2上的Router2#showiprouteS-O-OSPF,IA-OSPFarea1,E2-OSPF2oflastisnotissubnetted,3172.16.1.0[1/0]via/

Cisdirectlyconnected,1Cisdirectlyconnected,FastEthernet0步骤5测试络的互联互性C:\Documents172.16.3.2!PC1PC2172.16.3.2with32bytesofdata:bytes=32time=1msTTL=126bytes=32time<1msTTL=126bytes=32time<1msTTL=126bytes=32time<1msTTL=126PingstatisticsforSent=4,4,Lost=Approximatetripinmilli-seconds:Minimum=0ms,Maximum=1ms,C:\Documents172.16.1.2!从172.16.1.2with32bytesofdata:bytes=32time=1msTTL=126bytes=32time<1msTTL=126bytes=32time<1msTTL=126bytes=32time<1msTTL=126PingstatisticsforSent=4,4,Lo