CypressCY4541EZ-PDCCG4USBType-C控制方案.docx

Cypress CY4541EZPD CCG4 USBTypeC控制方案时间：2016-03-31 09:45:16 作者：Cypress 来源：中电网Cypress公司的CY4541EZ-PD CCG4是双路USB Type-C控制器,采用M0S8技术和32位48MHz ARM Cortex-M0 MCU技术,集成了128KB闪存和两个完整的Type-C收发器,能为笔记本电脑,电源适配器和坞站提供了完整的双路USB Type-C和USB电源传送端口控制解决方案.本文介绍了EZ-PD CCG4主要特性,框图和逻辑框图,EZ-PD CCG4 USB-PD子系统框图,以及采用CYPD4225-40LQXIT的CCG4双端口笔记本应用电路图和CY4541 EZ-PD CCG4评估套件(EVK)主要特性,框图,CCG4基板和子板框图,电路图和材料清单.EZ-PD CCG4 is a dual USB Type-C controller that complies with the latest USB Type-C and PD standards. EZ-PD CCG4 providesa complete dual USB Type-C and USB-Power Delivery port control solution for notebooks, power adapters and docking stations. Itcan also be used in dual role and downstream facing port applications. EZ-PD CCG4 uses Cypresss proprietary M0S8 technologywith a 32-bit, 48-MHz ARM Cortex-M0 processor with 128 KB flash and integrates two complete Type-C Transceivers including theType-C termination resistors RP and RD.EZ-PD CCG4 is Cypresss newest USB Type-C port controller with Power Delivery. CCG4 provides a two-port USB-C solution ideal for Desktops, Notebooks and Systems like Power Banks, Monitorsand Docks. CCG4is based onCypresssPSoCtechnology with128KBflash memory supporting fail-safe boot up.CCG4supports Upstream Facing Port (UFP), Downstream Facing Port (DFP), and Dual Role Port (DRP) modes.CCG4 reduces BOM by integrating four 1W VCONNFETs, Over-Voltage and Over-Current Protection and 15kV system level ESD protection.EZ-PD CCG4主要特性:32-bit MCU Subsystem 48-MHz ARM Cortex-M0 CPU 128-KB Flash 8-KB SRAM In-system reprogrammableIntegrated Digital Blocks Four integrated timers or counters to meet response timesrequired by the USB-PD protocol Four run-time serial communication blocks(SCBs) withreconfigurable I2C, SPI, or UART functionalityClocks and Oscillators Integrated oscillator eliminating the need for external clockType-C Support Two integrated transceivers (baseband PHY) Integrated UFP (RD) and current sources for DFP (RP) on bothType-C ports Integrated dead battery termination for DRP applications Supports two USB Type-C portsLow-Power Operation 2.7-V to 5.5-V operation Integrated VCONN FETs to power EMCA cables Independent supply voltage pin for GPIO that allows 1.71-V to5.5-V signaling on the I/Os Reset: 1.0 A, Deep Sleep: 2.5 A, Sleep: 2.5 mASystem-Level ESD on CC Pins 8-kV Contact Discharge and 15-kV Air Gap Discharge basedon IEC61000-4-2 level 4CHot Swappable IOs Port 1 I2C pins and CC1, CC2 pins are hot-swappablePackages 6.0 mm x6.0 mm, 0.6 mm, 40-pin QFN Supports industrial temperature range (40 to +85)EZ-PD CCG4应用: Notebooks Power adapters Docking stations图1.EZ-PD CCG4逻辑框图图2.EZ-PD CCG4框图图3.EZ-PD CCG4 USB-PD子系统框图图4.采用CYPD4225-40LQXIT的CCG4双端口笔记本应用电路图图5.采用CYPD4125-40LQXIT的CCG4单端口笔记本应用电路图CY4541 EZ-PD CCG4评估套件(EVK)The CY4541 EZ-PD CCG4 Evaluation Kit (EVK) is based on the Cypresss CCG4 dual port Type-C Power Delivery (PD) controllers. EZ-PD CCG4 is a dual USB Type-C controller that complies with the latest USB Type-C and PD standards. This EVK is primarily intended to be a demonstration vehicle for Type-C PC designs that house one or two Type-C ports. CCG4 can act either as a power provider (Source) or as a power consumer (Sink). The kit also helps to evaluate several features on two Type-C ports, using a Dual Role Port (DRP) or SuperSpeed USB demo, and a DisplayPort demo.CY4541 EZ-PD CCG4评估套件(EVK)包括:Two CCG EVK base boards assembled with one CCG4 daughter cardOne 24-V DC power adapter*Two SuperSpeed Type-A to Type-B cablesTwo Type-C to Type-A donglesOne Type-C cable*One Type-A to Mini-B cableOne set of jumper wiresOne screwdriverQuick Start Guide图6.CY4541 EZ-PD CCG4评估套件(EVK)外形图图7.CY4541 EZ-PD CCG4评估套件(EVK)系统框图The CY4541 EZ-PD CCG4 EVK consists of two CCG base boards and one CCG4 daughter card. The CCG4 daughter card is connected to the two CCG base boards to evaluate the CCG4s dual Type-C port capability.The CCG base board consists of a DC input power supply, a display multiplexer, a DisplayPort connector, a SuperSpeed Type-B port, and a Type-C port. The CCG4 daughter card consists of the CCG4 device and a USB-Serial IC to provide aUSB interface for debugging. CCG4s CC lines of the respective Type-C interface are connected to the Type-C port on the CCG base board. CCG4 controls the display multiplexer over an I2C interface.The CY4541 EZ-PD CCG4 EVK has a power provider and power consumer path control circuitry to showcase CCG4s ability to switch its power role from a provider to a consumer and vice-versa. This EVK has overvoltage and overcurrent protection circuitry for VBUS and VCONN; it also supports programming CCG4 devices over SWD and I2C interfaces.A PC with two USB 3.0 ports and a DisplayPort along with the CY4541 EZ-PD CCG4 EVK is equivalent to a PD-enabled dual Type-C port PC.图7.CY4541 EZ-PD CCG4评估套件(EVK)建立图The CCG base board has an onboard Type-C connector for the USB-PD interface and a CCG4 daughter card interface connector to connect the CCG4 daughter card. It also includes a SuperSpeed USB Type-B port and a DisplayPort connector to source video. The SuperSpeed USB signals and DisplayPort signals are connected to the Type-C connector through a display multiplexer controlled by the CCG4 device. A DC power adapter provides input voltage to the onboard Power Management IC (PMIC). The output voltage from the PMIC can be selected using two voltage selection lines, controlled by CCG4. This CCG base board, along with the CCG4 daughter card, helps convert any desktop or notebook PC with legacy USB ports to operate as a Type-C USB host.图8.CCG基板框图图9.CCG基板连接图The CCG4 daughter card is an evaluation board with a CCG4 controller (CYPD4225-40LQXIT) and a USB-Serial Bridge Controller (CY7C65215) to provide a USB interface for debugging. The CCG4 daughter card m