DSG(02E)基本设定.doc

DSG(02E)基本设定Prerequisites:ATF Temperature 30.100 C (86.210 F), see Measuring Blocks, Group 019. (ATF油温达到30-100度，看测量数据块19)Selector Lever in P (把换挡杆放到P档)Ignition ON (点火开关打开)Engine ON (Idling) (启动发动机怠速运转)Brake Pedal operated (hold for the whole procedure) (踩下制动踏板，保持为整个过程)Throttle Pedal not operated (节气门不要操作)NOTE: Be sure to perform the following steps in the sequence shown, followed by the defined test drive. (注意：必须顺序向下做每一步，)Select02 - Transmission(进入变速箱)Basic Settings - 04(基本设定04)Transmission Tolerances (Engaged Calibration) (变速箱公差适应)Group 061(进入61区)Go!(执行)Activate the Basic Setting.(进行基本操作)ON/OFF/NextTransmission Tolerances (Synch. Point. Measurement) Group 060Go! (进入60区)Activate the Basic Setting. (进行基本操作)ON/OFF/NextClutch Adaptation (离合器自适应)Control Module Software Version = 0800 : (控制模块版本高于0800)Group 067Go! (进入67区)Activate the Basic Setting. (进行基本操作)ON/OFF/NextReset Values (Clutch Safety Function) (重新设置数值，离合器安全功能)Group 068Go! (进入68区)Activate the Basic Setting. (进行基本操作)ON/OFF/NextReset Values (Pressure Adaptation) (重新设置数值，压力适应)Group 065Go! (进入65区)Activate the Basic Setting. (进行基本操作)ON/OFF/NextReset Values (Steering Wheel Paddle Installation) (重新设置数值，转向适应)Group 063Go! (进入63区)Activate the Basic Setting. (进行基本操作)ON/OFF/NextReset Values (ESP & Tip Cruise Control Installation) (重新设置数值，ESP和巡航适应)Group 069Go! (进入69区)Activate the Basic Setting. (进行基本操作)ON/OFF/NextDone, Go BackSwitch off Ignition, wait 10 Seconds and switch it back on. (关闭点火开关，等候10秒，再打开点火开关)Fault Codes - 02 (进入02读故障码)Check and clear fault codes after successful test.Close Controller, Go Back - 06Perform the Defined Test Drive