主机自动化专用术语_第1页
主机自动化专用术语_第2页
主机自动化专用术语_第3页
主机自动化专用术语_第4页
主机自动化专用术语_第5页
已阅读5页,还剩1页未读 继续免费阅读

下载本文档

版权说明:本文档由用户提供并上传,收益归属内容提供方,若内容存在侵权,请进行举报或认领

文档简介

1、主机自动化专用术语1、主机 Main Engine (M.E.)2、主机遥控 M.E. remote control3、螺旋桨 propeller4、可调螺旋桨 CPP (Controllable pitch propeller)5、齿轮箱 gearbox6、轴承 bearing7、推力(中间)轴承 thrust (intermediate) bearing8、凸轮轴 camshaft9、活塞 piston10、主起动阀 main starting valve11、调速器 governor12、气缸 cylinder13、高压油泵 high-pressure oil pump14、调油杆 oi

2、l-adjusting lever15、油排齿条格数tooth sector16、起动(停止)电磁阀 starting (stopping) electric-magnetic valve17、盘车机 turning gear18、扫气空气 scanvage air19、泵(马达)pump(motor)20、鼓风机blower21、转速rpm22、流量 flow23、手动 manual24、自动 automatic25、应急 emergency26、限制 limit27、指示 indicate28、故障 abnormal/trouble29、工况(负荷)working condition (l

3、oad)30、确认(应答)confirm (response)31、平稳 steady (smooth)32、调节 adjust33、复位 reset34、自检self-check35、备用stand-by36、啮合gear37、脱开detach38、减速slow-down39、失败failure40、零位nil position41、反馈信号feed signal42、转换信号change-over signal44、换向信号reverse signal45、接通connect46、断开cut-off47、切断cut48、正常normal49、无异常现象no abnormal50、闭锁loc

4、k51、试验test & trial52、电源power supply (source)53、交流电源AC 220V SOURCE54、直流电源DC 24V SOURCE1、主机推进系统M/E propulsion system2、主机遥控装置M/E remote control unit3、机旁local (by engine side)4、集控室ECR (centralized control room)5、驾驶室W/H (wheel-house)5、桥楼bridge6、遥控主车钟remote control main telegraph7、微速dead slow8、半速half8

5、、全速full9、完车finish10、辅车钟 aux. telegraph11、应急车钟emergency telegraph12、车钟记录仪telegraph recorder13、设定速度rated speed14、定速constant speed15、模拟试验simulation test16、测速装置speed-measuring unit17、转速传感器rpm sensor18、起动空气压力表starting air pressure gaugeI、 程序 (换向/起动 /慢转起动/转速 /转速自动)控制 program (change-over / starting/ slow

6、starting / rpm / rpm automatic) control2、三次自动重复起动automatic restarting for three times3、重起动restart4、错向报警wrong-way alarm5、临界转速(最小转速/最大倒车转速/ 热负荷/手动转速/ 燃油 / 扫气压力 /手动燃油)限制critical rpm (Min. rpm / Max. astern rpm / hot load / manual rpm / F.O. / scanvagepressure /manual F.O.) limit6、应急操纵(运行)emergency mane

7、uvering (running)7、应急(自动)停车emergency( automatic) stop8、安全保护装置safety protection unit9、盘车机未脱开Turning gear is still geared10、滑油压力低The pressure of L.O. is too low.II、 气缸 (活塞) 冷却水压力低The pressure of cooling water for cylinder (piston) istoo low.12、超速 overspeed13、活塞冷却水流量低The flow cooling water for piston i

8、s too low.14、 扫气空气 (推力轴承) 温度高 The temperature of scanvage air (thrust bearing) is too high.15、起动时间过长The starting time is too long.16、三次起动失败starting failure for a third time17、起动(控制)空气压力低The pressure of starting( control) air is too low.18、主起动阀未打开The main starting valve isn t opened.19、机旁操纵(调油)手柄位置Th

9、e local handle position for maneuvering.20、系统故障system failure21、内部电源故障 inside power source failure22、故障显示failure display23、气缸油断流cylinder oil non-flow24、越空 skip25、油雾探油装置oil mist detector26、鼓风机接通(断开) The blower is powered (out down).27、调速器governor28、报警器消音按钮The silencer push button for alarm unit.29、试灯

10、按钮push button for lighting30、凸轮轴位置检测器detector for camshaft position31、电气转换I/P32、故障指示灯failure indicator33、调光器旋钮snob for light regulator34、执行机构actuator35、燃油刻度指示表fuel oil dial indicator电站自动化 Automation of power Station I .1、柴油发电机起动失败D/G start failure.2、柴油发电机超速停车D/G overspeed stop.3、柴油发电机滑油低压停车D/G Lub.

11、oil low press. stop.4、柴油发电机淡水高温停车D/G F.W. high temp. stop.5、柴油发电机起动空气低压D/G starting air low press.6、柴油发电机停车电磁阀故障D/G auto-stop magnetic valve failure.7、柴油发电机测速装置故障D/G speed measurement failure.8、柴油发电机空气低压D/G control air low press.9、柴油发电机电源故障D/G power source failure.10、柴油发电机增压器滑油低压D/G turbocharger Lub

12、. Oil low press.11、柴油发电机燃油泄漏柜液位高D/G F.O. drain tank high level12、柴油发电机预滑油故障 D/G L.O. preheatment failure.13、柴油发电机报警闭锁D/G alarm lock.14、柴油发电机功率管理故障D/G power control failure.15、柴油发电机公共报警D/G common alarm.16、柴油发电机燃油模块故障D/G F.O. module failure.17、柴油发电机测速传感器D/G speed sensor.18、柴油发电机预供油泵马达D/G presupply oil

13、 pump motor.19、主配电板调速马达Main switchboard speed-governing motor.20、遥控和自动起动(控制) Remote control and auto start (control)21、就地控制 local control22、遥控(手动)停车stop by remote (hand) control23、发电机运行D/G operation24、发电机温度及压力显示Temperature & pressure display of D/G25、发电机燃油进口压力 D/G F.O. inlet press.26、 发电机高温淡水 (滑

14、油) 进口压力 D/G high-temp. F.W. (Lub.Oil.) intlet press.27、发电机燃油(滑油)进口温度D/G F.O. (L.O.) inlet temp.28、发电机高温淡水出口温度D/G high-temp. F.W. outlet temp.29、发电机 1 3 缸排气温度Exhaust temp. from the first to the third cylinder.30、发电机 R 相( S 相、 TS 相)绕组温度D/G R (S、 TS)-phase coil temp.31、主空气断路器main air breaker32、 电压表 (电流

15、表、 功率表、 同步表、 功率因素表、 频率表) Voltmeter (Ammeter/ powermeter / synchronoscope / power factor meter / frequency meter)33、转换开关change-over switch34、发电机加热器开关D/G heater switch35、调频转换开关frequency-regulating switch36、充磁(消音 /复位)按钮magnetic push button (silencer / reset)37、岸电供电(同步)指示灯shore electricity-supply (synch

16、ronous) indicator38、绝缘监视仪insulation monitor39、熔断器 fuseH .(主机主要部件)Main Parts for M/E1、 engine frame 机架2、 cylinder 气缸3、 piston 活塞4、crosshead 十字头5、 bedplate 机座6、 crankshaft 曲轴7、 cylinder cover/head 气缸盖8、 connecting rod 连杆9、 turbocharger 增压器10、 driving chain 传动链11、 air cooler 空气冷却器12、 scanvage box 扫气箱13

17、、 oil sprayer 喷油器14、 oil nozzle 喷油嘴15、 exhaust valve 排气阀16、 sealing ring 密封环17、 cylinder liner 气缸套18、 piston rod 活塞杆m .机舱布置图 Engine room arrangement1、 main engine /M.E.主机2、 intermediate shaft中间轴3、 bearing轴承4、 propeller shaft螺旋桨轴5、stern tube艇管6、aft seal head tank后密封油箱7、FWD seal head tank前密封油箱8、stern tube L.O. drain tank 艇管滑油泄放柜9、 chemical cleaning tank 化学清洗柜10、 L.O. drain tank11、 sludge oil trap 油渣收集柜12、 rust preventer tank 防锈剂柜13、 oily water separator油水分离器14、 Low sea chest 低位海水门15、 L.O. transfer pump16、 bilge pump 舱底泵17、 M/E lub oil pump18、 M/E S.W. cooling pump 主机海水泵19、 sludge pump 油渣泵20、 ej

温馨提示

  • 1. 本站所有资源如无特殊说明,都需要本地电脑安装OFFICE2007和PDF阅读器。图纸软件为CAD,CAXA,PROE,UG,SolidWorks等.压缩文件请下载最新的WinRAR软件解压。
  • 2. 本站的文档不包含任何第三方提供的附件图纸等,如果需要附件,请联系上传者。文件的所有权益归上传用户所有。
  • 3. 本站RAR压缩包中若带图纸,网页内容里面会有图纸预览,若没有图纸预览就没有图纸。
  • 4. 未经权益所有人同意不得将文件中的内容挪作商业或盈利用途。
  • 5. 人人文库网仅提供信息存储空间,仅对用户上传内容的表现方式做保护处理,对用户上传分享的文档内容本身不做任何修改或编辑,并不能对任何下载内容负责。
  • 6. 下载文件中如有侵权或不适当内容,请与我们联系,我们立即纠正。
  • 7. 本站不保证下载资源的准确性、安全性和完整性, 同时也不承担用户因使用这些下载资源对自己和他人造成任何形式的伤害或损失。

评论

0/150

提交评论